Canon Lbp 5000 User Guide

Loading Envelopes in the Paper Source2-38
Loading and Outputting Paper
2
•When printing envelopes of the Envelope B5 size, close the flaps and load them 
so that the printing side is facing up and the envelopes are printed from the top 
(the edge with the flap).
( : Feeding direction)
NOTE
Load envelopes in Cassette 2 (Only when the optional paper feeder is installed) in the 
same manner as you load envelopes in Cassette 1.
1Pull out the paper cassette.
CAUTION
Be sure to take the paper cassette out of the...

2-39
Loading and Outputting Paper
2
Loading Envelopes in the Paper Source
2Place the stack of envelopes on a flat surface, flatten them to 
release any remaining air, and be sure that the edges are 
pressed tightly.
CAUTION
When loading paper, take care not to cut your hands with the edges of the 
paper.
3Loosen any stiff corners of the envelopes and flatten curls as 
shown in the figure.
4Align the edges of the envelopes on a flat surface.
 

Loading Envelopes in the Paper Source2-40
Loading and Outputting Paper
2
5Load the envelopes so that the edge of the media is aligned 
with the front side of the paper cassette.
IMPORTANT
•Up to approximately 10 envelopes can be loaded in the paper cassette.
•You cannot print on the reverse side (glued side) of envelopes.
6While holding the lock release lever of the side paper guides, 
slide the guides to the mark for the size of the loaded 
envelopes.
The side paper guides move together.
 

2-41
Loading and Outputting Paper
2
Loading Envelopes in the Paper Source
IMPORTANT
Be sure to align the paper guides with the width of the envelopes. If the paper 
guides are too loose or too tight, this may result in misfeeds or paper jams.
7While holding the lock release lever of the rear paper guide, 
slide the guide to the size mark for the loaded envelopes.
 

Loading Envelopes in the Paper Source2-42
Loading and Outputting Paper
2
8Hold down the envelopes as shown in the figure, make sure 
that the stack does not exceed the load limit marks (A), and 
then set it under the hooks (B) on the paper guides.
Make sure that there is sufficient space between the hooks of the paper guides 
and the stack of the envelopes. If there is no sufficient space, slightly reduce the 
amount of the envelopes.
9Set the paper cassette in the printer.
Push the paper cassette into the...

2-43
Loading and Outputting Paper
2
Loading Envelopes in the Paper Source
10Register the size of the loaded paper using the following 
procedure.
This printers paper cassette cannot automatically detect the paper size. 
Therefore, you need to register the size of the loaded paper.
11Display the Printer Status Window.
For details on methods for displaying the Printer Status Window, see Displaying 
the Printer Status Window, on p. 4-88.
12From the [Options] menu, select [Device Settings]  [Register 
Paper...

Loading Envelopes in the Paper Source2-44
Loading and Outputting Paper
2
Loading an Envelope in the Manual Feed Slot
Load an envelope in the manual feed slot using the following procedure.
•When loading an envelope at sizes of DL, COM10, C5, or Monarch in the manual 
feed slot, be sure to load it in portrait orientation so that the printing side is facing 
down and the flap is toward the right of the printer when viewed from the front.
( : Feeding direction)
•When printing an envelope of the Envelope B5...

2-45
Loading and Outputting Paper
2
Loading Envelopes in the Paper Source
1Adjust the paper guides to the width of the loaded envelope 
as shown in the figure.
The paper guides move together.
IMPORTANT
Be sure to align the paper guides with the width of the envelopes. If the paper 
guides are too loose or too tight, this may result in misfeeds or paper jams.
 

Loading Envelopes in the Paper Source2-46
Loading and Outputting Paper
2
2Gently insert the envelope until it touches the back of the 
printer while supporting the envelope with hands as shown in 
the figure.
When the envelope is loaded, it is sent into the slot a little.
CAUTION
When loading paper, take care not to cut your hands with the edges of the 
paper.
IMPORTANT
Load the envelope so that it is straight.
Next, configure the printer driver (See p. 2-59).
 

2-47
Loading and Outputting Paper
2
Loading Custom Size Paper (Non-Standard Paper) in the Paper Source
Loading Custom Size Paper (Non-Standard Paper) in 
the Paper Source
This section describes the procedure for loading custom size paper in the paper 
source.
The paper source that you can load custom size paper is the paper cassette and 
manual feed slot. If you want to print continuously, load the custom size paper in the 
paper cassette.
When printing only a sheet of custom size paper that is different...