Canon Lv-7265, Lv-7260, Lv-x7 Multimedia Projector Users Manual

62
7.  A p p e n d i x
If there is no picture, or the picture is not displayed correctly.
•  Power on process for the projector and the PC.
  Be sure to connect the VGA cable between the projector and the computer before turning on the computer. 
There are some notebook PCs, which do not output signal unless there is a projector or monitor connected 
fi r s t .
NOTE: You can check the horizontal frequency of the current signal in the projector’s menu under Information.  If it reads 
“0kHz”, this means...

63
7.  A p p e n d i x
❷
 Speci cations
This section provides technical information about the projector's performance.
Model Number  LV-7265/LV-7260/LV-X7
Optical
LCD Panel LV-7265: 0.63" p-Si TFT active-matrix with Micro Lens Array (Aspect 4:3)
 LV-7260/LV-X7: 0.6" p-Si TFT active-matrix with Micro Lens Array (Aspect 4:3)
Resolution  1024 x 768 pixels*
1 native, up to UXGA with scaling technology
Lens  Manual zoom and manual focus
  F1.6 - 2.5   f = 17.7 - 28.3 mm
Lamp LV-7265: 200W DC lamp...

64
7.  A p p e n d i x
External Control  RS232, IR
Sync Compatibility  Separate Sync / Composite Sync / Sync on Green / Sync on Video
Built-in Speaker LV-7265: 5W (monaural)
 LV-7260/LV-X7: 1W (monaural)
Power Requirement  100 - 240V AC, 50 / 60 Hz
Input Current LV-7265/LV-7260: 3.1 - 1.3A
 LV-X7: 2.4 - 1.0A
Power Consumption LV-7265: 9W in Standby mode / 285W in Lamp Normal mode / 220W in Lamp 
Quiet mode
 LV-7260: 9W in Standby mode / 255W in Lamp Normal mode / 205W in Lamp 
Quiet mode
 LV-X7: 9W in...

65
7.  A p p e n d i x
PUSH
MENU
BACK
KEYSTONE
WARNING    POWER AUTO PCINPUT
VOL-VOL+LAMP
AUDIO IN
AUDIO OUTS-VIDEOIN
VIDEO
INL
AUDIO INRSERVICE PORT
ANALOG IN-1
DIGITAL IN /
ANALOG IN-2
S-VIDEOIN
VIDEO
INL
AUDIO INRSERVICE PORT
ANALOG IN
❸
 Cabinet Dimensions
Lens center Lens center
Unit: mm (inch)
73 (2.9)
310 (12.2)
10 9 (4.3)
265 (10.4)65 (2.6)
LV-7 2 6 0 / LV-X 7
LV-7 2 6 5 

66
Mini D-Sub 15 Pin Connector
❹
 Pin Assignments of D-Sub ANALOG Input Connector
Signal Level
Video signal : 0.7Vp-p (Analog)
Sync signal : TTL level
1 11 1512 1413
6
5 4
3 210 798
7.  A p p e n d i x
* Only ANALOG-1 input connector supported on LV-7265.
Pin No. RGB Signal (Analog) YCbCr Signal
1 Red Cr
2 Green or Sync on Green Y
3 Blue Cb
4 Ground
5 Ground
6 Red Ground Cr Ground
7 Green Ground Y Ground
8 Blue Ground Cb Ground
9 No Connection
10 Sync Signal Ground
11 No Connection
12 Bi-directional DATA...

67
7.  A p p e n d i x
❺
 Compatible Input Signal List
Horizontal: 15KHz to 100KHz (RGB: 24KHz or over)
Vertical: 50Hz to 120Hz
    Signal  Resolution  Frequency H.  Refresh Rate
      ( Dots )  ( kHz )  ( Hz )
     NTSC    –    15.73  59.94
  PAL   –   15.63  50.00
  PAL60   –   15.73  60.00
  SECAM   –   15.63  50.00
D  VESA  640 
 480  31.47  59.94
D  IBM  640 
 480  31.48  59.95
D  MAC  640 
 480  35.00  66.67
D  VESA  640 
 480  37.86  72.81
D  VESA  640 
 480  37.50  75.00
D  IBM  640 
 480...

68
7.  A p p e n d i x
25"
30"
40"
50"
60"
70"
80"
90"
10 0 "
11 0 "
120 "
13 0 "
14 0 "
15 0 "
16 0 "
17 0 "
176 "
18 0 "
19 0 "
200"
210"
220"
230"
240"
250"
260"
270"
280"
290"
300"51
61
81
10 2
12 2
14 2
16 3
18 3
203
224
244
264
284
305
325
345
358
366
386
406
427
447
467
488
508
528
549
569
589
610x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x38
46
61
76
91
107
12 2...

69
7.  A p p e n d i x
25"
30"
40"
50"
60"
70"
80"
90"
10 0 "
11 0 "
120 "
13 0 "
14 0 "
15 0 "
16 0 "
17 0 "
176 "
18 0 "
19 0 "
200"
210"
220"
230"
240"
250"
260"
270"
280"
290"
300"51
61
81
10 2
12 2
14 2
16 3
18 3
203
224
244
264
284
305
325
345
358
366
386
406
427
447
467
488
508
528
549
569
589
610x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x38
46
61
76
91
107
12 2...

70
7.  A p p e n d i x
❼
 PC Control Codes and Cable Connection
PC Control Codes
Cable Connection
Communication Protocol
Baud rate  19200 bps
Data length  8 bits
Parity No parity
Stop bit  One bit
Communications procedure ...........Full duplex
NOTE: Depending on the equipment, a lower baud rate may be recommended for long cable runs. NOTE: Contact your local dealer for a full list of the PC Control Codes if needed.
SERVICE PORT (Mini DIN-8P)
NOTE: Pins 2, 3, 5, 6 and 8 are used inside the projector.
To...

71
7.  A p p e n d i x
❽
 Troubleshooting Check List
Before contacting your dealer or service personnel, check the following list to be sure repairs are needed, you 
may also refer to the “Troubleshooting” section in your user’s manual. This checklist below will help us solve your 
problem more effi ciently.
* Print the following pages.
No image is displayed from your PC or video equipment to the 
projector.
Still no image even though you connect the projector to the 
PC  rst, then start the PC.
Enabling...