Home > Ford > Automobile > Ford Taurus 2010 Owners Manual

Ford Taurus 2010 Owners Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Ford Taurus 2010 Owners Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 41 Ford manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							Replacing backup lamp bulbs
    The backup lamp bulbs are located in the deck lid assembly.
    1. Make sure the headlamp switch is in the off position.
    2. Remove the deck lid trim panel
    press pins and carefully pull the
    panel away to expose the backside
    of the backup lamp assembly.
    3. Remove bulb socket by rotating it
    counterclockwise, then pull it out of
    the lamp assembly.
    4. Disconnect the wire harness connector from the bulb/socket.
    5. Install the new bulb in reverse order.
    Lights
    71
    2010 Taurus(500)
    Owners Guide(own2002), 1st Printing
    USA(fus) 
    						
    							Replacing high-mount brake lamp bulbs
    Your vehicle is equipped with an LED high-mount brake lamp. It is
    designed to last the life of the vehicle. If replacement is required, it is
    recommended that you see your authorized dealer.
    Replacing license plate lamp bulbs
    1. Make sure the headlamp switch is
    in the off position.
    2. Remove the two screws from the
    license plate lamp assembly.
    3. Carefully pull the bulb out from
    the contacts.
    Install new bulb(s) in reverse order.
    Replacing supplemental park lamp bulbs
    Your vehicle is equipped with an LED supplemental park lamp. It is
    designed to last the life of the vehicle. If replacement is required, it is
    recommended that you see your authorized dealer.
    Lights
    72
    2010 Taurus(500)
    Owners Guide(own2002), 1st Printing
    USA(fus) 
    						
    							MULTI-FUNCTION LEVER
    Windshield wiper:Rotate the end
    of the control away from you to
    increase the speed of the wipers;
    rotate towards you to decrease the
    speed of the wipers.
    Rain sensing wipers (if
    equipped):The rain sensing wipers
    will automatically activate when
    moisture is present on the
    windshield and the multi-function
    switch is set to one of five
    auto/interval moisture sensitivity settings. Rotate the end of the control
    toward the windshield to increase the sensitivity. The speed of the rain
    sensitive wipers will vary based on the amount of moisture detected on
    the windshield and the auto/interval setting. The wipers will continue to
    wipe as long as the presence of moisture is detected on the windshield.
    More or less wiping may occur depending on humidity, mist or light rain,
    or road spray.
    Keep the outside of the windshield clean, especially the area around the
    rear view mirror where the sensor is located or rain sensor performance
    may be affected.
    Note:During winter driving conditions with ice, snow or a salty road
    mist, inconsistent wiping or smearing may occur. In these conditions, you
    can lower the sensitivity to reduce the amount of smearing or override
    the feature by selecting low- or high-speed wiping or turning the wiper
    system off.
    Note:The rain sensing wiper feature must be turned off before entering
    a car wash.
    Windshield washer:Push the end
    of the stalk:
    •briefly: causes a single swipe of
    the wipers without washer fluid.
    •a quick push and hold: the wipers
    will swipe three times with
    washer fluid.
    •a long push and hold: the wipers
    and washer fluid will be activated
    for up to ten seconds.
    Driver Controls
    73
    2010 Taurus(500)
    Owners Guide(own2002), 1st Printing
    USA(fus) 
    						
