Hitachi Projector CP-WU13K User Manual

Projector
CP-WU13K
User Manual
Thank you for purchasing this product. Please 
read this manual before you operate your 
projector. Save it for future reference. 

2
Warning, Notices and Safety Instructions  4
Notice 4
Description pertaining to FCC Rules Part 15e:   4
About Waste Electrical and Electronic Equipment  5
Special Care for Laser Beams!  5
Sun light Warning   5
Never look into the projector light source directly  5
Do not turn off the projector by unplugging the power cord. 6
Electric shock  6
Do not overload wall outlets/extension cords  6
Cleaning 6
Dampness, smoke, steam, dust, high temperature and direct 
exposure to sunlight  6
Ventilation 7
Filter...

3
OSD Description  31
INPUT      31
Input Selection  31


	

 
Input Locking  32
Auto Power Off  32
Auto Power ON  32
No Signal  32
Auto Image Adjust  32
IMAGE 33
Contrast 33
Brightness 34
Sharpness 35
Noise Reduction  35
Color Temperature  36
Input Balance  36
Aspect Ratio  37
Timings 38
Auto Image  39
LAYOUT 40
Zoom 40
Main Select  41
PIP Select  41
PIP Position  41
PIP 41
LAMP 42
Mode 42
LAMPS 42
High Altitude  Mode  43
Power 43
Lamp1 Status  43
Lamp2 Status  43
Lamp1 Run Time  43...

4Warning, Notices and Safety Instructions
Warning, Notices and Safety Instructions
Notice
Please write down your projector model number and serial number and keep the information for 
maintenance purposes in the future. Should the equipment be lost or stolen, the information could also 
be used for the police report.
Model number:
Serial number:
	


	
	
















	
missing accessory, contact your dealer immediately.
1.  AC...

5 Warning, Notices and Safety Instructions
CAUTION: 
	

	



$
	%
&

		

%

+
	



operate the equipment.
This Class A digital apparatus meets all requirements of the Canadian ICES-003 Standards.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada. 
About Waste Electrical and Electronic Equipment
 The mark is in compliance with the Waste Electrical and Electronic Equipment Directive 
2002/96/EC (WEEE).The mark...

6Warning, Notices and Safety Instructions
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPENThe lightning flash with an arrowhead within a triangle
is intended to tell the user that inside this product
may cause risk of electrical shock to persons.
The exclamation point within a triangle is intended to tell
the user that important operating and/or servicing instructions
are included in the technical documentation for this equipment. CAUTION / TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER(OR BACK)
NO...

7 Warning, Notices and Safety Instructions
Ventilation
The projector case is designed with slots and openings to remove the heat inside the projector so that it 
will not overheat and damage the components. Be sure to operate the projector in an environment with 
ideal ventilation and don't operate it on a sofa, rug or other closed-in environments that could obstruct 
ventilation.
Filter 
<	


	

	







=



	

	
	


>
	
%

...

8Warning, Notices and Safety Instructions
Changing par ts
Should any part of the projector be damaged, check with your servicing personnel that only 
		



	




	

[

\

	

	



		





	@	

	





]

	
	
>
&


remind the servicing personnel to perform safety inspections to ensure that the projector operates 
normally.
Power cord
Don't place the projector where the...

9 Warning, Notices and Safety Instructions
Do not tilt the projector more than 15 degrees.
The maximum tilt angle for the projector is 15 degrees. 
When the projector is tilted more than 15 degrees, it will shorten the life of the projector lamp and 
may lead to other unpredictable damages.
Can’t >15°
Can’t >15°
	




	

	


	


When operating the projector at higher altitudes, be sure to manually set the fan mode to "High" or 







...

10Warning, Notices and Safety Instructions
Name and quantity of toxic/hazardous substances/elements contained 
in the product