GE Logiq 9 User Manual

Safety Precautions
LOGIQ E9 User Guide 4-9
Direction 5180302-100 Rev. 1
Related Hazards (continued)
CAUTIONThis equipment provides no special means of protection from 
high frequency (HF) burns that may result from using an 
electrosurgical unit (ESU).  To reduce the risk of HF burns, 
avoid contact between the patient and ultrasound transducer 
while operating the ESU.  Where contact cannot be avoided, as 
in the case of TEE monitoring during surgery, make sure the 
transducer is not located between the...

Safety
4-10 LOGIQ E9 User Guide
Direction 5180302-100 Rev. 1
Related Hazards (continued)
Biological
HazardFor patient and personnel safety, be aware of biological 
hazards while performing invasive procedures. To avoid the 
risk of disease transmission:
•  Use protective barriers (gloves and probe sheaths) 
whenever possible. Follow sterile procedures when 
appropriate.
•  Thoroughly clean probes and reusable accessories after 
each patient examination and disinfect or sterilize as 
needed. Refer to...

Safety Precautions
LOGIQ E9 User Guide 4-11
Direction 5180302-100 Rev. 1
Related Hazards (continued)
CAUTIONWhen you move the Control Panel up/down with the monitor, 
place BOTH hands on the Control Panel.  Touching other 
moving parts other than the Control Panel may cause personal 
injury.
CAUTIONTo avoid injury or system damage, NEVER place any object or 
liquid on the operator panel.
CAUTIONArchived data is managed at the individual sites. Performing 
data backup (to any device) is recommended....

Safety
4-12 LOGIQ E9 User Guide
Direction 5180302-100 Rev. 1
Related Hazards (continued)
Material Safe Data
Rubber partMaterial: EPDM
Where Used: Probe holder/Gel holder/Keyboard bumper/Front 
and Rear Foot Pedal/System bumper at the four corners
CAUTIONTo minimize accidental loss of data, perform EZBackup and 
Backup on a regular basis.
1.  First, perform EZBackup to save the images.
2.  Next, perform Backup at Utility -> Backup/Restore. Enable 
the following checkboxes under Backup:
• Patient Archive
•...

Safety Precautions
LOGIQ E9 User Guide 4-13
Direction 5180302-100 Rev. 1
Related Hazards (LCD Monitor)
Related Hazards (Volume Navigation)
CAUTION• DO NOT place a finger, hand or any object on the joint of 
the monitor or monitor arm to avoid injury when moving the 
monitor and monitor arm.
•  To avoid result of injury or system damage, NEVER place 
any object or liquid on the monitor, whether in the home or 
flip down/transport position.
• DO NOT scratch or press on the panel with any sharp 
objects,...

Safety
4-14 LOGIQ E9 User Guide
Direction 5180302-100 Rev. 1
Device Labels
Label Icon Description
The following table describes the purpose and location of safety 
labels and other important information provided on the 
equipment.
Table 4-2:  Label Icons
Label/IconPurpose/MeaningLocation
Identification and Rating Plate • Manufacturer’s name and country of 
origin
• Date of manufacture
• Model and serial numbers
• Electrical ratings (Volts, Amps, 
phase, and frequency)See ‘Warning Label Locations’ 
on...

Safety Precautions
LOGIQ E9 User Guide 4-15
Direction 5180302-100 Rev. 1
“Warning” - Dangerous voltage” (the 
lightning flash with arrowhead) is used 
to indicate electric shock hazards.Rear panel and inside of 
console
“Mains OFF” indicates the power off 
position of the mains power breaker.See the Console Overview 
section for location 
information.
“Mains ON” indicates the power on 
position of the mains power breaker.See the Console Overview 
section for location 
information.
“ON” indicates the...

Safety
4-16 LOGIQ E9 User Guide
Direction 5180302-100 Rev. 1
This symbol indicates that waste 
electrical and electronic equipment 
must not be disposed of as unsorted 
municipal waste and must be collected 
separately. Please contact an 
authorized representative of the 
manufacturer for information 
concerning the decommissioning of 
your equipment.Rear Panel
DO NOT place a finger, hand or any 
object below the operator panel on the 
top cover of the console to avoid injury 
while you’re moving it up...

Safety Precautions
LOGIQ E9 User Guide 4-17
Direction 5180302-100 Rev. 1
Label Icon Description (continued)
ClassificationsType of protection against electric shock
Class I Equipment (*1)
Degree of protection against electric shock
Type BF Applied part (*2)
 (for PCG, Probes marked with BF symbol)
Continuous Operation
System is Ordinary Equipment (IPX0)
*1. Class I Equipment
EQUIPMENT in which protection against electric shock does not 
rely on BASIC INSULATION only, but includes an earth ground. 
This...

Safety
4-18 LOGIQ E9 User Guide
Direction 5180302-100 Rev. 1
EMC (Electromagnetic Compatibility)
NOTE:  This equipment generates, uses and can radiate radio 
frequency energy. The equipment may cause radio frequency 
interference to other medical and non-medical devices and radio 
communications. To provide reasonable protection against such 
interference, this product complies with emissions limits for a 
Group 1, Class A Medical Devices Directive as stated in EN 
60601-1-2. However, there is no...