Apple macbook pro 15 inch mid 2010 User Manual
Here you can view all the pages of manual Apple macbook pro 15 inch mid 2010 User Manual. The Apple manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 131
MacBook Pro (15-inch, Mid 2010) Take Apart — Hard Drive/IR/Sleep Indicator Cable 131 2010-12-15 Removal 1 Caution: The cable is fragile; be careful when disconnecting and removing the it. 2 Use black stick to disconnect cable from connector on logic board and carefully pry cable from top of speaker. 3 Remove 4 screws: • 2 (2.6 mm) 922-9036 on cable • 2 (8.9 mm) 922-9105 on front bracket Replacement Note: Make sure rubber gaskets are installed on front bracket before reinstalling 2 screws....
Page 132
MacBook Pro (15-inch, Mid 2010) Take Apart — Memory 132 2010-12-15 First Steps Remove: • Bottom case • Battery Caution: Avoid touching anything other than the memory area. Tools • Clean, soft, lint-free cloth • ESD wrist strap and mat Memory
Page 133
MacBook Pro (15-inch, Mid 2010) Take Apart — Memory 133 2010-12-15 Memory Information Memory cards must be: • 1.18 inch (30 mm) • 2 GB or 4 GB • 204-pin • PC-8500 DDR3, 1066 MHz RAM Removal 1 Push 2 ejection levers outward until the memory pops up at an angle. Make sure you see the half-circle notches on the memory card. If not, press the ejection levers again. 2 Remove memory card from the slot. 3 Hold the card by the edges. 4 Do not touch the gold connectors. This computer comes with a...
Page 134
MacBook Pro (15-inch, Mid 2010) Take Apart — Memory 134 2010-12-15 Replacement 1 Install cards at an angle. If installing just one card, install it in lower slot. 2 Press card down. You will hear a click when inserted correctly. 3 If you installed additional memory, check that the computer recognizes it.
Page 135
MacBook Pro (15-inch, Mid 2010) Take Apart — AirPort/Bluetooth Flex Cable 135 2010-12-15 First Steps Remove: • Bottom case • Battery Tools • Clean, soft, lint-free cloth • ESD wrist strap and mat • Black stick AirPort/Bluetooth Flex Cable
Page 136
MacBook Pro (15-inch, Mid 2010) Take Apart — AirPort/Bluetooth Flex Cable 136 2010-12-15 Removal 1 Disconnect both ends of flex cable. 2 Remove cable from bottom case.
Page 137
MacBook Pro (15-inch, Mid 2010) Take Apart — AirPort/Bluetooth Card With Holder 137 2010-12-15 First Steps Remove: • Bottom case • Battery • AirPort/Bluetooth flex cable Tools • Clean, soft, lint-free cloth • ESD wrist strap and mat • Magnetized Phillips #00 screwdriver • Needlenose pliers or tweezers • Black stick (1 or 2) AirPort/Bluetooth Card With Holder
Page 138
MacBook Pro (15-inch, Mid 2010) Take Apart — AirPort/Bluetooth Card With Holder 138 2010-12-15 Removal 1 Disconnect camera cable from logic board. Note: When disconnecting camera cable, use two black sticks (or one black stick, alternating sides) to disconnect cable evenly.
Page 139
MacBook Pro (15-inch, Mid 2010) Take Apart — AirPort/Bluetooth Card With Holder 139 2010-12-15 2 Remove 2 screws: • 1 (8.1 mm) 922-9107 • 1 (3.5 mm) 922-8974 3 If you are removing AirPort/Bluetooth card from holder, disconnect Bluetooth cable and 2 AirPort cables from card. Note: Use needlenose pliers or tweezers to lift metal connector of each cable straight up
Page 140
MacBook Pro (15-inch, Mid 2010) Take Apart — AirPort/Bluetooth Card With Holder 140 2010-12-15 4 Rotate card holder back from bottom case. 5 To remove card from holder, remove 2 (2.5 mm) 922-9200 screws and lift card from holder.