compaq lte elite User Manual
Here you can view all the pages of manual compaq lte elite User Manual. The Compaq manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 311
9. Remove the docking mechanism (Section 9.12). 10. Remove the system board/battery charging compartment assembly (Section 9.13).
Page 312
Chapter 10 - Compaq SmartStation Specifications Introduction This chapter covers the following specifications of the Compaq SmartStation expansion base: o Physical and environmental o Power supply o Compaq Ethernet 16E controller o IEEE 802.3 Ethernet standards o SCSI-2 controller 10.1 Physical and Enviromental ========================================================================== U.S. Metric =========================================================================== Dimensions Height: From base...
Page 313
Nonoperating .50G --------------------------------------------------------------------------- Maximum Heat Output (calculated) 676 BTU/hr 198W --------------------------------------------------------------------------- Maximum Drive Bay Length: (both drive positions) 8.5 in 21.59 cm --------------------------------------------------------------------------- Monitor Support Monitor support cover supports a monitor weighing up to: 55 lb 25 kg...
Page 314
--------------------------------------------------------------------------- Transfer Width 16-bit --------------------------------------------------------------------------- Worst-Case Power Consumption:AUI Connector 500 mA @ +12V RJ-45 Connector 0 mA @ +12V * --------------------------------------------------------------------------- * When the RJ-45 connector is used, the controller does not consume any power at +12V. It passes +12V through to power any external transceiver connected to the AUI...
Page 315
Appendix A - Connector Pin Assignments Introduction This appendix provides connector pin assignment tables for the Compaq LTE Elite and the SmartStation expansion base. For more information on connectors, refer to Section 1.5 for connectors located on the computer and to Section 6.5 for connectors located on the expansion base. NOTE: The signals in all tables of this appendix are considered active high unless otherwise indicated by an asterisk (*). A.1 Connector Pin Assignments Table A-1. Parallel...
Page 316
3 Data Bit 1 16 Initialize Printer * 4 Data Bit 2 17 Select In * 5 Data Bit 3 18 Ground 6 Data Bit 4 19 Ground 7 Data Bit 5 20 Ground 8 Data Bit 6 21 Ground 9 Data Bit 7 22 Ground 10 Acknowledge * 23 Ground 11 Busy 24 Ground 12 Paper Out 25 Ground 13 Select Shell Ground =========================================================================== Table A-2. Serial Connector =========================================================================== Pin Signal Pin Signal...
Page 317
Table A-3. External Monitor Connector =========================================================================== Pin Signal Pin Signal =========================================================================== 1 Red Analog 9 Not connected 2 Green Analog 10 Ground 3 Blue Analog 11 Not connected 4 Not connected 12 Not connected 5 Ground 13 Horizontal Sync 6 Ground Analog 14 Vertical Sync 7 Ground Analog 15 Not connected 8 Ground Analog Shell Ground...
Page 318
Table A-4. Keyboard/Mouse Connector =========================================================================== Pin Signal Pin Signal =========================================================================== 1 Data 4 +5V 2 Reserved 5 Clock 3 Ground 6 Reserved Shield Ground ===========================================================================
Page 319
Table A-5. Compaq LTE Elite Numeric Keypad Connector =========================================================================== Pin Signal Pin Signal =========================================================================== Ring Ground Tip Data/Power ===========================================================================
Page 320
Table A-6. Compaq LTE Elite 198-Pin External Options Connector =========================================================================== Pin Signal Pin Signal =========================================================================== 1 Printer Select 100 +5V Fused (computer) 2 Printer Busy 101 Printer Auto Line Feed * 3 Printer Data Bit 7 102 Printer Error * 4 Printer Data Bit 5 103 Ground 5 Ground 104 Printer Initialize * 6 Printer Data Bit 3 105 Diskette Write Gate * 7 Printer Data Bit 1 106...