Digital Projection Titan 1080p-500, 1080p-250 User Manual
Here you can view all the pages of manual Digital Projection Titan 1080p-500, 1080p-250 User Manual. The Digital Projection manuals for Projector are available online for free. You can easily download all the documents as PDF.
Page 111
July 2007 Page 7.11 Digital Projection TITAN 1080p-500, 1080p-250 User Manual 7. Appendix 3. DVI-D input 24 way D-type connector 1 TMDS Data 2- 2 TMDS Data 2+ 3 TMDS Data 2 Shield 4 unused 5 unused 6 DDC Clock 7 DDC Data 8 unused 9 TMDS Data 1- 10 TMDS Data 1+ 11 TMDS Data 1 Shield 12 unused 13 unused 14 +5 V Power 15 Ground 16 Hot Plug Detect* 17 TMDS Data 0- 18 TMDS Data 0+ 19 TMDS Data 0+ 20 TMDS Data 0 Shield 21 unused 22 unused 23 TMDS Clock Shield 24 TMDS Clock+ * Hot plug detect...
Page 112
Page 7.12 July 2007
7. Appendix Digital Projection TITAN 1080p-500, 1080p-250 User Manual
4. (not used in this projector)
5. Composite video input
1 x 75 ohm BNC
PAL or NTSC video
6. S-Video input
4 pin mini-DIN
1 L Ground
2 C Ground
3 Lumunance (Y)
4 Chrominance (C)
7. Component video input
4 x 75 ohm BNC
Used for standard defi nition interlaced signals only
RGsB RGBS YCrCb
R R Cr
G + Sync G Y + Sync
B B Cb
Sync
Notes
pin view of female connector
Page 113
July 2007 Page 7.13 Digital Projection TITAN 1080p-500, 1080p-250 User Manual 7. Appendix Control connections LAN connection 10BaseT Unshielded Twisted Pair cable The standard wire colours as as follows: 1 White / Orange stripe 2 Orange 3 White / Green stripe 4 Blue 5 White / Blue stripe 6 Green 7 White / Brown stripe 8 Brown Crossed cable (used to connect directly to a computer with no hub or network.) (Note that only the green and orange pairs are crossed) 1 White / Orange stripe White / Green...
Page 114
Page 7.14 July 2007 7. Appendix Digital Projection TITAN 1080p-500, 1080p-250 User Manual Serial control input 1 unused 2 Received Data (RX) 3 Transmitted Data (TX) 4 unused 5 Signal Ground 6 unused 7 unused 8 unused 9 unused Null-modem cable (used to connect the projector to a computer) RX 2 --- 3 TX TX 3 --- 2 RX GND 5 --- 5 GND Serial port settings Baud rate 19,200 bps Data length 8 bits Stop bits one Parity none Flow control none • • • • • Notes The projector is a DTE, so use: a straight...
Page 115
July 2007 Page 7.15 Digital Projection TITAN 1080p-500, 1080p-250 User Manual 7. Appendix Remote communications protocol Version: Revision C 02/01/07 Introduction This protocol document covers all projectors in the Titan series and also the Lightning 30/40isx+. Only one remote connection (RS232, LAN or Wireless LAN) should be used at any one time. Following the transmission of a command, the control system must wait to receive the complete reply before sending a new command. It should be noted that...
Page 116
Page 7.16 July 2007 7. Appendix Digital Projection TITAN 1080p-500, 1080p-250 User Manual Operation Messages Operation messages are constructed using the following format: Header Type Size CRC Oper’n typeOperation Reserved 2 bytes 1 byte 2 bytes 2 bytes 1 byte 2 bytes 2 bytes Data BE EF 03 19 00 58 58 00 00 00 00 00 Byte # 1 2 3456789101112 Operation Target Operation Value Reserved 4 bytes 4 bytes 4 bytes Data 00 00 00 00 00 00 00 00 00 00 00 00 Byte # 13 14 15 16 17 18 19 20 21 22 23 24 Reserved...
Page 117
July 2007 Page 7.17 Digital Projection TITAN 1080p-500, 1080p-250 User Manual 7. Appendix Notes The following pages contain examples of some basic Operation commands. For full details of all the For full details of all the Operation commands and Enhanced commands, contact Digital Projection and ask for a copy of the Titan Projector Series External Control Protocol. Enhanced Messages Enhanced messages are constructed using the following format: Header Type Size CRC Data type Data length (n) 2...
Page 118
Page 7.18 July 2007 7. Appendix Digital Projection TITAN 1080p-500, 1080p-250 User Manual Operation Command examples All operation commands are located at bytes 9 &10. All values are located at bytes 17 & 18 unless otherwise indicated Power (0102) Projector On or Standby Value On 00h Standby 04h Examples Set Projector (On) BEEF 03 1900 5858 01 0102 0000 00000000 00000000 00000000 00000000 00000000 Response 1E BEEF 03 1900 5858 01 0102 0000 00000000 00000000 00000000 00000000...
Page 119
July 2007 Page 7.19 Digital Projection TITAN 1080p-500, 1080p-250 User Manual 7. Appendix Source (3702) Projector source select Value RGB1 00h RGB2 01h DVI 02h SDI 03h (not used on this projector) Composite 04h SVideo 05h Component 06h Examples Set Source (DVI) BEEF 03 1900 5858 01 3702 0000 00000000 02000000 00000000 00000000 00000000 Response 1E BEEF 03 1900 5858 01 3702 0000 00000000 02000000 00000000 00000000 00000000 Set Source (SVideo) BEEF 03 1900 5858 01...
Page 120
Page 7.20 July 2007 7. Appendix Digital Projection TITAN 1080p-500, 1080p-250 User Manual Brightness (E502) Adjusts Brightness Range: -128 — +127 (00h - FFh) Centre (0): 128 (80h) Examples Set Brightness 97 (128 + 97 = 225 = E1h) BEEF 03 1900 5858 01 E502 0000 00000000 E1000000 00000000 00000000 00000000 Response 1E BEEF 03 1900 5858 01 E502 0000 00000000 E1000000 00000000 00000000 00000000 Get Brightness BEEF 03 1900 5858 02 E502 0000 00000000 00000000 00000000...