Canon printer FAXPHONE L80 User Manual

Chapter 12 Maintenance12-1
Maintenance
Chapter 12
Maintenance
This chapter describes the steps you need to follow to keep your machine clean. You
will also find instructions for replacing the cartridge.
P eriodic Cleaning........................................................................\
...........12-2
Cleaning the Machine’s Exterior...........................................................12-2
Cleaning the Machine’s Interior ............................................................12-2...

12-2Maintenance Chapter 12
Periodic Cleaning
This section describes the necessary cleaning procedures for your machine. Please
note the following before cleaning your machine:
•Be sure to disconnect the power cord before cleaning the machine. Since documents
in memory are erased when the power is disconnected, print or send any documents
stored in memory before disconnecting the power cord (1
p.9-4).
•Do not use tissue paper, paper towels, or similar materials for cleaning; they can stick
to the...

Chapter 12 Maintenance12-3
Maintenance
3Hold the cartridge by its handle
and remove it from the machine.
•To avoid exposing the cartridge to light,
place it in its protective bag or wrap it in
a thick cloth.
4Use a clean, soft, dry, lint-free cloth to 
remove any toner or paper debris from
the machine’s interior (shaded area in
the illustration).
c
•The fixing assembly becomes
extremely hot when the machine
is in use. Be very careful not to
touch it so as to avoid injury.
•Be careful not to touch the...

12-4Maintenance Chapter 12
6Use both hands to close the front cover.
7Reconnect the power cord. 

Chapter 12 Maintenance12-5
Maintenance
Cleaning the Scanner Components
Follow this procedure to periodically check and clean the scanner components:
1Disconnect the power cord from the machine.
2Use both hands to gently open the
operation panel.
•It only opens partially.
3While holding the operation panel
open, clean these components:
❚Separation guide and separation
roller:
Wipe with a clean, soft, dry, lint-free
cloth.
❚White sheet and scanning glass:
Wipe with a clean, soft, lint-free cloth
moistened...

12-6Maintenance Chapter 12
5Use a clean, soft, dry, lint-free cloth
to wipe any paper dust from the areas
surrounding the separation roller
(shaded area in the illustration).
6When you are finished, close the
operation panel by pressing it down
from the center.
•Be sure to close the operation panel
until it locks into place, or the machine
will not function properly.
7Reconnect the power cord.
SEPARATION 
ROLLER 

Chapter 12 Maintenance12-7
Maintenance
Replacing the FX-3 Cartridge
The only component of your machine you will need to replace is the FX-3 cartridge. The
FX-3 S Cartridge is a starter cartridge that comes with your machine, and yields
approximately 1,500 pages based on 5% coverage of an A4 size page. The
replacement FX-3 cartridge yields approximately 2,700 pages based on 5% coverage
of an A4 size page. To purchase this cartridge, contact the Canon Customer Care
Center, or your business machine...

12-8Maintenance Chapter 12
4Hold the cartridge by its handle
and remove it from the machine.
•Discard the old cartridge immediately
according to the local laws and
regulations for disposal of consumables.
To  recycle your used cartridge, simply
fo llow the instructions included with your
new FX-3 cartridge.
5 Remove the new FX-3 cartridge from
its protective bag.
•S ave the protective bag in case you
need to repack the cartridge at a later
date.
6Gently rock the cartridge from 
side to side a few times...

Chapter 12 Maintenance12-9
Maintenance
8Hold the cartridge by its handle and 
insert it into the machine as far as it will
go, making sure that its tabs are aligned
with the rails inside the machine.
•Always hold the cartridge by its handle.
9Use both hands to close the front cover. 

12-10Maintenance Chapter 12