Honeywell Galaxy 3 User Manual

Honeywell Security
Galaxy
3-48C, 3-144, 3-144C, 3-520, 3-520C
Programming Manual 

Galaxy 3 Series Programming Manual
i
Table of Contents
Contents
Section 1:  Quick Setup ............................................................................. 1
Section 2:  System Operation ................................................................... 3
Menu Options ......................................................................................................... 3...

Galaxy 3 Series Programming Manual
ii
Table of Contents
Straying from the Entry Route .................................................................................................................... 12
Abort Time ................................................................................................................................................. 12
Abort Setting Message...

Galaxy 3 Series Programming Manual
iii
Table of Contents
Section 8:  Engineer 1 .............................................................................. 51
Option 51 – Parameters ..................................................................................................... 5 1
Assigning Parameters to Groups .............................................................................................................. 51
Option 52 – Program Zones...

Galaxy 3 Series Programming Manual
iv
Table of Contents
Section 10:  Engineer 3 .......................................................................... 176
Option 71 - SPI Key ........................................................................................................... 176
Fitting the SPI Key ................................................................................................................................... 176
Using the SPI Key...

Galaxy 3 Series Programming Manual
1
Quick Setup
l e n a P l o r t n o Cda p y e K
1 BB
1 AA
--
++
Section 1:  Quick Setup
To quickly set up a Galaxy 3 Series control panel for programming follow these simple steps:
1.Connect a 1k Ω (1%) resistor across each of the zones on the panel and any RIO’s (if connected).
2.Ensure that the tamper return loop — the terminal marked as 
AUX TAMP on the PCB — is a complete
loop.
NOTE: This is factory set as a completed loop with a 0 V return.
3.Connect one of the...

Galaxy 3 Series Programming Manual
2 

Galaxy 3 Series Programming Manual
3
Section 2:  System Operation
Menu Options
General
The Galaxy 3 Series provides various menu options for modifying the functional performance of the system.
There are two menu structures:
1. Full Menu — only accessed by authorized users including the master manager code and by the
engineer.
2. Quick Menu — a selection of options from the full menu. The quick menu is the default menu
access for all user codes (type 2.3 and above), except master manager and engineer.
The...

Galaxy 3 Series Programming Manual
4
There are two methods of selecting menu options:
1.Direct Access:
Code + ent + option number + ent.
2.Menu Driven Access:
Code + ent + A (to select menu level) + ent;
A key (to select menu option) + ent.
Direct Access
Entering a valid menu option number while in the menu immediately moves to that option. For example, press-
ing 52 (type 3.7 only) when the keypad is displaying 22 = DISPLAY LOG moves directly to option
52 = PROGRAM ZONES; Pressing 10 while accessing the...