    							Courtesy wipe feature:One extra wipe will occur a few seconds after
    washing the front window to clear any excess washer fluid remaining on
    the windshield.
    Note:Do not operate the washer when the washer reservoir is empty.
    This may cause the washer pump to overheat. Check the washer fluid
    level frequently. Do not operate the wipers when the windshield is dry.
    This may scratch the glass, damage the wiper blades and cause the wiper
    motor to burn out. Before operating the wiper on a dry windshield,
    always use the windshield washer. In freezing weather, be sure the wiper
    blades are not frozen to the windshield before operating the wipers.
    Windshield wiper rainlamp feature
    When the windshield wipers are turned on during daylight, and the
    headlamp control is in the autolamp position, the exterior lamps will turn
    on after a brief delay and will remain on until the wipers are turned off.
    TILT/TELESCOPE STEERING WHEEL
    To adjust the steering wheel:
    1. Pull the lever down to unlock the
    steering column.
    2. While the lever is in the down
    position, move the steering wheel
    up or down and in or out until you
    find the desired position.
    3. While holding the steering wheel
    in place, pull the lever up to its
    original position to lock the steering
    column.
    WARNING:Never adjust the steering wheel when the vehicle is
    moving.
    Driver Controls
    74
    2010 Taurus(500)
    Owners Guide(own2002), 1st Printing
    USA(fus) 
    						
    							ILLUMINATED VISOR MIRROR
    Lift the mirror cover to turn on the
    visor mirror lamp.
    Slide on rod feature
    The visor will slide back and forth
    on the rod for increased sunlight
    coverage. Rotate the visor towards
    the side window and extend it
    rearward for additional sunlight
    coverage.
    Note:To stow the visor back into
    the headliner, visor must be
    retracted before moving it back
    towards the windshield.
    OVERHEAD CONSOLE
    The appearance of your vehicle’s overhead console will vary according to
    your option package.
    Storage compartment
    The storage compartment may be
    used to store a pair of sunglasses.
    Press the release area on the rear
    edge of the bin door to open the
    storage compartment. The door will
    open to the full open position.
    Driver Controls
    75
    2010 Taurus(500)
    Owners Guide(own2002), 1st Printing
    USA(fus) 
    						
    							ELECTRONIC COMPASS (IF EQUIPPED)
    The compass heading is displayed in the center stack display.
    The compass reading may be affected when you drive near large
    buildings, bridges, power lines and powerful broadcast antenna. Magnetic
    or metallic objects placed in, on or near the vehicle may also affect
    compass accuracy.
    Usually, when something affects the compass readings, the compass will
    correct itself after a few days of operating your vehicle in normal
    conditions. If the compass still appears to be inaccurate, a manual
    calibration may be necessary. Refer toCompass calibration
    adjustment.
    Most geographic areas (zones) have a magnetic north compass point that
    varies slightly from the northerly direction on maps. This variation is four
    degrees between adjacent zones and will become noticeable as the
    vehicle crosses multiple zones. A correct zone setting will eliminate this
    error. Refer toCompass zone adjustment.
    Compass zone adjustment
    1. Determine which magnetic zone
    you are in for your geographic
    location by referring to the zone
    map.
    2. Turn ignition to the on position.
    3. Press and hold the 7 and 9 radio
    preset buttons together for
    approximately five seconds until
    ZONE XX appears in the CID.
    1 2 3
    4
    5
    6 7 8 9 101112 13 14 15
    Driver Controls
    76
    2010 Taurus(500)
    Owners Guide(own2002), 1st Printing
    USA(fus) 
    						
    							4. Press and release the 7 and 9
    radio preset buttons together,
    repeatedly until ZONE XX changes
    to the correct zone (1–15) in the
    CID.
    5. The direction will display after
    the buttons are released. The zone
    is now updated.
    Compass calibration adjustment
    Perform compass calibration in an open area free from steel structures
    and high voltage lines. For optimum calibration, turn off all electrical
    accessories (heater/air conditioning, wipers, etc.) and make sure all
    vehicle doors are shut.
    1. Start the vehicle.
    2. To calibrate, press and hold the 7
    and 9 radio preset buttons together
    for approximately 10 seconds until
    CAL appears. Release the buttons.
    3. Slowly drive the vehicle in a
    circle (less than 3 mph [5 km/h])
    until the CAL display changes to the
    direction value (N, S, E, W, etc.). It
    may take up to five circles to
    complete calibration.
    4. The compass is now calibrated.
    Driver Controls
    77
    2010 Taurus(500)
    Owners Guide(own2002), 1st Printing
    USA(fus) 
    						
