Eiki Lc-Xdp3500 Multimedia Projector Owners Manual

48
Maintenance of Projector
Lamp
1.  If you want to replace new lamp, but the projector was just turned off, 
please let the projector cool down and unplug power cord at least 60 
minutes.
2.  If the projector is mounted in the ceiling, contact your dealer to repla\
ce 
the lamp.
Replacing New Lamp(Part Number:23040021)
1. Remove the lamp door.
2.  Loosen 2 screws of the lamp holder. Hold the handle on the top of the 
lamp, pull out the lamp straight off the projector.
3.	Insert	new	lamp,	lock	the	lamp...

49
Maintenance of Projector
 WARNING
The projector uses a high-pressure mercury lamp.
The explosion of lamp with a loud bang or burn out could possibly cause \
injury	or	a	fire.
When	the	bulb	bursts,	it	is	possible	for	shards	of	glass	to	fly	into	the	lamp	
housing; and for gas containing mercury to escape from the projector’s 
vent holes.
If the lamp has broken, do not check the inside of the projector. Please 
ventilate the room immediately.
Do not touch or bring your face close to the broken pieces...

50
Maintenance of Projector
Additional
- In order to ensure the safe use of your projector, please contact your 
dealer to inspect about once a year.
- Before maintenance, make sure the power cable is unplugged, allow the 
projector	to	cool	sufficiently.	 The	high	temperature	state	of	the	projector	
could cause a burn in and/or malfunction to the projector.
-Never try to maintain the inside of the projector by yourself. 
Anti-smoke filter(Part Number:13340231) 
- If the projector would be used in smokier...

Troubleshooting
51
Troubleshooting
Indicator
The power and lamp indicators show the status of the projector. Before requesting repair, 
check the projector status using the chart below. If the problem cannot be resolved, 
contact your dealer.
In normal status~~~
POWERLAMPCONDITIONSDESCRIPTION
Blinking In 
GreenOffStand by modeProjector is ready to be turned on.
Lighting In 
GreenOffOn modeProjector is on and operating.
Lighting In 
Green
Blinking In Red 
( Slow )Cool down modeProjector is in cool down...

52
Troubleshooting
Error For Machine Defects
The following problems may be confused with a machine defect. Check and \
follow the 
table. If it couldn’t be improved, contact your dealer.
SymptomCause / Remedy
Projector power
does not turn on.
The power cord is disconnected.
Plug the power cord into an AC outlet.
Intending to turn on the projector again during the cool down mode.
Wait until the cool down mode has completed.
There is no lamp and/or lamp cover is not firmly closed.
Please turn off the power...

53
Troubleshooting
Error For Machine Defects
SymptomCause / Remedy
No audio
The projector is not connected correctly.
Check audio cable if connect correctly.
The volume is set to minimum.
Adjust the volume.
Mute is turned on.
Press the MUTE button.
Remote control is 
not working.
No battery.
Before using the remote control, please check the battery of remote 
control.
Remote signal is obstructed.
Remove the obstacle between projector and remote control. 

54
Troubleshooting
List of Supported Monitor Displays
Computer mode / DVI-I mode
SignalRefresh Rate (Hz)Resolution (dots)
VGA60640x480
VESA60 / 72 / 75 / 85640x480
SVGA56 / 60 / 72 / 75 /85800x600
XGA60 / 70 / 75 / 851024x768
SXGA70 / 751152x864
SXGA60 / 751280x960
SXGA601280x1024
WXGA60 / 751280x800
WXGA+60/ 75 / 851440x900
SXGA +60 / 751400x1050
UXGA601600x1200
WSXGA+601680x1050
MAC671280x1024 / 640x480
MAC75832x624
MAC751024x768
MAC751152x870
Component (Y,Pb,Pr)
SignalRefresh Rate (Hz)Resolution...

Appendix
Appendix
Menu Tree (PC Mode)
AUDIOContrast
Sharpness
NaturalCinema
Daylight Green Board
White Board
Black Board
Volume
Mute
H Position
Frequency
ADVANCE DBlank Power Off
DVI-I
PIN Lock Protectio
nOn 1
On 2
FrontCeilin g
Rear
Ceiling And Re a
r
Freeze
English…]ÛLþ_Í


Français
Deutsch
Italiano
Polski
Português
Español
ไทย
Svenska
1:1 MAC ADDR
.
PICTURE Brightness
SETTING V Position
Phase
Auto Keystone
V Keystone Auto Sync
Auto Search
Zoom / Pa n
Blank 
Reset
Resize
4:3
16:9
Language...

Appendix
AUDIOContrast
Sharpness
NaturalCinema
Daylight Green Board
White Board
Black Board
Volume
Mute
ADVANCE DBlank Power Off
DVI-I PIN Lock Protectio
n
On 1
On 2
FrontCeilin g
Rear
Ceiling And Rear
Freeze
English…]ÛLþ_Í


Français
Deutsch
Italiano
Polski
Português
Español
ไทย
Svenska MAC ADDR
.
PICTURE Brightness
SETTING
Auto Keystone
Auto Sync
Auto Search
Zoom / Pa n
Blank 
Reset
Resize
Language
Select Sourc e
Logo SettingRGB 2
RGB 1
Y,Pb,PrVideoS-VideoLogo Mode
Background Logo Size
Display...

Appendix
360.30
35.30
267.10
255.00
195.00170.00
265.00
325.00
110.40
90.00
Appearance
Screw for Ceiling Mounted M4x8mm 4pcs