Apple power mac g5 late 2005 User Manual

Power Mac G5 (Late 2005) Take Apart — Battery 51
Procedure
If necessary, carefully spread the two tabs holding the battery.
Remove the battery from its holder.  
Replacement Note: Insert the new battery in the holder, making sure the battery’s negative 
symbol (–) faces up.
Warning: Installing the battery incorrectly may cause an explosion. Be sure the battery’s positive 
and negative sides are correctly oriented in the holder. Use only the same type of battery or an 
equivalent recommended by the...

Power Mac G5 (Late 2005) Take Apart — AirPort Extreme/Bluetooth Combo Card 52
AirPort Extreme/Bluetooth  
Combo Card and Runway Card
Note: The combo card is connected to an adapter card called the runway card. This procedure 
includes steps for removing both the combo and runway cards. However, if you are replacing just 
the combo card, it is not necessary to remove the runway card from the enclosure.
Tools
The only tools required for this procedure are a jeweler’s Phillips #0 screwdriver and Xacto...

Power Mac G5 (Late 2005) Take Apart — AirPort Extreme/Bluetooth Combo Card 53
Procedure
Using a jeweler’s Phillips screwdriver, remove the two combo card mounting screws.
Disconnect the combo card antennas from the clip on the side of the PCI divider. 
Disconnect the combo card from the runway card and lift up a short distance.
Disconnect the two antenna cables from the card and remove the card from the enclosure.
Replacement Note: The cables can attach to either connector on the card. 
1.
2.
3.
4. 

Power Mac G5 (Late 2005) Take Apart — AirPort Extreme/Bluetooth Combo Card 54
To remove the runway card (after removing the combo card), do the following:
Note: The runway card is attached to the PCI divider by two black rivets. You must remove the 
rivets before disconnecting the card from the logic board.
Using a Xacto knife, pry up and remove the center plug of the first black rivet. Then pry up 
and remove the outer casing for the rivet. 
Repeat for the second rivet.
Holding the runway card by its...

Power Mac G5 (Late 2005) Take Apart — PCI Card Guide 55
PCI Card Guide
Tools
The only tool required for this procedure is a Phillips #1 screwdriver.
Preliminary Steps
Before you begin, open the computer, lay it on its side with the access side facing up, and 
remove any 12-inch graphics or PCI Express cards.
Part Location 

Power Mac G5 (Late 2005) Take Apart — PCI Card Guide 5
Procedure
Remove the two screws that mount the PCI card guide to the logic board.
Slide the card guide up to release the two latches from the PCI divider, and remove the card 
guide from the enclosure.
1.
2. 

Power Mac G5 (Late 2005) Take Apart — Speaker/Fan Assembly 5
Speaker/Fan Assembly
Tools
No tools are required for this procedure.
Preliminary Steps
Before you begin, open the computer, lay it on its side with the access side facing up, and remove 
the following:
Any 12-inch graphics or PCI Express cards
PCI card guide.
Part Location
•
• 

Power Mac G5 (Late 2005) Take Apart — Speaker/Fan Assembly 5
Procedure
Disconnect the speaker and fan cables from the logic board.
Lift the speaker/fan assembly straight up and remove it from the enclosure. 
Important: Be careful that the fan and speaker cables do not catch on the PCI divider as you 
lift the assembly.
Replacement Note: When reinstalling the speaker/fan bracket in the enclosure, make sure the 
large tab on the side of bracket engages with the channel in the PCI divider.
1.
2. 

Power Mac G5 (Late 2005) Take Apart — Ambient Board 5
Ambient Board
Tools
No tools are required for this procedure.
Preliminary Steps
Before you begin, open the computer, lay it on its side with the access side facing up, and remove 
the following:
Any 12-inch graphics or PCI Express cards
PCI card guide
Speaker/fan assembly
Part Location
•
•
• 

Power Mac G5 (Late 2005) Take Apart — Ambient Board 0
Procedure
Locate the ambient board connected to the logic board.
Position your fingers on both sides of the board. Gently rock the board from side-to-side, 
pulling it straight up and out of the connector.
1.
2.