    							CENTER CONSOLE
    Your vehicle may be equipped with a variety of console features.Note:
    The appearance and features of the center console may be different than
    show based on your vehicle’s option level. These include:
    •Cupholders
    •Utility compartment with audio
    input jack, USB port and power
    point
    •Pen holder
    WARNING:Use only soft cups in the cupholder. Hard objects
    can injure you in a collision.
    Some consoles will have panel doors
    covering the cupholders and
    switches. Press the doors to open
    them.
    Some cupholders will be equipped
    with a divider. Pull up on the divider
    and move it in the slots right or left
    for the best fit with the cup you are
    using.
    Driver Controls
    78
    2010 Taurus(500)
    Owners Guide(own2002), 1st Printing
    USA(fus) 
    						
    							AUXILIARY POWER POINT (12VDC)
    Power outlets are designed for accessory plugs only. Do not insert
    any other object in the power outlet as this will damage the
    outlet and blow the fuse. Do not hang any type of accessory or
    accessory bracket from the plug. Improper use of the power
    outlet can cause damage not covered by your warranty.
    Auxiliary power points can be found in the following locations:
    •On the instrument panel under a panel door (press the door to open)
    •In the center console utility compartment
    •On the rear of the center console accessible from the rear seat
    Do not use the power point for operating the cigarette lighter element (if
    equipped).
    To prevent the fuse from being blown, do not use the power point(s)
    over the vehicle capacity of 12 VDC/180W. If the power point or cigar
    lighter socket is not working, a fuse may have blown. Refer toFuses and
    relaysin theRoadside Emergencieschapter for information on
    checking and replacing fuses.
    To have full capacity usage of your power point, the engine is required to
    be running to avoid unintentional discharge of the battery. To prevent
    the battery from being discharged:
    •do not use the power point longer than necessary when the engine is
    not running,
    •do not leave battery chargers, video game adapters, computers and
    other devices plugged in overnight or when the vehicle is parked for
    extended periods.
    Always keep the power point caps closed when not being used.
    POWER WINDOWS
    WARNING:Do not leave children unattended in the vehicle and
    do not let children play with the power windows. They may
    seriously injure themselves.
    WARNING:When closing the power windows, you should verify
    they are free of obstructions and ensure that children and/or
    pets are not in the proximity of the window openings.
    Driver Controls
    79
    2010 Taurus(500)
    Owners Guide(own2002), 1st Printing
    USA(fus) 
    						
    							Press and pull the window switches
    to open and close windows.
    •Push down (to the first detent)
    and hold the switch to open.
    •Pull up (to the first detent) and
    hold the switch to close.
    Rear Window Buffeting:When one or both of the rear windows are
    open, the vehicle may demonstrate a wind throb or buffeting noise. This
    noise can be alleviated by lowering a front window approximately
    2–3 inches (5–8 cm).
    Global open windows (if equipped)
    Press
    on the remote transmitter and hold for more than two seconds
    in order to begin opening the two front windows and (if equipped) vent
    the moon roof.
    •The
    control can then be released and the windows will complete
    the opening operation and fully vent the moon roof.
    •If
    oris pressed during the opening operation, both windows
    and moon roof movement will stop.
    Note:The ignition must be in the off position and the accessory delay
    feature must be not activated in order for this feature to operate.
    Note:To disable this feature, contact your authorized dealer.
    One-touch up or down
    This feature allows the driver’s and passenger’s window to open or close
    fully without holding the control down.
    Driver’s window one-touch up or
    down
    A
    U
    T
    O
    A
    U
    T
    O
    Driver Controls
    80
    2010 Taurus(500)
    Owners Guide(own2002), 1st Printing
    USA(fus) 
    						
    All Ford manuals Comments (0)

    Related Manuals for Ford Taurus 2010 Owners Manual