Apple studio display 17 crt 16 vis adc User Manual
Here you can view all the pages of manual Apple studio display 17 crt 16 vis adc User Manual. The Apple manuals for Display are available online for free. You can easily download all the documents as PDF.
Page 31
Studio Display (17 ADC) Take Apart - 29 Deflection Board and Mount Assembly11. Remove the deßection board and mount assembly from the CRT and place it on the workbench. Replacement Note: When replacing the deßection board and mount assembly on the CRT, place the edge of the stand tilt base in the bezel channel as shown below.
Page 32
30 - Studio Display (17 ADC) Take Apart Deflection Board Assembly Deflection Board Assembly Tools The following tools are required: ¥ #2 Phillips screwdriver ¥ #1 Phillips screwdriver ¥ Small, flat-blade screwdriver ¥ JewelerÕs screwdriver ¥ Needlenose pliers Preliminary Steps Before you begin, remove the following: ¥ Monitor stand ¥ Rear housing ¥ CRT shroud ¥ Discharge the CRT ¥ Deflection board and mount assembly
Page 33
Studio Display (17 ADC) Take Apart - 31 Deflection Board Assembly Procedure 1. Remove four screws and two ground straps from the deßection board and PCB mount. Replacement Note: Attach ground straps to the outside mounting screws, and attach a ground strap and clip to the lower, center mounting screw.
Page 34
32 - Studio Display (17 ADC) Take Apart Deflection Board Assembly 2. Disconnect these cables from the analog board: ¥ USB cable from connector B103 ¥ LED cable from connector B105 ¥ Ground cable from connector B901 3. Use ßat-tip screwdriver to pry off the metal USB shield.
Page 35
Studio Display (17 ADC) Take Apart - 33 Deflection Board Assembly4. Remove the six remaining screws from the analog board and PCB mount. 5. Remove the analog board from the PCB mount and place it nearby on the workbench. Caution: Note that video cables still connect the anode board and PCB mount.
Page 36
34 - Studio Display (17 ADC) Take Apart Deflection Board Assembly 6. Remove the screw and ground cable from the bottom of the video shield. Remove two of the remaining three screws as shown. Note: Do NOT remove the last screw, shown in red below. 7.Replacement Note: Note the position of the video cable and clip before performing the next step. You may need a needlenose pliers to replace the video cable. 8. Disconnect the video cable from connector B708. Pull apart the video holder and video shield...
Page 37
Studio Display (17 ADC) Take Apart - 35 Video Cable Video Cable Tools The following tools are required: ¥ #2 Phillips screwdriver Preliminary Steps Before you begin, remove the following: ¥ Monitor stand ¥ Rear housing ¥ CRT shroud ¥ Discharge the CRT ¥ Deflection board and mount assembly ¥ Deflection board assembly
Page 38
36 - Studio Display (17 ADC) Take Apart Video Cable Procedure Replacement Note: Note the positioning of the video cables before removing them from the PCB mount in the next step. 1. Remove four screws from the PCB mount, and remove the PCB mount (1) from the bottom pan (2).
Page 39
Studio Display (17 ADC) Take Apart - 37 Video Cable2. Turn over the bottom pan, and separate the stand tilt base (1) from the bottom pan. 3. Pull the video cable off the bottom pan and pop open the plastic strain reliefs.
Page 40
38 - Studio Display (17 ADC) Take Apart Video Cable 4. Lace the video cables (1) through the bottom pan (2). Note: Remove Þve clips from the video cables before returning a faulty cable to Apple. Note the position of the clips in the photo below.