Epson Projector Emp Ts10 User Manual

Printed in Japan
402171700
(9002556)
02.01-.*A(C05)
Printed on 100% recycled paper.
E 

About The Manuals and Notations Used
The documentation for your EPSON projector is divided into the following four manuals. Refer to the 
manuals in the order given below.
Unpacking and Installation Guide
This manual contains information on the procedures from unpacking the projector through to starting to use the 
projector, and also describes the included accessories.
Safety Instructions/ World-Wide Warranty Terms
This manual contains information on using the projector safely, and also includes safety...

1
Contents
Features of the Projector ......................................................................................... 2
Basic Operations
Turning On the Projector .......................................................................................... 6
Connecting the Power Cord ............................................................................................ 6
Turning On the Power and Projecting Images ................................................................ 7
Turning Off...

2
Features of the Projector
Compact and lightweight
The projector has a compact body with a footprint the size of an A4 page 
(274 (D) x 348 (W) x 104 (H) mm (10.79 (D) x 13.7 (W) x 4.09 (H) inches) and 
is light in weight (approximately 4.2kg (9.3 lbs)).
Equipped with five color modes
The optimum images can be projected simply 
by selecting the desired color mode from the 
following five preset modes in accordance 
with the images being projected. No complex 
color adjustments are required.
  Dynamic...

3 

5
Basic 
Operations
This chapter describes basic operations such as turning 
projection on and off and adjusting the projected images.
Turning On the Projector ................................... 6
•
•• •Connecting the Power Cord ............................................... 6
•
•• •Turning On the Power and Projecting Images.................. 7
Turning Off the Projector ................................... 9
Adjusting the Screen Image ............................ 11
•
•• •Adjusting the Image Size...

6
Turning On the Projector
This section describes the procedure from turning on the power to projecting images.
Procedure
1Check that the power is turned off for all 
components connected to the 
projector.
2Connect the computer or other video 
source to the projector.
(Setup Guide).
3Remove the lens cover.
4
Connect the accessory power cord to 
the projector.
Check that the power cord connector is facing the 
same way as the power inlet on the projector, and 
then insert the power cord connector...

7
Basic Operations
Procedure
1
Turn on the power for all equipment 
connected to the projector.
For a video source, press the [Play] button at the 
video source to start playback if necessary.
Check that the   indicator on the projector has 
stopped flashing and lights orange.
2When using the remote control, set the 
R/C switch on the remote control to ON.
3Press the [Power] button on either the 
remote control or the projectors 
control panel to turn on the power for 
the projector.
The   indicator...

Turning On the Projector
8
•
•• •If only one signal source has been connected, the signals from that source will be 
projected without needing to press one of the buttons from the previous table.
•
•• •If the No-Signal. message does not disappear, check the connections again.
•
•• •If a laptop computer or a computer with an LCD screen has been connected to the 
projector, the images may not be projected straight away. After making the connections, 
check that the computer has been set up to output...