GE Logiq 9 User Manual

Safety Precautions
LOGIQ E9 User Guide 4-29
Direction 5180302-100 Rev. 1
Patient Environmental Devices
 Figure 4-1. Patient Environmental Devices
1.  Front Panel (Signal I/O Port, Power On/Off)
2. Peripheral Devices
DVD Multi Drive
3. Netowrk/Disk Indicators
4.  Probe Ports (4)
5. Imaging Probes6. Power In/Out
Power Line (AC~)
Ground Line
Power Cable with Protective Earth
7. Signals I/O Port
InSite Modem (Signal I/O Port) 

Safety
4-30 LOGIQ E9 User Guide
Direction 5180302-100 Rev. 1
Acceptable Devices
The Patient Environmental devices shown on the previous page 
are specified to be suitable for use within the PATIENT 
ENVIRONMENT.
Unapproved Devices
Accessories, Options, Supplies 
CAUTIONDO NOT connect any probes or accessories without approval 
by GE within the PATIENT ENVIRONMENT.
See ‘Peripheral Update for EC countries’ on page 4-23 for 
more information.
CAUTIONDO NOT use unapproved devices. 
If devices are connected...

Safety Precautions
LOGIQ E9 User Guide 4-31
Direction 5180302-100 Rev. 1
Acoustic Output
Located on the upper right section of the system display monitor, 
the acoustic output display provides the operator with real-time 
indication of acoustic levels being generated by the system. See 
the Acoustic Output chapter in the Advanced Reference Manual 
for more information. This display is based on NEMA/AIUM 
Standards for Real-time Display of Thermal and Mechanic 
Acoustic Output Indices on Diagnostic...

Safety
4-32 LOGIQ E9 User Guide
Direction 5180302-100 Rev. 1
Acoustic Output Display Specifications (continued)
Mechanical IndexMI recognizes the importance of non-thermal processes, 
cavitation in particular, and the Index is an attempt to indicate 
the probability that they might occur within the tissue.
Changing the
Thermal Index
Ty p eYou can select the displayed TI type on Utility -> Imaging ->  B-
Mode. This preset is application dependent so each application 
could specify a different TI type....

Safety Precautions
LOGIQ E9 User Guide 4-33
Direction 5180302-100 Rev. 1
Best practices while scanning
NOTE:  Refer to the sections in Chapter 5 for a complete discussion of 
each control. 
Acoustic Output Default Levels
In order to assure that an exam does not start at a high output 
level, the LOGIQ E9 initiates scanning at a reduced default 
output level. This reduced level is preset programmable and 
depends upon the exam category and probe selected. It takes 
effect when the system is powered on or...

Safety
4-34 LOGIQ E9 User Guide
Direction 5180302-100 Rev. 1
Warning Label Locations
 Figure 4-2. Label Location 
Table 4-8:  Label Location Explanations
1.  Possible shock hazard. Do not remove covers 
or panels. No user serviceable parts are inside. 
Refer servicing to qualified service personnel.
2.  Signal ground point label CAUTION: This is 
only for “FUNCTIONAL GROUNDING”, NOT 
“PROTECTIVE EARTH”.
3.  Prescription Device (For U.S.A. Only)
4.  The equipment weighs approximately 135 kg 
(298 lbs). To...

Safety Precautions
LOGIQ E9 User Guide 4-35
Direction 5180302-100 Rev. 1
Warning Label Locations (continued)
Figure 4-3. Caution Label on the LCD Monitor  

Safety
4-36 LOGIQ E9 User Guide
Direction 5180302-100 Rev. 1 

LOGIQ E9 User Guide Index-1
Direction 5180302-100 Rev. 1
Index
A
accessory connector panel illustration , 1-8
acoustic output
default levels , 4-33
active images , 1-30
air filter
locating , 3-37
ALARA (as low as reasonably achievable), bioeffects
, 4-3
area measurements
ellipse , 2-15
spline , 2-18
trace , 2-16, , 2-17, , 2-18
B
back view, console , 1-6
backing up data
EZBackup/Move, see EZBackup/Move, using
biological hazards , 4-9, , 4-10
B-Mode measurements, general , 2-13
B-Mode measurements, mode...

Index-2 LOGIQ E9 User Guide
Direction 5180302-100 Rev. 1
Exam Data Transfer, description , 1-30
exam study, display location , 1-11
explosion hazard , 4-8
EZBackup/Move, using , 3-18
F
freezing an image , 2-10
front view, console , 1-6
G
Gels, coupling , 3-11
H
hazards , 3-10
hazards, safety symbols , 4-3
hazards, types
biological , 4-9, , 4-10
electrical , 4-6, , 4-9
explosion , 4-8
mechanical , 4-6
I
Indications for Use , 1-2
L
left side view, console , 1-5
LOGIQ system
contraindications , 1-2...