Honda Civic 5 Owners Manual

Air flows from the centre
and corner vents in the dashboard.
Airf low is divided between
the vents in the dashboard and the
f loor vents. You can also use the MODE button
on the side panel to select the vents.
Each time you press the MODE
button, the selected mode is
highlighted on the display.
Air f lows f rom the f loor and
corner vents.
Airf low is divided between
the floor and corner vents, and the
demister vents at the base of the
windscreen.This button turns the rear window
demister of f and on...

ÛÝ The temperatures of the driver’s side
and the passenger’s side can be
controlled independently when the
indicator in the DUAL button is on.
To adjust the driver’s side, turn the
temperature control dial on the
climate control panel. To adjust the
passenger’s side, press either side
( or ) of the temperature control
button on the f ront passenger’s door
armrest.
Push AUTO or . The selected
temperatures appear in the display
(in the side display on vehicles with
navigation system). When the
indicator...

ÛÝ To set the driver’s side temperature
to a different value than the
passenger’s side, press the DUAL
button, then turn the temperature
controldialonthecontrolpanel.To
set the passenger’s side to a
different value than the driver’s side,
press either side ( or ) of the
temperature control button on the
f ront passenger’s door armrest. You
can adjust the passenger’s side
without pressing the DUAL button
first.When you set the temperature to its
lower limit or its upper limit, it will be
displayed as ‘‘...

Theclimatecontrolsystemhastwo
sensors: a sunlight sensor on top of
the dashboard, and a temperature
and humidity sensor next to the
steering column. Do not cover the
sensors or spill any liquid on them. Sunlight and T emperature
Sensors
Climat e Cont rol Syst em
Features219
SUNLIGHT SENSOR
TEMPERATURE SENSOR
09/01/28 18:01:32 32SMG631_224 

The audio system is standard
equipment on some models. Read
the appropriate pages as shown
below f or the operation of the audio
system installed in your vehicle.
On vehicles without navigation
system, see page to .
On vehicles with navigation system,
see page to .
In addition to the standard audio
controls, the audio system in your
vehicle can be operated using the
voice control system. See the
navigation system manual f or
complete details.221 262
263 311
On vehicles with navigation system
Voice...

Audio System (on vehicles without navigation system)
Features
Playing the Radio
221
SCAN BUTTON
PRESET BUTTONS
POWER/VOLUME KNOB AUTO SELECT BUTTON
TUNE KNOB
Left-hand drive model is shown.SEEK/SKIP BAR
09/01/28 18:01:46 32SMG631_226 

µ
µµ
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
power/volume knob or the AM/FM
button. Adjust the volume by turning
the power/volume knob.
The band and f requency that the
radio was last tuned to are displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
displayed if the station is
broadcasting in stereo. Stereo
reproduction in AM is not available.
On the AM band, AM noise
reduction turns on automatically.Use the TUNE...

µ µ
µ Select the desired band, AM, LW
or FM. FM1 and FM2 let you store
six f requencies each.If you are
travelling and can no longer receive
your preset stations, you can use the
auto select feature to find stations in
the local area.
Press the A. SEL button. You will see
A. SEL f lashing in the display, and
the system goes into scan mode f or
several seconds. The system stores
the f requencies of 6 FM stations in
the preset buttons.
You will see a ‘‘0’’ displayed af ter
pressing a preset button if...

With Radio Data System (RDS)
Audio System (on vehicles without navigation system)
Features224
POWER/VOLUME KNOBPRESET BUTTONS
TUNE KNOB TA/PTY BUTTON
Left-hand drive model is shown.
09/01/28 18:02:09 32SMG631_229 

µ
µ
µ µ Alternative f requency f unction on or
of f
Regional programme on or of f
Automatic traf f ic program on or of f
News programme on or of f Program service f unction on or of f
The RDS f unctions turns on
automatically when you turn the
system on. If the station you are
listening to is an RDS stations, the
f requency is displayed in the
information display and the station
name will be displayed in the audio
display. Then, the system will
automatically keep selecting the
f requency with the...