Eiki Eip-3500 Dlp Projector Owners Manual

67
Optional
accessoryLamp unit
AH-35001Removing and Installing
the Lamp Unit
Info
•Ensure the lamp unit is removed using the
handle. Ensure the glass surface of the
lamp unit or the inside of the projector are
not touched.
•To avoid injury to yourself and damage to
the lamp, ensure to carefully follow the
steps below.
•Do not loosen other screws except for the
lamp unit cover and lamp unit.
1Press  on the projector or 
on the remote control to put the
projector into standby mode.
•Wait until the cooling...

68
4Remove the lamp unit.
•Loosen the securing screws from the
lamp unit. Hold the lamp unit by the
handle and pull it in the direction of the
arrow. At this time, keep the lamp unit
horizontal and do not tilt it.
5Insert the new lamp unit.
•Press the lamp unit firmly into the lamp
unit compartment. Fasten the securing
screws.
6Replace the lamp unit cover.
•Align the lamp unit cover and slide it to
close. Then tighten the user service
screw to secure the lamp unit cover.
Info
•If the lamp unit and lamp...

69
Note
•This projector may not be able to display images from notebook computers in simultaneous (CRT/LCD)
mode. Should this occur, turn off the LCD display on the notebook computer and output the display data
in “CRT only” mode. Details on how to change display modes can be found in your notebook computer’s
operation manual.
•When this projector receives 640 × 350 VESA format VGA signals, “640 × 400” appears on the screen.
•When projecting the RGB interlace signal using INPUT 1/2 with “Signal Type” set...

70
Troubleshooting
Check
•Projector power cord is not plugged into the wall outlet.
•Power to the external connected devices is off.
•The selected input mode is wrong.
•The AV MUTE function is working.
•Cables incorrectly connected to rear panel of the projector.
•Remote control batteries have run out.
•External output has not been set when connecting notebook computer.
•The lamp unit cover is not installed correctly.
•Cables incorrectly connected to the rear panel of the projector.
•“Bright” is set to...

71
CheckProblemPage
Picture is green on
INPUT 1 (COMPONENT)/
INPUT 2 (COMPONENT).
Picture is pink (no green)
on INPUT 1 (RGB)/
INPUT 2 (RGB).
Picture is too bright and
whitish.
The cooling fan
becomes noisy.
The lamp does not light
up even after the
projector turns on.
The lamp suddenly turns
off during projection.
The image sometimes
flickers.
The lamp takes a long
time to turn on.
Picture is dark.•Change the input signal type setting.
•Image adjustments are incorrectly set.
•When temperature inside the...

72
Specifications
DLPTM Projector
EIP-3500
NTSC3.58/NTSC4.43/PAL/PAL-M/PAL-N/PAL-60/SECAM/
DTV480I/DTV480P/DTV540P/DTV576I/DTV576P/DTV720P/DTV1035I/DTV1080I
Single Chip Digital Micromirror Device
TM (DMDTM) by Texas Instruments
Panel size: 0.7
No. of dots:  786,432 dots (1,024 [H] × 768 [V])
1.5 × electric zoom/focus lens, F2.0–2.5, f = 21.3–31.6 mm
275 W DC lamp
15-pin mini D-sub connector
Y: 1.0 Vp-p, sync negative, 75 Ω terminated
P
B: 0.7 Vp-p, 75 Ω terminated
P
R: 0.7 Vp-p, 75 Ω terminated
750 TV...

73
Glossary
Aspect Ratio
Width and height ratio of an image. The normal
aspect ratio of a computer and video image is 4:3.
There are also wide images with an aspect ratio
of 16:9 and 21:9.
Auto Sync
Optimizes projected computer images by auto-
matically adjusting certain characteristics.
Background
Initial setting image projected when no signal is
being output.
Border
Projects a 4:3 image fully within a 16:9 screen by
keeping the aspect ratio at 4:3.
Clock
Clock adjustment is used to adjust vertical...

743 RCA to 15-pin D-sub cable............................... 25
AC socket ............................................................. 29
Adjustment buttons.............................................. 40
Aspect ratio.....................................................36,37
AUDIO INPUT terminal........................................ 23
AUDIO OUTPUT terminal.................................... 28
Auto Focus......................................................32,57
AUTO FOCUS...

EIP-3500
OWNERS MANUAL
EIKI INDUSTRIAL CO., LTD.
A-Key to better communications
U.S.A.
EIKI International, Inc.
30251 Esperanza
Rancho Santa Margarita
CA 92688-2132
U.S.A.
Tel : 800-242-3454 (949)-457-0200
Fax : 800-457-3454 (949)-457-7878
E-Mail : [email protected]
Deutschland & Österreich
EIKI Deutschland GmbH
Am Frauwald 12
65510 Idstein
Deutschland
Tel : 06126-9371-0
Fax : 06126-9371-14
E-Mail : [email protected]
Canada
EIKI CANADA - Eiki International, Inc.
P.O. Box 156, 310 First St. - Unit 2,
Midland, ON,...