Home > Apple > Notebook > Apple powerbook g4 12 inch 1 33ghz User Manual

Apple powerbook g4 12 inch 1 33ghz User Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Apple powerbook g4 12 inch 1 33ghz User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							 
    PowerBook G4 (12-inch 1.33 GHz) Take Apart -  
    19 
     Keyboard2. Open the computer, and locate the following keys:
    •F1
    •F2
    • F11
    • F12
    3.
      Important:  Using a black stick, carefully pry up each of the four keys from the left side 
    of each key. The keys are easily removed from the left side without damaging the 
    keyboard. 
    						
    							20 - PowerBook G4 (12-inch 1.33 GHz) Take Apart
     Keyboard 4. Use a black stick or flat-blade screwdriver to lift off the two round stickers that are 
    located between the two key mechanisms. Reserve the stickers for replacement.
    5. Remove the screw under each of the stickers. 
    						
    							PowerBook G4 (12-inch 1.33 GHz) Take Apart - 21
     Keyboard6. Lift up the top two corners of the keyboard, and move the keyboard toward the display 
    to clear the tabs at the bottom of the keyboard. 
    						
    							22 - PowerBook G4 (12-inch 1.33 GHz) Take Apart
     Keyboard 7. Flip the keyboard over and lay the keyboard flat on the trackpad.
    8. Peel up the keyboard cable from its adhesive. Using a black stick, pry up the tabs at 
    the ends of the connector, and then pull the cable straight up to disconnect it. 
    						
    							PowerBook G4 (12-inch 1.33 GHz) Take Apart - 23
     Keyboard9. Install the replacement keyboard. Make sure you
    • Set the tabs at the bottom of the keyboard into the slots in the top case.
    • Press the keyboard into place, and install the screws and round stickers.
    • Install the function keys:
    – Position the key directly over the scissor mechanism.
    – Press the key onto the scissor.
    – Check the operation of the key.
    • Close the display and install the final screw in the memory bay.
    10. Reassemble and test the computer. 
    						
    							24 - PowerBook G4 (12-inch 1.33 GHz) Take Apart
     Top Case
    Top Case
    Tools
    This procedure requires the following tools:
    • #0 Phillips screwdriver 
    • Black stick (or other nonconductive nylon or plastic flat-blade tool) 
    • Hex 1.5 mm screwdriver 
    Note: To organize the screws you remove from the computer, use a tray with divided 
    compartments (such as a plastic ice cube tray).
    Part Location
    Preliminary Steps
    Before you begin, remove the following:
    • Battery
    • Memory door and memory card
    • Keyboard 
    						
    							PowerBook G4 (12-inch 1.33 GHz) Take Apart - 25
     Top Case
    Procedure
    1.Warning: The screws in the battery bay require holding the screwdriver at an 
    angle. Be careful not to strip the screws.
    Note: Avoid scratching the external housing by using care when removing the 
    screws. You might want to cover part of the housing with a soft cloth as you remove 
    screws.
    With the computer upside down on a soft cloth, remove the three screws from the 
    bottom case at the battery bay.
    2. Remove the screws near the display hinge.  
    						
    							26 - PowerBook G4 (12-inch 1.33 GHz) Take Apart
     Top Case 3. Open the display, and with the computer upright, remove the following 14 screws from 
    the top case:
    • one Hex, 16.5-mm long screw at upper right corner near power button
    • one Hex, 7-mm long screw at upper left corner near microphone
    • one #0 Phillips, 14.5-mm long screw in keyboard well
    • five #0 Phillips, 4.5-mm long screws in keyboard well
    • six #0 Phillips, 2.5-mm long screws in keyboard well
    Replacement Note:
     When replacing the top case screws, install the screws in the 
    order shown. 
    						
    							PowerBook G4 (12-inch 1.33 GHz) Take Apart - 27
     Top Case4. Remove two screws from the front right side of the top case.
    Note:
     The shape of the two 3-mm long screws differs from most of the screws used 
    in the computer. The screw has a collar under the screw head.
    Replacement Note:
     In addition to securing the top case to the bottom case, the two 
    3-mm long screws help secure an inner bracket to the battery well. Make sure the 
    bracket and two latches are installed in the bottom case before replacing the top 
    case.
    5. Remove two screws from the front left side of the top case.
    Replacement Note:
     When installing the top case, install these two 5.5-mm long 
    screws before installing the 3-mm long screws. 
    						
    							28 - PowerBook G4 (12-inch 1.33 GHz) Take Apart
     Top Case 6. Place the computer on its side, and loosen but do not remove the half of the top case 
    that is closest to the display. 
    						
    All Apple manuals Comments (0)

    Related Manuals for Apple powerbook g4 12 inch 1 33ghz User Manual