Canon Pixma Mx922 User Guide

Shipping the Bluetooth Unit
The Bluetooth unit may not be used in countries or regions other than the country or region where it was
purchased due to local laws and regulations. Please note that the use of the Bluetooth unit in such countries or regions may lead to penalties and that Canon should not be liable for such punishment.
 

Preparation to Use the Bluetooth Unit
 Bluetooth Unit
 Attaching to and Removing from the Printer
 

Bluetooth Unit
The Bluetooth Unit BU-30 (hereafter referred to as the Bluetooth unit) is an adaptor which can be used with
a Canon IJ printer with Bluetooth interface.
By attaching the Bluetooth unit to a Canon IJ printer with Bluetooth interface, wireless printing from a Bluetooth enabled device, such as a computer or mobile phone, is possible.
Note
Communication is possible in a range of up to about 33 ft. / 10 m depending on the conditions below.
Printing speed may vary depending on the following...

Attaching to and Removing from the Printer
Attaching the Bluetooth Unit to the Printer
Removing the Bluetooth Unit from the Printer
Attaching the Bluetooth Unit to the Printer
Attach the Bluetooth unit to the USB flash drive port of the printer in accordance with the following procedure.
Refer to Front View for the position of the USB flash drive port.
1.
Make sure that the printer is turned on.
Confirming that the Power Is On
2.
Insert the Bluetooth unit to the USB flash drive port of the printer....

Make sure that the lamp on the Bluetooth unit is neither lit nor flashing before you remove the
Bluetooth unit.
Important
Store the Bluetooth unit with the cap attached.
 

Printing Data via Bluetooth Communication
 Preparation
 Installing the MP Drivers
 Checking the Device Name of the Printer
 Registering the Printer
 Deleting the Printer
 

PreparationIn order to print via Bluetooth communication with Windows, the following system requirements must besatisfied.
•
Computer
A computer in which an internal Bluetooth module is installed or a computer to which an optional
Bluetooth adapter (available from various manufacturers) is attached.
•
OS
Microsoft Windows 7 (Satisfying any one of the following conditions is needed)
•
Add a Bluetooth Device is displayed in Hardware and Sound under Control Panel
•
Bluetooth Stack for Windows by Toshiba...

•When using Windows XP SP2 or later, and when Bluetooth Devices is displayed
in Printers and Other Hardware under Control Panel
Authenticate the printer as a Bluetooth device on  Bluetooth Devices in Printers and Other
Hardware  under Control Panel .
See  Registering the Printer .•
The operations may vary depending on your operating program. In this case,
refer to your computers operation manual.
 

Installing the MP Drivers
Note
If you use the printer connecting with a computer, the MP Drivers have already been installed. In this
case, move to the next step.
Checking the Device Name of the Printer
Before connecting the Bluetooth unit to the printer for wireless printing, install the MP Drivers to your computer.
If you reinstall the MP Drivers, reinstall the MP Drivers using the Setup CD-ROM.
 

Checking the Device Name of the Printer
This section describes the procedures for checking the settings of the Bluetooth unit on the LCD of the printer in preparation for Bluetooth printing.
Canon IJ printers with the Bluetooth interface are divided into two types. One is equipped with a graphicLCD, and the other with a text LCD.
If you need more information about the Bluetooth settings, see  Setting Bluetooth Printing.
1.
Make sure that the printer is turned on.
Confirming that the Power Is On
2.
Attach...