Christie Projector Roadster, Matrix WU, Mirage S+/HD/WU User Manual

 Operation 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 3-7 020-100002-05 Rev. 1 (02-2010) 
the shutter
  Press OSD  to turn OffUse to
 
Figure 3.4. “Brick” Rental Staging – Standard IR Remote 
 
 
1) 
Press keys one-at-a-time; there are no simultaneous key combinations required. 
2) Note that three keys—Power, Shutter and OSD—press key once, refer to Figure 
3.3 Remote Keypad 
3) Hold arrow keys down for continuous adjustment/movement in one direction. In 
serial networks, pause briefly between...

Operation  
3-8 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010)   
Specific keypad commands are explained below: 
Power ON/OFF 
Press and hold 
 briefly to toggle the projector on or off with a single keystroke or 
press twice. Or press and release 
 followed immediately by  (on) or  
(off) to guarantee the correct toggle (useful if you are unsure of the present state). 
NOTES: 1) After powering down, the lamp cooling fan remains on for 
approximately 5 minutes to cool...

 Operation 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 3-9 020-100002-05 Rev. 1 (02-2010)  
Channel 
Press 
Channel to select a specific source setup (channel) defined and stored in projector 
memory. Once you enter a two-digit channel number (or, if there is a list displayed, 
highlight it and press
), the display will automatically change and update 
according to the numerous setup parameters defined for that channel. Note that a new 
channel is automatically created if you adjust an image from a...

Operation  
3-10 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010)   
Input 6 
Press
Inpu t  6 to display from the INPUT 6 interface module installed in the Option 2. If 
PIP is enabled, pressing this key changes the PIP source. If there are two inputs 
connected here, such as if the Dual SD/HD-SDI module is installed, the second input 
(B) is considered 
INPUT 8. If you are using the built-in keypad or the remote keypad, 
press 
INPUT 6 to access INPUT 8as follows: 
...

 Operation 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 3-11 020-100002-05 Rev. 1 (02-2010)  
Gamma 
NOTE: This is the same as “Gamma” in the Image Settings Menu.  
“Gamma” determines how gray shades are displayed between minimum input (black) 
and maximum input (white) for a given amount of signal. The proper setting helps 
maintain optimized blacks and whites while ensuring a smooth transition for the “in-
between” values utilized in grays. Unlike brightness and contrast controls, the overall...

Operation  
3-12 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010) 
Shutter  
Press and hold
 Shutter briefly to toggle the internal mechanical shutter blade closed or 
open with a single keystroke. Or press and release 
Shutter followed immediately by 
 (shutter on; closed) or  (shutter off; open) to guarantee the correct toggle 
(useful if you are unsure of the present state). Alternatively, press 
Shutter Shutter to toggle 
from the present on/off state. A closed shutter...

 Operation 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 3-13 020-100002-05 Rev. 1 (02-2010) 
NOTE:  The “Broadcast Keys” option in the Communications menu must be 
selected for only one (any) projector in a serial network. The keypad in use must be 
OFF (disabled) for the remaining projectors. Refer to 2.11 Keypad Protocols and 
Conversion, and 3.7, Adjusting System Parameters and Advanced Controls. 
Enter 
Press 
 to select a highlighted item, to toggle a checkbox, or to accept a parameter...

Operation  
3-14 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010) 
 
Most of the controls for the projector 
are accessed from within the 
projector’s menu system. There are 
several groups of related functions, 
with each group selectable from the 
Main menu as shown at right. Press 
Menu at any time to display this Main 
menu. See Figure 3.5. 
On the remote keypad, either enter 
the number corresponding to the 
function menu you wish to access, such as 
2 for the Image...

 Operation 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 3-15 020-100002-05 Rev. 1 (02-2010) 
 
Figure 3.7. Accessing General Help Topics  
If a slidebar, menu, or message is displayed, you have limited time in which to make 
a keypad entry before the projector returns to presentation level
Hel p and the graphic 
disappears. These time-outs may vary depending on what is displayed. 
Menu options that include this icon apply universally to any incoming signal. 
 
Menu options that include this icon...

Operation  
3-16 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010)  “Direct” slidebars -
 For quick access, you access Gamma, Brightness, and Contrast 
slidebars without traveling the menu system. For example, simply press 
Co n t to 
immediately display the same contrast slidebar accessed with the 
Contrast option in 
the Image Settings menu. 
Use the arrow keys to adjust a direct slidebar, or press 
 and enter a specific 
number from the keypad, then 
 or  or  to save (or...