IBM Thinkpad R32 Manual

							2
Note:Thermal Pad must be replaced when either Heat
Sink Module, CPU or System Board is replaced.
Thermal Pad is stuck on the bottom side of Heat
Sink Module with adhesive. Do not re-use the
thermal pad.
1240 Speaker Disassembly
v“1010 Battery Disassembly”on page 123
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 124
v“1040 Hard Disk Drive Disassembly”on page 126
v“1070 Keyboard Disassembly”on page 128
v“1100 Middle Cover Disassembly”on page 131
v“1170 LCD Disassembly”on page 137
v“1180 Keyboard bezel Disassembly”on page 138
2
1
MT 2658/2659/2677145 
						

							Step Size (Quantity) Color Torque
2 M2.5 x L5(1) Silver 2.5 kgf-cm
1250 System Board Disassembly
v“1010 Battery Disassembly”on page 123
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 124
v“1040 Hard Disk Drive Disassembly”on page 126
v“1060 CD-ROM Disassembly”on page 127
v“1070 Keyboard Disassembly”on page 128
v“1100 Middle Cover Disassembly”on page 131
v“1110 CDC Cover Disassembly”on page 132
v“1170 LCD Disassembly”on page 137
v“1180 Keyboard bezel Disassembly”on page 138
v“1240 Speaker Disassembly”on page 145
1
Step Size (Quantity) Color Torque
1 M2.5 x L5(2) Silver 2.5 kgf-cm
146ThinkPad R32 Series 
						

							23
Notes:
1. When removing the system board from the bottom
cover, gently raise the side of the system board facing
the rear I/O ports; then pull out the system board.
2. In step 2, further pull out this latch before the system
board is attached to the lower case.
3. Thermal Pad must be replaced when either Heat Sink
Module, CPU or System Board is replaced. Thermal
Pad is stuck on the bottom side of Heat Sink Module
with adhesive. Do not re-use the thermal pad.
1260 I/O Port Bracket Disassembly
v“1010 Battery Disassembly”on page 123
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 124
v“1040 Hard Disk Drive Disassembly”on page 126
v“1060 CD-ROM Disassembly”on page 127
v“1070 Keyboard Disassembly”on page 128
v“1100 Middle Cover Disassembly”on page 131
v“1110 CDC Cover Disassembly”on page 132
v“1170 LCD Disassembly”on page 137
v“1180 Keyboard bezel Disassembly”on page 138
v“1240 Speaker Disassembly”on page 145
v“1250 System Board Disassembly”on page 146
MT 2658/2659/2677
147 
						

							1
2
Step Size (Quantity) Color Torque
1 M2.5 x L6 Silver 3.2 kgf-cm
2 M2 x L12 Silver 1.6 kgf-cm
3
45
6
78
148ThinkPad R32 Series 
						

							Step Size (Quantity) Color Torque
4 Hex Screw(4) Silver 2.5 kgf-cm
Note:When attaching the I/O port bracket to the system
board, please pay special attention to the studs’
positions as marked 5, 6, 7, 8. The one marked 5
should be installed above the one marked 6; the
one marked number 7 should be aligned with and
attached beneath the one marked number 8.
CAUTION:
There are several types of system board FRU for the
Thinkpad R32 series, as followed:
vSystem board with IBM security chip
a
vSystem board without IBM security chip
a
Begin by checking the FRU number of the system
board, and be sure to use the correct system board
FRU for the computer. For the FRU numbers,
see“Parts list”on page 161
MT 2658/2659/2677
149 
						

							ImportantIf the ThinkPad computer you are servicing has the
security chip, mind the following:
vDo not remove the security chip from the
system board.If the security chip is removed by
accident, reintall it on the system board
immediately. Then make sure that it is firmly fixed
on the system board and does not remove easily.
vThe security chipcannotbe used with any other
system board.
vThe system boardcannotbe used with any other
security chip.
vThe system boardcannotbe used without
security chip
vWhen you return the defective system board
FRU, you must check whether the security chip is
firmly attached to the system board. If it is not
embedded, it may not be covered under warranty.
1270 LCD Bezel Disassembly (14.1″)
v“1010 Battery Disassembly”on page 123
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 124
v“1070 Keyboard Disassembly”on page 128
v“1100 Middle Cover Disassembly”on page 131
v“1170 LCD Disassembly”on page 137
1
150ThinkPad R32 Series 
						

							2
Step Size (Quantity) Color Torque
2 M2.5 x L6(2) Black 2.5 kgf-cm
3
3
4
5
6
7
Note:When removing the LCD, take note of the following:
vBe careful not to scratch the LCD bezel when
removing the screw mylars.
vThe LCD bezel has several latches. Release
these latches; then remove the LCD bezel. Be
careful not to break these latches.
vGently push the two LCD latches outward to
remove the LCD bezel.
1280 LCD Inveter Disassembly(14.1″)
v“1010 Battery Disassembly”on page 123
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 124
v“1070 Keyboard Disassembly”on page 128
MT 2658/2659/2677
151 
						

							v“1100 Middle Cover Disassembly”on page 131
v“1170 LCD Disassembly”on page 137
v“1270 LCD Bezel Disassembly (14.1″)”on page 150
23
1a
1b
Step Size (Quantity) Color Torque
1 M2 x L10(2) Black 2.5 kgf-cm
1290 LCD Board Disassembly(14.1″)
v“1010 Battery Disassembly”on page 123
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 124
v“1070 Keyboard Disassembly”on page 128
v“1100 Middle Cover Disassembly”on page 131
v“1170 LCD Disassembly”on page 137
v“1270 LCD Bezel Disassembly (14.1″)”on page 150
v“1280 LCD Inveter Disassembly(14.1″)”on page 151
1
152ThinkPad R32 Series 
						

							2
Step Size (Quantity) Color Torque
2 M2 x L4(2) Silver 2.5 kgf-cm
3a
3b
4
Step Size (Quantity) Color Torque
3 M2.5 x L6(2) Black 2.5 kgf-cm
MT 2658/2659/2677153 
						

							Note:Before step 4 of removing the LED board, please
make sure the main antenna cable is lifted gently.
5
6
1300 LCD Bracket Hinges Disassembly
(14.1″)
v“1010 Battery Disassembly”on page 123
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 124
v“1070 Keyboard Disassembly”on page 128
154ThinkPad R32 Series