Canon Projector WUX450 User Manual

271
Using Layout Functions
Networked Multi-Projection
Functions in All Modes
Similarly, computers leaving a session are removed from the list of computers. 

272
Completing Application Projection Settings
Application settings can be configured to specify the image quality of computer 
projection, user nicknames, and other details.
1Click   next to the computer icon.
2The settings window is displayed. Complete each setting as needed, and 
then click [OK].
Available settings are as follows. (Types of settings vary slightly by mode.)
When setting windows are displayed while layout windows are minimized to the taskbar, 
some information may be cut off. 

273
Completing Application Projection Settings
Networked Multi-Projection
Functions in All Modes
Picture qual settingSelect one of the following options, depending on your 
preferred image quality and frame rate.
High : Projects at a lower frame rate while 
emphasizing image quality. Select this 
mode if lower image quality is not 
acceptable.
Medium : Projection with image quality and frame 
rate balanced.
Low : Projects at lower image quality to maintain 
a high frame rate. Select this mode to 
reduce...

274
Reducing Windows to a Compact Size
A compact version of windows in all modes is available, showing only the minimum 
buttons and information needed.
1Click .
The window is now reduced to a compact size.
2To revert to original size, click  .
The title bar is no longer displayed when the cursor is away from the window, which 
makes the window even more compact. 

275
Networked Multi-Projection
Functions in All Modes
Tips for Better Networked Projection
■Avoid Exceeding Connection Limits
The maximum number of computers and projectors that can be connected varies 
by mode. When this limit would be exceeded, it is not possible to add computers or 
projectors to a session. Thus, if the total number of computer users requesting to 
join a session at the same time would exceed the limit, their requests may be 
denied. In this case, an error message is displayed on the...

276
Restrictions
■Router Connections
Although the application can also link computers and projectors over a network via 
a router, operation is only ensured over one router hop. Note that before projecting 
from projectors in other subnets in Broadcast Mode, you must configure the router’s 
multicast routing settings. For details, ask your network administrator.
■Security Dialog Box Projection
The application cannot be used to project the Windows Security dialog box, 
normally accessed by pressing...

277
MULTIMEDIA PROJECTOR
Appendix 

278 

279
Table of Contents
Safety Instructions
Before Use
Operation
Projecting an Image
Useful Functions Available 
During a Presentation
Setting Functions from 
Menus
Installation and Maintenance
Installation
Connecting to a Network
Maintenance
Networked Multi-Projection
Networked Multi-Projection 
Overview
Operation in Each Mode
Functions in All Modes
AppendixOther Information
Index
Appendix 

280
Troubleshooting
LED Indicator Meanings
When there is a problem with the projector, the LED indicator on the side of the 
projector illuminates or flashes continuously after the projector is turned off.
• Wait until the cooling fan stops and disconnect the power plug from the electrical outlet before 
dealing with the problem.
LED indicator 
statusMeaning Countermeasure
WARNING and 
TEMP are lit.Temperature 
abnormalityThe temperature inside the projector is too high 
for some reason or the outside...