IBM Thinkpad Transnote Manual

1040 Hard-disk drive and hard-disk
drive cover
AttentionDo not drop or apply any shock to the hard-disk
drive.The hard-disk drive is sensitive to physical
shock. Incorrect handling can cause damage and
permanent loss of data.
Before removing the drive, have the user make a
backup copy of all the information on the drive if
possible.
Never remove the drive while the system is
operating or is in suspend mode.
Note:Loosen the screw
2, but do not remove it.
(continued) vBattery pack(1010)
Removing and...

Note:The hard disk is attached to the cover, but the cover
is a separate FRU.
When installing:Make sure that the label on the
hard-disk drive faces the bottom side of
the computer and that the hard-disk
connector is firmly connected.
Removing and replacing a FRU
68ThinkPad TransNote 

1050 Keyboard
Note:Loosen the screw
2, but do not remove it.
(continued) vBattery pack(1010)
vDIMM(1020)
vHard-disk drive and hard-disk drive cover(1040)
Removing and replacing a FRU
ThinkPad TransNote69 

(continued)
Removing and replacing a FRU
70ThinkPad TransNote 

When installing:Make sure that the keyboard connector
is firmly attached.
Removing and replacing a FRU
ThinkPad TransNote71 

When installing:When installing the keyboard, do as
follows:
1. Make sure that the front edges of the keyboard are
under the frame as shown in the following figure.
2. Push theEkey andDkeys andOkey andLkeys
1
to latch the keyboard to the frame; then connect the
keyboard connector
2.
Removing and replacing a FRU
72ThinkPad TransNote 

1060 Backup battery and sub-battery
CAUTION:
There is a danger of an explosion if the backup battery
is incorrectly replaced. The lithium battery (IBM P/N
02K6572 UL-recognized component [file no. MH12210])
contains lithium and can explode if it is not properly
handled or disposed of. Replace only with a battery of
the same type. To avoid possible injury or death, do
not (1) throw or immerse the battery into water, (2)
allow it to heat to more than 100°C (212°F), or (3)
attempt to repair or disassemble...

When installing:Make sure that the connector is firmly
attached.
Removing and replacing a FRU
74ThinkPad TransNote 

1070 Digital-pen holder kit
For a right-handed model
Step Screw (quantity) Screw cap Torque

1M2.5×3 mm,
nylon-coated (2)
39.2 Ncm
(4 kgfcm)

3M2.5×3 mm,
nylon-coated (1)39.2 Ncm
(4 kgfcm)
When installing:
When installing part
Ain the preceding figure, fit the
screw-hole plate and the claw into the square holes on the
bottom side of
A(
a) and then slide
Ain the direction
of the arrow
b. Then tighten the screw.
(continued) vBattery pack(1010)
Removing and replacing a FRU
ThinkPad TransNote75 

Step Screw (quantity) Screw cap Torque

5M2.5×3 mm,
nylon-coated (1)
39.2 Ncm
(4 kgfcm)

6M2.5×3 mm,
nylon-coated (1)
39.2 Ncm
(4 kgfcm) Removing and replacing a FRU
76ThinkPad TransNote