IBM Thinkpad Transnote Manual

Identifying problems with the FlipTouch
display
To analyze a problem with the FlipTouch display, do the
following:
1. Make sure that the FlipTouch display is enabled:
vIBM BIOS Setup Utility -->Config-->FlipTouch
Display
2. Insert the PC-Doctor DOS disk in the diskette drive,
and turn on the system unit. For details on using
PC-Doctor, see“Testing the computer”on page 26.
3. RunDiagnosticsand selectFlipTouch display.Ifthe
test fails, one or both of the following are defective:
vLCD panel 10.4-in. TFT...

vThe ThinkScribe digital notepad assembly
(02K5881) is defective.
3. RunDiagnosticsand selectThinkScribe. If the device
fails any of the tests, the ThinkScribe digital notepad
assembly (02K5881) is defective.
4. RunInteractive Tests, and selectThinkScribe LCD
Test. If the device fails any of the tests, the
ThinkScribe digital notepad assembly (02K5881) is
defective.
5. RunInteractive Testsand selectThinkScribe LED
Test. If the device fails any of the tests, the
ThinkScribe digital notepad assembly...

Undetermined problems
You are here because the diagnostic tests did not identify
which adapter or device failed, incorrect devices are
installed, a short circuit is suspected, or the system is
inoperative. Follow these procedures to isolate the failing
FRU.
Note:Do not replace any FRU if the procedures do not
identify it as defective.
Verify that all attached devices are supported by the
computer.
Check the power system; see“Power system checkout”on
page 28.
1. Power off the computer.
2. Visually check...

FRU replacement notices
This section contains notices related to removing and
replacing parts. Read this section carefully before replacing
any FRU.
Screw notices
Loose screws can cause a reliability problem. An IBM
ThinkPad computer addresses this problem with special
nylon-coated screws that have the following characteristics:
vThey maintain tight connections.
vThey do not easily come loose, even with shock or
vibration.
vThey are harder to tighten.
vThey should be used only once.
Do the following when...

vMake sure you use the correct screw. If you have a
torque screwdriver, tighten all screws firmly to the torque
shown in the table.Never use a screw that you
removed. Use a new one. Make sure the screws are
tightened firmly.
Retaining serial numbers
This section includes the following descriptions:
v“Restoring the serial number of the system unit”
v“Retaining the UUID”
Restoring the serial number of the system
unit
When the computer was manufactured, the EEPROM on
the system board was loaded with the...

unique IDs until the year A.D. 3400. No two computers in
the world have the same number.
When you replace the system board, you must set the
UUID on the new system board as follows:
1. Install the ThinkPad hardware maintenance diskette
version 1.61, and restart the computer.
2. From the main menu, select4. Assign UUID.
A new UUID is created and written. If a valid UUID
already exists, it is not overwritten.
FRU replacement notices
52ThinkPad TransNote 

Removing and replacing a FRU
This section presents information and drawings for use in
removing and replacing a FRU. Be sure to observe the
following general rules:
1. Do not try to service the computer unless you have
been trained and certified. An untrained person runs
the risk of damaging parts.
2. Before replacing any FRU, review“FRU replacement
notices”on page 50.
3. Begin by removing any FRUs that have to be removed
before the failing FRU. Any such FRUs are listed at the
top of the page. Remove...

Removing the ThinkPad TransNote
Note:There are two models of the ThinkPad TransNote,
one is for a right-handed person and the other or a
left-handed person. This manual depicts the
right-handed model, but all remove and replace
processes remain the same, except the one for the
pen holder kit (Section 1070). Section 4010 depicts
the process for changing the orientation of a
right-handed model to a left-handed model by
replacing the Endurimer or leather cover.
The following illustration shows a...

Note for FlexFold hinge
The external portion of the ThinkPad TransNote cover is
made of a Endurimer material. This material can be folded
in such a way to allow use of the computer or digital
notepad without placing either one face down on a surface.
See the following examples.
Removing and replacing a FRU
ThinkPad TransNote55 

1010 Battery pack
CAUTION:
If the rechargeable battery pack is incorrectly replaced,
there is danger of an explosion. The battery pack
contains a small amount of harmful substances. To
avoid possible injury: (1) replace only with a battery of
the type recommended by IBM, or an equivalent, (2)
keep the battery pack away from fire, (3) do not
expose it to water or rain, (4) do not attempt to
disassemble it, (5) do not short-circuit it. Do not put
the battery pack in trash that is disposed of in
landfills....