Christie Projector Roadster, Matrix WU, Mirage S+/HD/WU User Manual

 Installation & Setup 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 2-31 020-100002-05 Rev. 1 (02-2010) 
In addition, the rental staging keypad typically used with Roadsters can operate under 
a variety of different IR protocols, useful in multiple-projector sites where you prefer 
the tether-less freedom of controlling many adjacent projectors independently. When 
Keypad A operates under a different protocol than Keypad B (or others), each keypad 
communicates only with the projector(s) having a...

Installation & Setup  
2-32 Roadster, Matrix WU, Mirage S+/HD/WU User Manual   020-100002-05 Rev. 1 (02-2010) 
Step 2 
Find the four jumpers located along the latching side of the battery compartment. 
These jumper settings establish the remote keypad protocol so that the remote 
functions in a certain manner. 
Step 3: Set the Jumpers 
Set the jumpers to match one of the protocols shown in Figure 2.42. Use tweezers or 
needle-nose pliers to remove and replace each jumper as necessary. 
 J1 jumper: Set...

 Installation & Setup 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 2-33 020-100002-05 Rev. 1 (02-2010) 
TO CHANGE FROM INFRARED TO WIRED: 
1. Remove battery compartment cover from back of keypad. 
2. Remove batteries. 
3. Wait 1-2 minutes. Meanwhile, notch the battery cover to create an exit hole for 
the cable. Ensure the hole is smooth and will accommodate the cable without 
pinching. 
4. Plug the keypad cable (supplied) into the empty battery compartment—ensure 
the connector is oriented...

Section 3 
Operation 
 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 3-1 020-100002-05 Rev. 1 (02-2010) 
 
This section explains how to use the projector once it has been installed. Please read 
through these pages before using the projector for the first time. An understanding of 
projector features and how to access them will help you to take full advantage of the 
capabilities of the projector within minutes. 
NOTE: Installation involves locating the projector and adjusting it for use at that...

Operation  
3-2 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010) 
Operated with the keypad, vertical and horizontal offsets shift the lens and move the 
image up or down and left or right. Refer to Section 2, Installation and Setup and 
Section 6, Specifications for ranges and other details. 
Operated with the keypad, closing the internal shutter blocks the lens internally and 
turns the image to off (black). Enlarge the diameter of the iris—a.k.a. optical 
aperture—for...

 Operation 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 3-3 020-100002-05 Rev. 1 (02-2010) 
 
 AC LINE CORD INPUT - Use the AC supply specified, and always use the line cord 
recommended by Christie. Refer to Section 5. Before unplugging, wait until the main 
blower turns off or the LCD status reads Power Off. 
Model AC Power Specifications 
Roadster S+12K/HD12K  200-240 VAC, 50-60 Hz, max. 12 amps @ 200VAC 
Matrix WU12  200-240 VAC, 50-60 Hz, max. 12 amps @ 200VAC 
Mirage HD12  200-240 VAC, 50-60...

Operation  
3-4 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010) 
BUILT-IN KEYPAD - Alternative location for working with the projector. 
INFRARED SENSORS - The infrared (IR) sensors on the front and rear of the projector 
receive infrared signals from the IR keypad for remote control of projector functions. 
For proper operation, ensure these sensors are not blocked. 
  Laser radiation is emitted from the laser diode in the remote. Do not look 
directly into the beam of...

 Operation 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual 3-5 020-100002-05 Rev. 1 (02-2010) 
Note: N/A on WU Models
 
Figure 3.3. Remote Keypad 
               IR Remote   

Operation  
3-6 Roadster, Matrix WU, Mirage S+/HD/WU User Manual  020-100002-05 Rev. 1 (02-2010) 
The IR remote keypad controls the projector by way of wireless communications 
from a battery-powered infrared (IR) transmitter. Use the IR remote keypad the same 
way you would use a remote keypad supplied with a TV or VCR. When making key 
presses, direct the keypad either toward the screen or toward the front or rear of the 
projector. One of the two IR sensors on the projector will detect the signals and...