Home > Christie Digital Systems > Projector > Christie Digital Systems Ds+60 Users Manual

Christie Digital Systems Ds+60 Users Manual

Here you can view all the pages of manual Christie Digital Systems Ds+60 Users Manual. The Christie Digital Systems manuals for Projector are available online for free. You can easily download all the documents as PDF.

Page 91

Section 4: Maintenance  
 
Christie DS+60 User’s Manual     4-7  
 
Figure 4.4. 
6.  Discard the lamp using approved disposal methods for your area. NOTE: Lamps 
containing mercury must be treated as hazardous waste if discarded in large 
volumes.  
 WARNING 
Do not stick hands into an empty lamp compartment, 
especially if the other lamp is still on. The lamp 
compartment can become quite hot and cause physical 
injury. 
7.  On the new lamp module, turn the 
three lock screws to the “unlock” 
position...

Page 92

Section 4: Maintenance  
4-8   Christie DS+60 User’s Manual  
 
Use the following instructions when replacing a projection lens: 
NOTE for first time use: The projection lens is shipped separately from the 
projector. Before you install a lens it is important to remove the lens plug from the 
lens opening in the projector and the protective end cap from the lens.  
1.  Power down the projector and wait 5 minutes to allow the lamps to cool before 
continuing with Step 2.  
2.  Place the lens cap on the...

Page 93

Section 5 
Troubleshooting  
 
Christie DS+60 User’s Manual     5-1 
 
If the projector does not appear to be operating properly, note the symptoms present and use the following guide to 
assist you. If you cannot resolve the problems yourself, contact your dealer for assistance. 
NOTE: A qualified service technician
 is required when opening the projector to diagnose any “probable cause”. 
 
 
 
 
The projector is on but there’s no display... 
1.  Was a lens cover accidentally left on? Remove lens...

Page 94

Section 5: Troubleshooting 
5-2     Christie DS+60 User’s Manual      
The display is faint… 
1.  Brightness and/or contrast may be set very low. 
2.  The source may be double terminated. Ensure the source is terminated only once. 
3.  The source (if non-video) may need a different sync tip clamp location. 
The upper portion of the display is waving, tearing or jittering… 
1.  This can sometimes occur with video or VCR sources. Check your source. 
Portions of the display are cut off or wrap to the...

Page 95

Section 5: Troubleshooting 
 
   Christie DS+60 User’s Manual     5-3  
2.  The video input may not be terminated. Make sure the video input is terminated 
(75 
Ω). If it is the last connection in a loop-through chain, the video input should 
be terminated at the last source input only. 
3.  The input signal and/or signal cables carrying the input signal may be of poor 
quality. 
4.  If the distance between the input source device and the projector is greater than 25 
feet, signal...

Page 96


				            

Page 97

Section 6 
Specifications 
 
     Christie DS+60 User’s Manual     6-1 
 
NOTES: 1) Due to continuing research, specifications are subject to change without notice. 2) 
Specifications apply to all models unless otherwise noted. 
 
 
Resolution 
SXGA+ (1400 x 1050) 
Brightness (typical) 
Dual Lamp (White Boost ON)  6000 ANSI lumens 
Dual Lamp (White Boost OFF)  3500 ANSI lumens 
Single Lamp (White Boost ON)  3050 ANSI lumens 
Single Lamp (White Boost OFF)  1800 ANSI lumens 
 
Contrast Ratio 
DS+60...

Page 98

Section 6: Specifications 
6-2     Christie DS+60 User’s Manual      
Analog RGB or YPrPb (Interlaced or Progressive Scan Format) 
Horizontal Frequency Range  15 – 120 kHz 
Vertical Frequency Range (See Note 1)  23.97 – 150 Hz 
Pixel Clock Rate  13-210 MHz max 
Signal Format 
Input Levels   R, G, B, - with sync:  1.0V
p-p ±2dB 
      R, G, B, - without sync:  0.7V
p-p ±2dB 
     Pb, Pr  0.7
p-p ±2dB 
DC Offset ±2V 
Nominal Impedance  75 ohms 
Note 1: Value specifies frame rate of non-interlaced sources...

Page 99

Section 6: Specifications 
 
   Christie DS+60 User’s Manual     6-3  
DVI-I – Digital  
Input Characteristics  meets DVI spec 
DVI Cable Length  5m 
EDID   Supported 
HDCP (High Speed Digital Content Protection)  Supported 
RS-232 Serial Input 
Connector Type  1 male DB9 (RS-232 out) 
    1 female DB9 (RS-232 in) 
RS-422 Serial Input 
Connector Type  1 female DB9 connector  
Network Control 
Ethernet  1 RJ45 connector 
Max. Baud Rate  115200 
Remote Control 
Type  IR with wired ability 
Range 30 meters...

Page 100

Section 6: Specifications 
6-4     Christie DS+60 User’s Manual      
 
 
Dimensions (L x W x H) 374mm x 510mm x 256mm 
  14.7” x 20.1” x 10.1”  
Weight 36 lbs 
 
CAN/CSA  C22.2  No. 60950-00 
ANSI/UL 60950 3
rd Edition 
EN60950, 2000   European Norm, Safety of Information Technology Equipment 
China Compulsory Certificate  (CCC) 
FDA 
 
Emissions 
FCC Code of Federal Regulations, Title 47, Part 15, Conducted and Radiated 
Emissions, Class A 
EN55022 (CISPR 22) for Information Technology Equipment,...
Start reading Christie Digital Systems Ds+60 Users Manual

Related Manuals for Christie Digital Systems Ds+60 Users Manual

All Christie Digital Systems manuals