Brother HL 2035R User Manual

4
2
2
What kind of paper can I use?2
Type and size of paper2
The printer loads paper from the installed paper tray, or the manual feed slot.
The names for the paper trays in the printer driver and this guide are as follows:
When looking at this page on the CD-ROM, you can jump to the page for each printing method by clicking p 
in the table.
1Legal paper is not available in some regions.
Printing Methods2
Paper tray Tray 1
Manual feed slot Manual
Media typeTray 1ManualSelect the Media type from 
the...

Printing Methods
5
2
Recommended paper2
„Before you buy a lot of paper, please test a small quantity to make sure that the paper is suitable.
„Use paper that is made for plain-paper copying.
„Use paper that is 75 to 90 g/m
2 (20 to 24 lb).
„Use neutral paper. Do not use acidic or alkaline paper.
„Use long-grain paper.
„Use paper with a moisture content of approximately 5%.
„This printer can use recycled paper that meets DIN 19309 specification.
CAUTION 
Do not use ink jet paper, because it might cause a...

Printing Methods
6
2
Printable area2
The edges of the paper that cannot be printed on are shown below.
Portrait2
 
Landscape2
 
A4LetterLegalB5 (ISO)ExecutiveA5A6B6
1 4.23 mm 
(0.16 in.)4.23 mm 
(0.16 in.)4.23 mm 
(0.16 in.)4.23 mm 
(0.16 in.)4.23 mm 
(0.16 in.)4.23 mm 
(0.16 in.)4.23 mm 
(0.16 in.)4.23 mm 
(0.16 in.)
2 6.01 mm 
(0.24 in.)6.35 mm 
(0.25 in.)6.35 mm 
(0.25 in.)6.01 mm 
(0.24 in.)6.35 mm 
(0.25 in.)6.01 mm 
(0.24 in.)6.01 mm 
(0.24 in.)6.01 mm 
(0.24 in.)
3 4.23 mm 
(0.16 in.)4.23 mm...

Printing Methods
7
2
Printing methods2
Printing on plain paper, bond paper and transparencies2
You can print on plain paper, bond paper or transparencies from the paper tray or manual feed slot. For the 
paper you want to use, see What kind of paper can I use? on page 4.
Printing on plain paper, bond paper or transparencies from the paper tray2
Note
Do not put more than 10 transparencies in the paper tray, if you print on transparencies.
 
aChoose the following from the printer driver:
Paper...

Printing Methods
8
2
bPull the paper tray completely out of the printer. 
cWhile pressing the blue paper-guide release lever, slide the paper guides to fit the paper size. Check 
that the guides are firmly in the slots.
 
dPut paper in the tray. 
 

Printing Methods
9
2
eCheck that the paper is below the maximum paper mark  (b). 
Note
• Paper jams may occur if you put more than 250 sheets (80 g/m
2 or 21 lb) of plain or bond paper in the 
paper tray at any one time.
• Paper jams may occur if you put more than 10 transparencies in the paper tray at any one time.
• When you use pre-printed paper, put the side that is going to be printed on (blank side) face down, with 
the top of the paper at the front of the tray.
 
fPut the paper tray firmly back in...

Printing Methods
10
2
Printing on plain paper, bond paper or transparencies from the manual feed slot2
Note
The printer automatically turns on the Manual Feed mode when you put paper in the manual feed slot.
 
aChoose the following from the printer driver:
Paper Size............................ (1)
Media Type........................... (2)
Paper Source....................... (3)
and any other settings.
„Windows
® printer driver
 
bSend the print data to the printer. 
Note
A No paper fed manual feed slot...

Printing Methods
11
2
cLift up the support flap to prevent paper from sliding off the face-down output tray. 
Note
If you choose not to lift up the output tray support flap, we recommend that you remove printed pages as 
soon as they come out of the printer.
 
dUsing both hands, slide the manual feed slot paper guides to the width of the paper that you are going 
to use.
 
eUsing both hands, put one piece of paper or one envelope in the manual feed slot until the front edge of 
the paper or envelope...

Printing Methods
12
2
fAfter the printed page comes out of the printer, put in the next sheet of paper or the transparency as in 
Step 5 above. Repeat for each page that you want to print.
Note
If you print on transparencies, remove each transparency immediately after printing. Stacking the printed 
transparencies may cause a paper jam or the transparency to curl.
 
 

Printing Methods
13
2
Printing on thick paper, labels and envelopes2
Note
The printer automatically turns on the Manual Feed mode when you put paper in the manual feed slot.
 
When you select the paper you want to use, see What kind of paper can I use? on page 4.
If you print on envelopes, see Types of envelopes to avoid on page 16.
Printing on thick paper, labels and envelopes from the manual feed slot2
aChoose the following from the printer driver:
Paper Size............................ (1)
Media...