BenQ Mw712 Users Manual

Downloaded from www.Manualslib.com manuals search engine Downloaded From projector-manual.com BenQ ManualsOperation41
Adjusting the sound level
To adjust the sound level, press Volume+/Volume- on the 
remote control, or :
1. Repeat steps 1-2 above.
2. Highlight VOLUME and select a desired sound level.
Turning off the Power on/off ring tone
To turn off the ring tone:
1. Repeat steps 1-2 in Muting the sound section.
2. Highlight Power on/off Ring Tone and select Off.
The only way to change Power on/off...

Downloaded from www.Manualslib.com manuals search engine Downloaded From projector-manual.com BenQ ManualsOperation 42
Select the lamp saver mode
• Using the remote control. 
Press Smart Eco and Highlight Lamp Mode and press  /  to select Normal/
Economic/Smart Eco.
•Using the OSD menu.
1. Press MENU/EXIT and then press  /  
until the SYSTEM SETUP: Advanced menu 
is highlighted.
2. Press  to highlight Lamp Mode and press 
MODE/ENTER. The Lamp Settings page 
displays.
3. Highlight Lamp Mode and press  /...

Downloaded from www.Manualslib.com manuals search engine Downloaded From projector-manual.com BenQ ManualsOperation43
U s e  Te a c h i n g  Te m p l a t e
Making writing on the board easier for teachers, you can use build-in template by OSD.  
Open the OSD menu and go to the DISPLAY > 
Teaching Template . Choice Blackboard/ 
Whiteboard. >  Off/ Letter Formation/ Musical 
Staff/ Worksheet/ Coordinate Chart. The 
Teaching Template displays.
Teaching 
TemplateWhiteboardBlackboard
Letter 
Formation
Musical...

Downloaded from www.Manualslib.com manuals search engine Downloaded From projector-manual.com BenQ ManualsOperation 44
Controlling the projector through a LAN 
environment
Network Settings allow you to manage the projector from a computer using a web 
browser when the computer and the projector are properly connected to the same local 
area network.
Configuring the Wired LAN Settings
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the LAN input jack of the projector and 
the...

Downloaded from www.Manualslib.com manuals search engine Downloaded From projector-manual.com BenQ ManualsOperation45 1. Enter the address of the projector in the address bar of your browser and press 
Enter. For example: http://10.60.7.31
• The Crestron remote network operation page opens.
The Crestron page is only available when you are  on a Wired LAN network. It also allows 
you to control the projector remotely. The Crestron supports RoomView version 6.2.2.9.
i. These buttons function the same as...

Downloaded from www.Manualslib.com manuals search engine Downloaded From projector-manual.com BenQ ManualsOperation 46The tools page allows you to manage the projector, configure the LAN control settings and 
secure access of remote network operation on this projector.
i. You can name the projector, keep track of its location and the person in charge 
of it.
ii. You can adjust the Wired LAN settings.
iii. Once set, access to the remote network operation on this projector has been 
password-protected.
iv....

Downloaded from www.Manualslib.com manuals search engine Downloaded From projector-manual.com BenQ ManualsOperation47 The info page displays the information and status of this projector.
i. Press exit to go back to the Crestron remote network operation page.
i  

Downloaded from www.Manualslib.com manuals search engine Downloaded From projector-manual.com BenQ ManualsOperation 48
Shutting down the projector
1. Press   on the projector. A confirmation 
message displays prompting you. 
If you dont respond in a few seconds, the 
message will disappear. If you use the remote 
control, press   to shut down the projector.
2. Press   on the projector a second time. The 
POWER indicator light flashes orange, the 
projection lamp shuts down, and the fans will 
continue to...

Downloaded from www.Manualslib.com manuals search engine Downloaded From projector-manual.com BenQ ManualsOperation49
Menu operation
Menu system
Please note that the on-screen display (OSD) menus vary according to the signal type 
selected.
Main menu Sub-menu Options
1. 
DISPLAY
Wall ColorOff/Light Yellow/Pink/Light 
Green/Blue/Blackboard
Aspect Ratio Auto/Real/4:3/16:9/16:10
Keystone
Position
Phase
H. Size
Digital Zoom
3D SyncOff/Top-Bottom/
Frame sequential
3D Sync Invert On/Off
Teaching 
Te m p l a t...

Downloaded from www.Manualslib.com manuals search engine Downloaded From projector-manual.com BenQ ManualsOperation 50
4. 
SYSTEM 
SETUP: 
Basic
Presentation TimerTimer period1~240 minutes
Timer displayAlways/Last 1 Min/Last 2 Min/
Last 3 Min/Never
Timer positionTop-Left/Bottom-Left/Top-Right/
Bottom-Right
Timer counting 
directionCount Down/Count Up
Sound reminder On/Off
On/Off Yes/No
Language
Projector PositionFront Table/Rear Table/Rear Ceiling/
Front Ceiling
Menu SettingsMenu display time5 sec/10...