IBM Thinkpad R32 Manual

							2
Note:Thermal Pad must be replaced when either Heat
Sink Module, CPU or System Board is replaced.
Thermal Pad is stuck on the bottom side of Heat
Sink Module with adhesive. Do not re-use the
thermal pad.
1240 Speaker Disassembly
v“1010 Battery Disassembly”on page 63
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 64
v“1040 Hard Disk Drive Disassembly”on page 66
v“1070 Keyboard Disassembly”on page 68
v“1100 Middle Cover Disassembly”on page 71
v“1170 LCD Disassembly”on page 77
v“1180 Keyboard bezel Disassembly”on page 78
2
1
MT 2658/2659/267785 
						

							Step Size (Quantity) Color Torque
2 M2.5 x L5(1) Silver 2.5 kgf-cm
1250 System Board Disassembly
v“1010 Battery Disassembly”on page 63
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 64
v“1040 Hard Disk Drive Disassembly”on page 66
v“1060 CD-ROM Disassembly”on page 67
v“1070 Keyboard Disassembly”on page 68
v“1100 Middle Cover Disassembly”on page 71
v“1110 CDC Cover Disassembly”on page 72
v“1170 LCD Disassembly”on page 77
v“1180 Keyboard bezel Disassembly”on page 78
v“1240 Speaker Disassembly”on page 85
1
Step Size (Quantity) Color Torque
1 M2.5 x L5(2) Silver 2.5 kgf-cm
86ThinkPad R32 Series 
						

							23
Notes:
1. When removing the system board from the bottom
cover, gently raise the side of the system board facing
the rear I/O ports; then pull out the system board.
2. In step 2, further pull out this latch before the system
board is attached to the lower case.
3. Thermal Pad must be replaced when either Heat Sink
Module, CPU or System Board is replaced. Thermal
Pad is stuck on the bottom side of Heat Sink Module
with adhesive. Do not re-use the thermal pad.
1260 I/O Port Bracket Disassembly
v“1010 Battery Disassembly”on page 63
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 64
v“1040 Hard Disk Drive Disassembly”on page 66
v“1060 CD-ROM Disassembly”on page 67
v“1070 Keyboard Disassembly”on page 68
v“1100 Middle Cover Disassembly”on page 71
v“1110 CDC Cover Disassembly”on page 72
v“1170 LCD Disassembly”on page 77
v“1180 Keyboard bezel Disassembly”on page 78
v“1240 Speaker Disassembly”on page 85
v“1250 System Board Disassembly”on page 86
MT 2658/2659/2677
87 
						

							1
2
Step Size (Quantity) Color Torque
1 M2.5 x L6 Silver 3.2 kgf-cm
2 M2 x L12 Silver 1.6 kgf-cm
3
45
6
78
88ThinkPad R32 Series 
						

							Step Size (Quantity) Color Torque
4 Hex Screw(4) Silver 2.5 kgf-cm
Note:When attaching the I/O port bracket to the system
board, please pay special attention to the studs’
positions as marked 5, 6, 7, 8. The one marked 5
should be installed above the one marked 6; the
one marked number 7 should be aligned with and
attached beneath the one marked number 8.
CAUTION:
There are several types of system board FRU for the
Thinkpad R32 series, as followed:
vSystem board with IBM security chip
a
vSystem board without IBM security chip
a
Begin by checking the FRU number of the system
board, and be sure to use the correct system board
FRU for the computer. For the FRU numbers,
see“Parts list”on page 161
MT 2658/2659/2677
89 
						

							ImportantIf the ThinkPad computer you are servicing has the
security chip, mind the following:
vDo not remove the security chip from the
system board.If the security chip is removed by
accident, reintall it on the system board
immediately. Then make sure that it is firmly fixed
on the system board and does not remove easily.
vThe security chipcannotbe used with any other
system board.
vThe system boardcannotbe used with any other
security chip.
vThe system boardcannotbe used without
security chip
vWhen you return the defective system board
FRU, you must check whether the security chip is
firmly attached to the system board. If it is not
embedded, it may not be covered under warranty.
1270 LCD Bezel Disassembly (14.1″)
v“1010 Battery Disassembly”on page 63
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 64
v“1070 Keyboard Disassembly”on page 68
v“1100 Middle Cover Disassembly”on page 71
v“1170 LCD Disassembly”on page 77
1
90ThinkPad R32 Series 
						

							2
Step Size (Quantity) Color Torque
2 M2.5 x L6(2) Black 2.5 kgf-cm
3
3
4
5
6
7
Note:When removing the LCD, take note of the following:
vBe careful not to scratch the LCD bezel when
removing the screw mylars.
vThe LCD bezel has several latches. Release
these latches; then remove the LCD bezel. Be
careful not to break these latches.
vGently push the two LCD latches outward to
remove the LCD bezel.
1280 LCD Inveter Disassembly(14.1″)
v“1010 Battery Disassembly”on page 63
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 64
MT 2658/2659/2677
91 
						

							v“1070 Keyboard Disassembly”on page 68
v“1100 Middle Cover Disassembly”on page 71
v“1170 LCD Disassembly”on page 77
v“1270 LCD Bezel Disassembly (14.1″)”on page 90
23
1a
1b
Step Size (Quantity) Color Torque
1 M2 x L10(2) Black 2.5 kgf-cm
1290 LCD Board Disassembly(14.1″)
v“1010 Battery Disassembly”on page 63
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 64
v“1070 Keyboard Disassembly”on page 68
v“1100 Middle Cover Disassembly”on page 71
v“1170 LCD Disassembly”on page 77
v“1270 LCD Bezel Disassembly (14.1″)”on page 90
v“1280 LCD Inveter Disassembly(14.1″)”on page 91
1
92ThinkPad R32 Series 
						

							2
Step Size (Quantity) Color Torque
2 M2 x L4(2) Silver 2.5 kgf-cm
3a
3b
4
Step Size (Quantity) Color Torque
3 M2.5 x L6(2) Black 2.5 kgf-cm
MT 2658/2659/267793 
						

							Note:Before step 4 of removing the LED board, please
make sure the main antenna cable is lifted gently.
5
6
1300 LCD Bracket Hinges Disassembly
(14.1″)
v“1010 Battery Disassembly”on page 63
v“1020 Mini-PCI cover and Mini-PCI card Disassembly”
on page 64
v“1070 Keyboard Disassembly”on page 68
v“1100 Middle Cover Disassembly”on page 71
94ThinkPad R32 Series