Global Garden Products XK4 165 HD, XK4 180 HD Instructions Manual

51
DEUTSCHDE
5.8.1 Kontrolle
Drehen Sie das Rad mit kurzem ruckartigen Zie-
hen nach vorn und hinten. Es darf kein mechani-
sches Spiel an den Lenkketten vorliegen.
5.8.2 Einstellung
Justieren Sie die Lenkketten bei Bedarf wie folgt:
1. Stellen Sie das Gerät auf geradeaus ein.
2. Justieren Sie die Lenkketten mit den zwei Mut-tern, die sich unter dem Knicklenkpunkt befin-
den. Siehe Abb. 16.
3. Justieren Sie beide Muttern gleich und so weit,  bis kein Spiel mehr vorliegt.
4. Fahren Sie das Gerät zur Probe...

52
DEUTSCHDE
4.  Papierfilter folgendermaßen reinigen: Filter leicht gegen eine ebene Fläche klopfen. Wenn 
der Papierfilter sehr schmutzig ist, sollte er aus-
gewechselt werden.
5.  Den Luftfilter in umgekehrter Reihenfolge wie- der zusammensetzen.
Zur Reinigung des Papierfilters dürfen keine 
Lösungsmittel wie z. B. Petroleum verwendet 
werden. Diese Lösungsmittel zerstören den Fil-
ter.
Zur Reinigung des Papierfilters keine Druckluft 
benutzen. Der Papierfilter darf nicht eingeölt 
werden. 
5.10.2...

53
ENGLISHEN
1 GENERAL
This symbol indicates WARNING. Seri-
ous personal injury and/or damage to 
property may result if the instructions 
are not followed carefully.
You must read these instructions for use 
and the accompanying pamphlet 
“SAFETY INSTRUCTIONS” careful-
ly, before starting up the machine.
1.1 SYMBOLSThe following symbols appear on the machine. 
They are there to remind you of the care and atten-
tion required during use and maintenance.
This is what the symbols mean:Wa r n i n g !
Read...

54
ENGLISHEN
2.4.3 Inhibitor, parking brake (3:A)
The inhibitor locks the “clutch-brake” 
pedal in the depressed position. This func-
tion is used to lock the machine on slopes, 
during transport, etc., when the engine is 
not running.
Locking:
1. Depress the pedal (3:B) fully. 
2. Move the inhibitor (3:A) to the right.
3. Release the pedal (3:B).
4. Release the inhibitor (3:A).
Unlocking:
Press and release the pedal (3:B).
2.4.4 Driving-service brake (3:F)
If the machine does not brake as expect-
ed...

55
ENGLISHEN
2.4.10 Hour meter (2:P)
Indicates the number of working hours. Only 
works when the engine is running.
2.4.11 Cutting height adjustment (4, 5:J)
The machine is equipped with a control for using 
the cutting deck with electrical cutting height ad-
justment.The switch is used to adjust the cutting 
height in continuously variable positions.
The cutting deck is connected to the contact (2:Q).
2.4.12 Clutch release lever 
A lever for disengaging the variable transmission.
4WD is equipped with...

56
ENGLISHEN
3 AREAS OF USE
The machine may only be used for the following 
tasks using the genuine GGP accessories stated.
The maximum vertical load on the towing hitch 
must not exceed 100 N.
The maximum over-run load on the towing hitch 
from towed accessories must not exceed 500 N.
NOTE! Before using a trailer – contact your insur-
ance company.
NOTE! This machine is not intended to be driven 
on public roads.
4 STARTING AND OPERATION
The machine may not be operated un-
less the engine casing is...

57
ENGLISHEN
4.4.1 General safety check
4.4.2 Electrical safety checkThe operation of the safety system 
should always be checked every time 
before use.
4.5 START1.  Open the fuel cock. See 15.
2.  Check that the spark plug cable(s) is/are in-stalled on the spark plug(s).
3.  Check to make sure that the power take-off is  disengaged. 
4.  Do not keep your foot on the drive pedal. 
5. 165 HD:
Put the throttle control at full throttle. 
Starting cold engine – pull the choke control out 
fully. 
Starting...

58
ENGLISHEN
4.8 CLEANING
To reduce the risk of fire, keep the en-
gine, silencer, battery and fuel tank free 
from grass, leaves and oil.
To reduce the risk of fire, regularly 
check the machine for oil and/or fuel 
leakage. 
Never use high-pressure water. This can 
damage shaft seals, electrical compo-
nents or hydraulic valves.
Never use high-pressure air against the 
radiator fins. This will damage the fin 
structure. 
Clean the machine after each use. The following 
instructions apply for cleaning:...

59
ENGLISHEN
Oil quantity:
7. After filling up the oil, start the engine and idle  for 30 seconds. 
8. Check to see if there is any oil leakage.
9. Stop the engine. Wait for 30 seconds and then  check the oil level in accordance with 4.2.
5.4.3 Oil filter
First drain the engine oil and install the oil drain-
age plug as described above. Then replace the oil 
filter as follows:
1. Clean the area around the filter and dismantle  the filter.
2. Moisten the new filter’s gasket with oil.
3. Install the...

60
ENGLISHEN
10.Switch off the engine, install the oil reservoir cover and close the engine cover.
11.Test drive for several minutes and adjust the oil  level in the reservoir.
5.7 BELT TRANSMISSIONSAfter 5 hours of operation, check that all the belts 
are intact and undamaged.
5.8 STEERINGThe steering must be checked/adjusted after 5 
hours of operation and thereafter after 100 hours of 
operation.
5.8.1 Checks
Briefly turn the steering wheel back and forth. 
There must be no mechanical clearance in the...