Home > IBM > Notebook > IBM Thinkpad Transnote Manual

IBM Thinkpad Transnote Manual

Here you can view all the pages of manual IBM Thinkpad Transnote Manual. The IBM manuals for Notebook are available online for free. You can easily download all the documents as PDF.

Page 61

Removing and replacing a FRU
ThinkPad TransNote57 

Page 62

1020 DIMM
(continued) vBattery pack(1010)
Removing and replacing a FRU
58ThinkPad TransNote 

Page 63

Note:Loosen the screw3, but do not remove it.
(continued)
Removing and replacing a FRU
ThinkPad TransNote59 

Page 64

Removing and replacing a FRU
60ThinkPad TransNote 

Page 65

DIMM installation notice:
With the notched end of the DIMM toward the socket,
insert the DIMM at an angle of about 25 degrees, into the
socket1; then press it firmly. Pivot the DIMM until it
snaps into place2. Make sure that the card is firmly
fixed in the slot and does not move easily.
DIMM cover installation notice:
Attach the latch of the cover firmly by pressing the part
shown in the following figure, and then tighten the screw.
Removing and replacing a FRU
ThinkPad TransNote61 

Page 66

1030 Mini PCI adapter
Note:Loosen the screw1, but do not remove it.
(continued) vBattery pack(1010)
Removing and replacing a FRU
62ThinkPad TransNote 

Page 67

Removing and replacing a FRU
ThinkPad TransNote63 

Page 68

Note:The illustration shows the combo card. Connector
(A)is for the LAN feature and(B)is for the modem
feature. This slot also supports a Mini PCI modem
card or a Mini PCI network card. Step7depends
on the card type. Disconnect either(A),(B)or both.
Removing and replacing a FRU
64ThinkPad TransNote 

Page 69

When installing:
Align the contact edge of the combo card or Mini-PCI Card
with the corresponding socket contact of the computer at
an angle of 25 degrees. Insert the card into the socket1.
Pivot the card until it snaps into place2. Make sure that
the card is firmly fixed in the slot and does not move
easily.
(continued)
Removing and replacing a FRU
ThinkPad TransNote65 

Page 70

Note:Be sure that connectors and cables are properly
housed in the slot as shown in the following figure.
Otherwise, the card cannot be seated firmly in it.
After installing the Mini-PCI Card, attach the black sheet to
the card. If the sheet does not stick to the slot on the video
card, just leave it and install the Mini-PCI slot cover not to
pinch the cable or the black sheet.
Removing and replacing a FRU
66ThinkPad TransNote 
Start reading IBM Thinkpad Transnote Manual

Related Manuals for IBM Thinkpad Transnote Manual

All IBM manuals