IBM Thinkpad I Series 12001300 Manual

							WarningBattery packs are capable of delivering high
currents for a significant amount of time. Do not
short the battery terminals.
CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used
batteries according to the manufacturer’s instructions.
1030 Memory cover and memory card
v“1020 Battery assembly”on page 50
1
2
Note:The screw does not separate from the memory
cover.
To install the memory card:
With the notched end of the memory card toward the right
side of the socket, insert the memory card, at an angle of
approximately 20°, into the socket; then press it firmly.
ThinkPad i Series 1200/1300
51 
						

							Pivot the memory card until it snaps into place.
Side View
1040 Hard disk drive assembly
v“1020 Battery assembly”on page 50
1
52ThinkPad i Series 1200/1300 HMM 
						

							2
Note:To remove the hard disk drive cover, let the top
cover of the computer a little open. Then you can
remove it more easily.
3
ThinkPad i Series 1200/130053 
						

							WarningDo not drop or apply any shock to the hard disk
drive. The hard disk drive is sensitive to physical
shock. Incorrect handling can cause damage and
permanent loss of data on the drive.
Before removing the drive, have the user make a
backup copy of all the information on the drive if
possible.
Never remove the drive while the system is
operating or is in suspend mode.
1050 Hard disk drive kitting pack
v“1020 Battery assembly”on page 50
v“1040 Hard disk drive assembly”on page 52
1
2
Step Size (Quantity) Color Torque
1 M3 x 4L (1) Silver 3.2 kgf-cm
1060 CD-ROM assembly
v“1020 Battery assembly”on page 50
54ThinkPad i Series 1200/1300 HMM 
						

							1
2
Step Size (Quantity) Color Torque
1 M2.5 x 8L (1) Black 3.2 kgf-cm
3
Note:Some CD-ROM/CD-RW FRU (Delta CD-ROM and
KME CD-RW) has Pickup Lens Fixture sheet in
drive. After the drive is attached to the system,
remove this sheet. Do no put back this sheet in the
drive again.
ThinkPad i Series 1200/130055 
						

							1070 EZ key cover
v“1020 Battery assembly”on page 50
1
2
1080 Keyboard
v“1020 Battery assembly”on page 50
v“1070 EZ key cover”
1
Step Size (Quantity) Color Torque
1 M2.5 x 8L (2) Black 3.2 kgf-cm
56ThinkPad i Series 1200/1300 HMM 
						

							2
54
3
Note:Make sure the FPC finger side is facing correct,
when inserted.
Notes:
1. When replacing the keyboard, make sure that the 2
cables are clean and insert them directly into the
connectors, making sure they make contact with the
bottom of the connector. Now press down on the latch
of the connector to secure.
2. If the cables do not touch the bottom of the connector,
the keyboard function will be rendered useless.
3. The cables of the keyboard are fragile and could be
damaged. Be careful when pulling out the cables.
1090 Backup battery
v“1020 Battery assembly”on page 50
v“1070 EZ key cover”on page 56
v“1080 Keyboard”on page 56
ThinkPad i Series 1200/1300
57 
						

							1
2
CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same type. Dispose of used
batteries according to manufacturer’s instruction.
Safety Notice 4Translation in″Safety Notices: Multi-lingual
Translations″section: The backup battery is a
lithium battery and can cause a fire, an explosion, or
severe burns. Do not recharge it, remove its
polarized connector, disassemble it, heat it above
100°C (212°F), incinerate it, or expose its cell
contents to water. Dispose of the battery as required
by local ordinances or regulations. Use of an
incorrect battery can result in ignition or explosion of
the battery. Replacement batteries can be ordered
from IBM or IBM Authorized Dealers.
1100 PCMCIA holder
v“1020 Battery assembly”on page 50
v“1070 EZ key cover”on page 56
v“1080 Keyboard”on page 56
58ThinkPad i Series 1200/1300 HMM 
						

							1
2
Step Size (Quantity) Color Torque
2 M2 x 6L (3) Silver with
Binding head1.6 kgf-cm
4
3
ThinkPad i Series 1200/130059 
						

							Note:Before removing and replacing the PCMCIA holder,
make sure that the PCMCIA cards are removed and
the eject levers are sticking out.
1110 Modem and Ethernet card cover
v“1020 Battery assembly”on page 50
v“1070 EZ key cover”on page 56
v“1080 Keyboard”on page 56
12
Step Size (Quantity) Color Torque
1 M2.5 x 5L (2) Blue 3.2 kgf-cm
1120 Modem card
v“1020 Battery assembly”on page 50
v“1070 EZ key cover”on page 56
v“1080 Keyboard”on page 56
v“1110 Modem and Ethernet card cover”
60ThinkPad i Series 1200/1300 HMM