Dell 3008wfp Users Guide

   
After you have completed connecting the DVI/VGA/DisplayPort cable, follow the procedure below to connect the USB cable to the computer and complete your 
monitor setup:  
l Connect the upstream USB port (cable supplied) to an appropriate USB port on your computer.   
l Connect USB peripherals to the downstream USB ports (rear or side) on the monitor. (See  rear  or  side  view for details.)   
l Plug the power cables for your computer and monitor into a nearby outlet.   
l Turn on the monitor and the...

 
Attaching the Stand  
 
 
Place the s tand  on a flat surface and  follow these steps to attach the monitor stand:  1. Remove the four screws from the stand. 
2.   Remove the stand by lifting it straight up and away from the monitor. 
1. Fit the groove on the back of the monitor to the two tabs on the upper part of the stand.  

Back to Contents Page  
    2.   Lower the monitor so that the monitor mounting area snaps on to or locks on to the stand and tighten up the bolts as indicated.  

Back to Contents Page    
 
Solving Problems    
 
   Monitor Specific Troubleshooting  
   Common Problems  
   Video Problems  
   Product Specific Problems  
   Universal Serial Bus Specific Problems  
   Troubleshooting the Dell™ Soundbar  
   Troubleshooting the Card Reader   
   
Monitor Specific Troubleshooting  
Self - Test Feature Check  
Your monitor provides a self - test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly...

Video Problems  
Product Specific Problems  spots l Pixel that is permanently off is a natural defect that can occur in LCD technology.   
Stuck - on Pixels LCD screen has 
bright spots l Cycle power on - off.  
l Pixel that is permanently off is a natural defect that can occur in LCD technology.   
Brightness Problems Picture too dim or 
too bright l Reset the monitor to Factory Settings.  
l Auto Adjust via OSD.  
l Adjust brightness & contrast controls via OSD.   
Geometric Distortion Screen not...

Universal Serial Bus (USB) Specific Problems  
   
 Cannot adjust the monitor 
with the buttons on the 
front panel OSD does not appear on the screen l Turn off the monitor, unplug the power cord, plug back, and then turn on the 
monitor.   
The monitor will not go 
into power saving mode. No picture, the LED light is blue. When 
press  “ + ” ,  “ - ”   or  “ Menu ”   key, the message  “  
No S - Video input signal  ” ,  “   No Composite 
input signal  ”    or  “   No Component input 
signal  ”   appears...

 
Back to Contents Page   l Troubleshoot the computers sound card.   
l Test the Soundbar using another audio source (For example: portable CD player, MP3 
player).   
Low Volume Volume is too low l Clear any obstructions between the Soundbar and the user.   
l Turn the Power/Volume knob on the Soundbar clockwise to the maximum volume 
setting.   
l Set all Windows volume controls to their maximum.   
l Increase the volume of the audio application.   
l Test the Soundbar using another audio source (For...