Air Live Router WT-2000ARM User Manual

 
AirLive WT-2000ARM User’s Manual 
 1
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 WT-2000ARM   
802.11g Wireless LAN 
ADSL 2+ Router 
User’s Manual  

Declaration of Conformity
We, Manufacturer/Importer
Declare that the product
802.11g Wireless LAN ADSL2+ Router
WT-2000ARM
is in conformity with
4PEPzPGP0PAPALLPCLxP0PzPAPAPGL0LzPBLGPGL–LSPDLALALBPGLCLCLDLELCPxLDPGLALz/cPCPAPAPBLzLFPAPGP0PzLxPGAPLSLSLSPDALPGLCLDLEAAPGANPGAGAGLCPGLALzPCPAPA/cPBLzLFPA>
Clause Description
4LCLNPAPAPBPCLLPFP0AxPzPAPBLzPAPGPALLPFLPP0PBLzA0LzLNLzPBAzPGP0PzLxPGAAP0/cLxLzLLPGA–LPPAPAPBPCP–PFPGPxP0PBPBPAPCA–PGASLCAAPxAAAB>...

WT-2000ARM CE Declaration Statement 
Country Declaration Country Declaration 
cs  
Česky [Czech] 
OvisLink Corp. tímto prohlašuje, že tento 
WT-2000ARM je ve shodě se základními 
požadavky a dalšími příslušnými ustanoveními 
sm ěrnice 1999/5/ES. lt 
Lietuvi ų 
[Lithuanian] 
Š iuo OvisLink Corp. deklaruoja, kad šisWT-2000ARM
atitinka esminius reikalavimus ir kitas 1999/5/EB 
Direktyvos nuostatas. 
da  
Dansk [Danish] 
Undertegnede OvisLink Corp. erklærer herved, at 
følgende udstyr WT-2000ARM...

 
AirLive WT-2000ARM User’s Manual 
 2
 
Copyright 
 
The contents of this publication may not be reproduced in any part or as a whole, stored, transcribed 
in an information retrieval system, translated into any language, or transmitted in any form or by any 
means, mechanical, magnetic, electronic, optical, photocopying, manual, or otherwise, without the 
prior written permission. 
 
FCC Interference Statement 
 
This equipment has been tested and found to comply with the limits for a Class B digital...

 
AirLive WT-2000ARM User’s Manual 
 
Table of Contents 
CHAPTER I: INTRODUCTION ........................................................................................................1 
1.1. F
EATURES.........................................................................................................................1 
1.2. M
INIMUM REQUIREMENTS..................................................................................................2 
1.3. P
ACKAGE...

 
AirLive WT-2000ARM User’s Manual 
 1
Chapter I: Introduction 
Congratulations on purchasing this 802.11g Wireless LAN ADSL2+ Router. This router is a cost-
effective ADSL2+ router, with the combination of an ADSL2+ modem, router, Ethernet network switch 
and wireless access point, you can surf the Internet through your ADSL2/2+ broadband connection 
without investing other devices. 
 
This router can support downstream transmission rates of up to 24Mbps and upstream transmission 
rates of up to 1Mbps....

 
AirLive WT-2000ARM User’s Manual 
 2
Router  
•  NAT (Network Address Translation) IP Sharing 
• Virtual Server 
• DMZ 
•  VPN Pass Through (IPSec/PPTP/L2TP) 
•  SPI Anti-DOS Firewall 
•  DHCP Server and Client 
 
Access Management 
• ACL (Access Control) 
• IP Filter 
•  UPnP (Universal Plug and Play) 
• SNMP 
• Dynamic DNS 
1.2. Minimum Requirements 
The following devices are necessary to configure and use the ADSL2+ Router: 
•  A PC with Pre-installed Ethernet Adapter (Required) and a Web-Browser...

 
AirLive WT-2000ARM User’s Manual 
 3
1.4. Hardware Placement 
1.4.1. Rear Panel 
 
 
 
1) Antenna Connector 
The antenna connector of the router is reverse SMA connector. It allows you to connecting an 
external antenna with reverse SMA connector to the router easily.  
 
2) Reset 
     The Reset button can be used to reset the router or restore to factory defaults. 
z If problems occur with your router, press the router’s reset button with a pencil tip (for less 
than 5 seconds) and the router will...

 
AirLive WT-2000ARM User’s Manual 
 4
1.4.2. Front LEDs 
On the router’s front panel there are LED lights that inform you of the router’s current status. Below is 
an explanation of each LED and its description. 
 
 
 
LED Light Status Description 
On  The router is ready PWR (Green) 
  
Off  Wireless LAN is disabled 
Blinking  Wireless traffic is transmitting or receiving  WLAN (Yellow) 
  
On  Connected to an ADSL DSLAN successfully   ADSL (Green) 
Blinking No connection 
   
On The LAN cable is...

 
AirLive WT-2000ARM User’s Manual 
 5
Chapter II: Hardware Installation 
Step 1. Connect the ADSL Line 
Connect the router to your ADSL cable through the supplied RJ-11 telephone line. 
 
Step 2. Connect the router to your LAN network 
Connect the router to your PC, hub or switch by attached the Ethernet cable to the LAN port of the 
router.  
 
Step 3. Connect the Power Adapter to the Router 
Connect the power adapter to the power jack on the rear panel of router. 
 
Step4: Check the ADSL LED on the...