Hitachi Projector CP-WU13K User Manual

41 OSD Menu description
Main Select
When you want to project PIP image, use this function to 
specify the image source for the PIP image. This function is 
identical to Input Selection; for more information.
PIP Select
Use this function to select the source  for the sub window.  
You can choose from HDMI1, HDMI2, RGB D-15, YUV1 
RGBHV/YUV2 and SDI/HDSDI/3G.
PIP Position
You can choose to display 
the sub window  in 
%


	

%

	
picture according to your preference....

42OSD Menu description
LAMP
This chapter covers information on the projector lamp.
Mode
#
ECO 
  
When set to Eco mode, the wattage of the lamp will be at 360W. If the surrounding environment 



	






=


&
>

	



	


43 OSD Menu description
High Altitude Mode
Use this function to control the projector's cooling fan. You can set it to Off or On. The default setting 
is Off. 
 
Under normal circumstances, the projector will operate normally with this function set to Off.  By 
default, the projector will detect the temperature of the surrounding environment to regulate the speed 
of the cooling fan. When the ambient temperature rises, fan speed will increase (generates louder 
noise) to make sure the heat inside the...

44OSD Menu description
ALIGNMENT
Rear Projection
The default setting is Off.
When you have set up the projector for rear projection, please set it to ON. For more information on 
different modes of projection, 
refer to  " Page 18 : Modes of installation ".
Ceiling Mode
The default setting is Off.
When you have set up the projector for ceiling mode (hung from the ceiling in reverse), please set 
it to ON. For more information on different modes of projection, 
refer to " Page 18 : Modes of...

45 OSD Menu description
Gamma
Different Gamma settings will affect viewers' perception of the image. Generally speaking, for images 
that are darker, it is recommended that Gamma be set higher to yield better image quality in darker 

&
	

	

&

		


	
>



&

	>

	
set the Gamma lower to give up details in the darker areas to make the brighter areas (i.e. clouds) 
more visible.

46OSD Menu description
Warp
The function provides distortion correction on projected images.
Horizontal Keystone 

 

47 OSD Menu description
Top Right Corner  







48OSD Menu description
Edge blend 
The function of Edge blend is applied in multiple projectors that are projecting at the same screen 
simultaneously to adjust the uniformity of the images on the screen.
#
Status 
 Press ENTER to select ON or OFF. The function must be set to ON in order to enable the   
function of Edge blend. If the function is set to OFF, the function of Edge blend is disabled.
#
White Level


%
















	


 
$...

49 OSD Menu description
#
Adjust Lines 
 
When the function is ON, there will be adjust lines on the image in order to easily adjust   


	


50OSD Menu description
CONTROL
IR Address
[








+