HP LaserJet P1006 User Manual

3.Release the small, white tabs on each side of the pickup roller, and rotate the pickup roller toward 
the front.
4. Gently pull the pickup roller up and out.
5.Position the new pickup roller in the slot. The circular and rectangular slots on each side prevents 
you from installing the roller incorrectly.
6. Rotate the top of the new pickup roller away from you until both sides snap into place.
ENWWChange the pickup roller 51
 

7.Insert the print cartridge in the device and close the print-cartridge door.
52 Chapter 6   Managing and maintenance ENWW
 

Clean the pickup roller
If you want to clean the pickup roller before deciding to replace it, follow these instructions:
1.Unplug the power cord from the device and remove the pickup roller as described in steps 1 
through 5 of Change the pickup roller on page 50
2.Dab a lint-free cloth in isopropyl alcohol, and scrub the roller.
WARNING!Alcohol is flammable. Keep the alcohol and cloth away from an open flame. Before
you close the device and plug in the power cord, allow the alcohol to dry completely....

Change the printer separation pad
Normal use with good media causes wear. The use of poor media might require more frequent 
replacement of the separation pad. 
If the device regularly pulls multiple sheets of media at a time, you might need to change the separation 
pad.
NOTE: Before you change the separation pad, clean the pickup roller. See Clean the pickup roller
on page 53.
WARNING!Before changing the printer separation pad, turn the device off by unplugging the power 
cord, and wait for the device...

4.Remove the separation pad.
5.Insert the new separation pad, and screw it into place.
ENWW Change the printer separation pad 55
 

6.Plug the device into the wall outlet, and turn on the device.
56 Chapter 6   Managing and maintenance ENWW
 

EconoMode
With EconoMode, the device uses less toner per page. Selecting this option can extend the life of the
print cartridge and reduce your cost per page. However, it also reduces print quality. The printed image
is lighter, but it is adequate for printing drafts or proofs.
HP does not recommend the full-time use of EconoMode. If EconoMode is used full-time, the toner
supply might outlast the mechanical parts in the print cartridge. If print quality begins to degrade under
these circumstances, you...

58 Chapter 6   Managing and maintenance ENWW
 

7 Problem solving
●Problem-solving checklist
●
Status-light patterns
●
Clearing jams
●
Improve print quality
●
Media problem-solving
●
Printed page is different from what appeared on screen
●
Printer software problems
●
Common Macintosh problems
●
Network-setup problem-solving
ENWW59
 

Problem-solving checklist
Step 1: Is the device set up correctly?
● Is the device plugged into a power outlet that is known to work? 
● Is the on/off switch in the on position? 
● Is the print cartridge properly installed? See Replace the print cartridge on page 40 . 
● Is paper properly loaded  in the input tray? See Load media on page 29.
YesIf you answered yes to the questions above, go to Step 2: Is
the Ready light on? on page 60
NoIf the device will not turn on, Contact HP support
on page 62.
Step...