compaq lte elite User Manual

9. While holding the eject override mechanism in the released position,
press the computer slightly toward the rear of the expansion base.
10. Remove the tool from the override mechanism slot.
11. Remove the computer.
12. Slide the expansion base fully onto the table.
13. Remove the computer, being careful not to lift up on it until it is
fully removed from the expansion base.
NOTE: If the computer does not eject using the manual eject override
method, the docking mechanism may have to be removed...

To install the upgrade adapter on the Compaq LTE Lite Desktop Expansion
Base, complete the following steps:
1. Turn off the expansion base.
2. Remove the Compaq LTE Lite monitor support cover and extender panel if
installed.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>>

NOTE: The upgrade adapter must be removed from the Compaq LTE Lite Desktop
Expansion Base when docking the Compaq LTE Lite. To remove the
upgrade adapter, simultaneously press the release buttons on the rear
of both side rails of the adapter while pulling the adapter forward
to disconnect the 198-pin external options connector.
Docking the Computer
To dock the Compaq LTE Elite in the Compaq LTE Lite Desktop Expansion Base,
complete the following steps:
1. Install the upgrade adapter on the expansion base...

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>>>>

10. Turn on external devices that are connected to the expansion base.
11. Turn the system on with the power button on the expansion base.
NOTE: The first time you dock the computer in the expansion base or
when you install new devices, the system detects a configuration
change and may prompt you to run Computer Setup. Refer to
Section 6.7 for more information on running Computer Setup.
IMPORTANT: Do not undock from the expansion base before reading the
next section, Undocking the Computer.
Undocking the...

1. Remove any cable or card that does not allow the PCMCIA door to fully
close.
2. Save and close all open files.
3. Turn off the system by pressing the expansion base power button.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

D.3 Docking The Compaq LTE ELITE In The Compaq Ministation 
NOTE:The Compaq LTE Lite Family of Personal Computers cannot dock in the
Compaq MiniStation/EN or the Compaq MiniStation/TR convenience base.
Docking the Computer
To dock the Compaq LTE Elite in the Compaq MiniStation/EN or the Compaq
MiniStation/TR convenience base, complete the following steps:
1. Connect the convenience base to an electrical outlet.
2. Turn off and disconnect any external devices that are connected to the
computer....

the front of the convenience base to the fully forward position
(Figure D-14).
8. Place the computer on the convenience base guide rails and slide it
toward the back until you feel a slight resistance (Figure D-15). 

9. Push the lever toward the back of the convenience base (Figure D-16). 

10. Turn on the external devices that are connected to the convenience
base.
11. Turn on the system, using either the convenience base power button [1]
or the computer power switch [2] (Figure D-17).