Apple macbook pro 15 inch mid 2009 User Manual
Here you can view all the pages of manual Apple macbook pro 15 inch mid 2009 User Manual. The Apple manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 141
MacBook Pro (15-inch, Mid 2009) Take Apart — Memory 141 2010-12-15 First Steps Remove: • Bottom case • Battery Caution: Avoid touching anything other than the memory area. Tools • Clean, soft, lint-free cloth • ESD wrist strap and mat Memory
Page 142
MacBook Pro (15-inch, Mid 2009) Take Apart — Memory 142 2010-12-15 Memory Information Memory cards must be: • 1.18 inch (30 mm) • 2 GB or 4 GB • 204-pin • PC-8500 DDR3, 1066 MHz RAM Removal 1 Push 2 ejection levers outward until the memory pops up at an angle. Make sure you see the half-circle notches on the memory card. If not, press the ejection levers again. 2 Remove memory card from the slot. 3 Hold the card by the edges. 4 Do not touch the gold connectors. This computer comes with a...
Page 143
MacBook Pro (15-inch, Mid 2009) Take Apart — Memory 143 2010-12-15 Replacement 1 Install cards at an angle. If installing just one card, install it in lower slot. 2 Press card down. You will hear a click when inserted correctly. 3 If you installed additional memory, check that the computer recognizes it.
Page 144
MacBook Pro (15-inch, Mid 2009) Take Apart — Bluetooth Card With Holder 144 2010-12-15 First Steps Remove: • Bottom case • Battery Note: This procedure applies only to anti-glare display models Tools • Clean, soft, lint-free cloth • ESD wrist strap and mat • Magnetized Phillips #00 screwdriver • Black stick Bluetooth Card With Holder Note: This procedure applies only to anti-glare display models.
Page 145
MacBook Pro (15-inch, Mid 2009) Take Apart — Bluetooth Card With Holder 145 2010-12-15 Removal 1 Disconnect 2 screws. 2 Peel up mylar cover, and disconnect 2 cables: 3 Using black stick, pry camera cable off Bluetooth card holder. 4 Slide Bluetooth holder and card from underneath camera cable and remove assembly from computer.
Page 146
MacBook Pro (15-inch, Mid 2009) Take Apart — Bluetooth Card With Holder 146 2010-12-15 Replacement Note: Install Bluetooth holder on optical drive as illustrated. Check that • holder slides under camera cable • holder’s clamp secures camera cable • screw holes align • grommets are positioned on top of holder’s screw holes
Page 147
MacBook Pro (15-inch, Mid 2009) Take Apart — Camera Cable Guide 147 2010-12-15 First Steps Remove: • Bottom case • Battery Tools • Clean, soft, lint-free cloth • ESD wrist strap and mat • Magnetized Phillips #00 screwdriver Camera Cable Guide Note: This procedure does not apply to anti-glare models with the Bluetooth card option. The camera cable guide on these models is built into the Bluetooth card holder.
Page 148
MacBook Pro (15-inch, Mid 2009) Take Apart — Camera Cable Guide 148 2010-12-15 Removal 1 Remove 2 (8-mm) screws (922-9107). 2 Remove cable guide from the top case. Replacement Note: Be sure to anchor the ground tab when reinstalling the screw closest to the display clutch cover.
Page 149
MacBook Pro (15-inch, Mid 2009) Take Apart — LVDS Cable Guide 149 2010-12-15 First Steps Remove: • Bottom case • Battery Tools • Clean, soft, lint-free cloth • ESD wrist strap and mat • Magnetized Phillips #00 screwdriver LVDS Cable Guide
Page 150
MacBook Pro (15-inch, Mid 2009) Take Apart — LVDS Cable Guide 150 2010-12-15 Removal 1 Remove 1 (7-mm) screw (922-8645). Replacement Note: Be sure to anchor the ground tab when reinstalling the screw.