Gateway m350 User Manual

251
Adding or replacing memory
www.gateway.com
Replacing memory under the keyboard
Installing replacement memory under the keyboard is a process consisting of 
three procedures that must be done in sequence:
1Open the keyboard compartment.
2Replace the memory.
3Reattach the keyboard.
Opening the keyboard compartment
To open the keyboard compartment:
1Follow the instructions under “Preventing static electricity discharge” on 
page 246.
2Turn off your notebook, disconnect the AC adapter and modem and...

252
Chapter 15: Upgrading Your Notebook
www.gateway.com
7Insert the small flat-blade screwdriver under the bottom right corner of 
the keyboard bezel and gently pry it up.
ImportantInserting a piece of cloth between the screwdriver and 
keyboard and notebook case will help prevent damage to 
your notebook. 

253
Adding or replacing memory
www.gateway.com
8Pull the bezel off your notebook. You will hear small snapping sounds as 
the bezel comes away from your notebook. Be careful not to break off the 
tabs found on the left end of the bezel.
9With a small Phillips screwdriver, remove the four keyboard screws and 
put them in a safe place.
Screws 

254
Chapter 15: Upgrading Your Notebook
www.gateway.com
10Lift the back edge of the keyboard, then slowly rotate it toward you so it 
lies keys-down on top of your notebook. Be careful not to damage the 
LCD panel. 

255
Adding or replacing memory
www.gateway.com
Replacing the memory
To replace the memory:
1Gently press outward on the clip at each end of the memory module until 
the module tilts upward.
2Pull the memory module out of the slot. 

256
Chapter 15: Upgrading Your Notebook
www.gateway.com
3Hold the new or replacement module at a 30-degree angle and press it into 
the empty memory slot. This module is keyed so it can only be inserted 
in one direction. If the module does not fit, make sure that the notch in 
the module lines up with the tab in the memory bay.
4Gently push the module down until it clicks in place.
Reattaching the keyboard
To reattach the keyboard:
1Rotate the keyboard toward the LCD panel until the keyboard is 
almost...

257
Adding or replacing memory
www.gateway.com
4Replace the four keyboard screws.
5Slide the two tabs on the left end of the bezel under your notebook frame.
Screws 

258
Chapter 15: Upgrading Your Notebook
www.gateway.com
6Press down on the bezel in several places until it clicks in place.
The bezel is correctly mounted when you can run you finger along the 
bezel and find no loose spots. The bezel should be flat all the way across.
7Turn your notebook over so the bottom is facing up.
8Insert the battery, then turn your notebook over.
9Connect the power adapter and modem and network cables, then turn on 
your notebook.
WarningIf the bezel is not correctly replaced,...

259
Replacing the hard drive kit
www.gateway.com
Replacing the hard drive kit
If you would like more hard drive capacity, you can replace your original drive 
with a higher-capacity drive.
To replace the hard drive kit:
1Follow the instructions under “Preventing static electricity discharge” on 
page 246.
2Turn off your notebook, disconnect the AC adapter and modem and 
network cables.
3Turn your notebook over so the bottom is facing up.
4Remove the battery. For more information, see “Replacing the...

260
Chapter 15: Upgrading Your Notebook
www.gateway.com
5Remove the two hard drive kit screws.
Tips & TricksUse a magnetic screwdriver or turn the notebook over to 
remove the screws.
Screws