Canon scanner CanoScan FB 1200S User Manual

61
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
3. Attach the ADF connector cable to the ADF connector on the option cables
connector block.
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
4. Attach the power cord to the option cable AC adapter.
ADF Connector Cable
Option Cable AC Adapter
Power Cord 

62
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
5. Plug the power cord into an electrical outlet.
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
6. Plug the scanners power cord into an electrical outlet.
ADFScanner 

63
Loading Documents
Observe the following precautions when loading documents into the ADF.
WARNING¥ The maximum stack of documents that can be loaded into the ADF at one time is
indicated by the stack mark on the inner side of the paper guide. The ADF can
accommodate up to 20 sheets of standard copy paper or a stack of documents no higher
than 2 mm. Loading stacks higher than this may result in paper jams.
¥ Uncurl or straighten any documents that are curled or wrinkled....

64
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
2. Push the left edge of the document stack flush against the paper guide
and as far under the ADF cover as possible.
¥ If the document is a standard size, align its top corner with the corresponding paper
alignment mark on the document tray.
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
3. Slide the movable paper guide lightly against the side of the stack.
¥ Shift the movable paper guide snugly up against the stack, but not so tightly that it...

65
No tears
No punched holesNo staples or paperclips
Acceptable Media
The ADF can feed media falling within the following parameters.
¥ Standard paper sizes: B5, A4, Letter, Legal
Width: 182-216 mm (7.2-8.5 in.) / Length: 257-356 mm (10.1-14.0 in)
¥ Standard paper weights: 60-105 g/m
2 (16-28 lb.)
The following can cause paper jams and should be avoided.
¥ papers with weights higher or lower than the range given above
¥ non-rectangular media with irregular shapes
¥ specialty paper for color printers,...

66
5 mm30 ˚
ABC
WARNING¥ Scan valuable or single-copy documents using the document glass, not the ADF, to avoid
the risk of damaging the original in a paper jam.
¥ The allowable curl on papers fed by the ADF is shown below. Do not use the ADF for
papers with curls exceeding 30û.
To scan photographs, books and papers not suited for the ADF, lift up the ADF on its hinges,
position the item directly on the document glass and close the ADF. Then initiate the scan.
a a a...

67
Software Settings
Follow the procedures below to set the software to scan documents loaded into the ADF. The settings
may differ between software programs.
NOTE¥ The ADF can be used to scan at resolutions up to 600 dpi.
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
1. Start ScanGear CS-S.
¥ For instructions, see the Getting Started guide (p. 29).
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
2. Click the [FB1200S] tab.
Windows 

68
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
3. Click the arrow of the [Image Source] list box and select [Document
Feeder].
This is all that is required to set the scanner to choose the ADF as the document source.
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
4. Load documents into the ADF and click the [Preview] button.
The first document will feed into the scanner and the preview image will begin to appear
in the ScanGear CS-S window.
¥ 
The final scan is initiated in a later step. For...

69
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
1. Start Plug-in Module CS-S.
¥ For instructions, see the Getting Started guide (p. 41).
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
2. Open the [Preferences] menu and select [Auto document feeder].
This is all that is required to set the scanner to choose the ADF as the document source.
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
3. Load documents into the ADF and click the [Preview] button.
The first document will feed into the scanner...

70
Paper Jams
Use the following procedures to clear paper jams where they occur in the ADF.
Jams in the Document Tray
1. Lift the ADF cover.
2. Remove the jammed document by pulling it forward.