ADT Security Services Concord 4 User Manual

Concord  4 Series Security Systems11
Refer to the User Sheets in Appendix A to determine which light number is associated with 
which lamp.
Basic Output Control
Your system may be set up with programmed outputs that control special hardware installed in 
your system. These outputs are usually set up to turn on automatically in response to certain 
events.
Your installer may have configured your system so that you can control some outputs from your 
touchpad. Have the installer list and explain any...

Concord  4 Series Security Systems12
ately. A panic alarm can be activated in any arming level. Each type of panic alarm sounds and 
reacts differently when activated.
Fire Panic Alarm
The Fire panic alarm sounds from all interior and exterior sirens. On monitored systems, the cen-
tral monitoring station responds by calling the fire department.

Concord  4 Series Security Systems13
Even though reaching the time-out stops the sirens, the alarm will still be in progress until the 
system is manually disarmed.
Access CodesThe system requires a valid access code before it will process most commands.
There is one System Master code which serves as the primary User Programming code for your 
system. Only a very limited number of users will need to know this code.
Concord 4 systems have six Partition Master codes (one for each partition) which allow...

Concord  4 Series Security Systems14
If more than 40 keys are pressed when the system asks for a code, and those keystrokes are not 
part of a valid access code, a siren will sound. Talk to your installer or see Appendix A “Touch-
pad Information” on page 44 to see if this feature is enabled.
Changing or Erasing User Codes
A Touchtone phone can be used to change or erase user codes, but alphanumeric or fixed display 
touchpads work much better because of their extensive feedback. See Appendix C for phone...

Concord  4 Series Security Systems15
2. For Concord 4 systems, press 030 nnn 2 where nnn is user 000 through 229.
For Concord Express V4 systems, press 
030 nn 2 where nn is the user 00 through 15.
3. To turn Remote Access:

Concord  4 Series Security Systems16
4. Press * + 00 + # to exit the programming menus.
Figure 4. 24-Hour Format

Concord  4 Series Security Systems17
3. Select a brightness level:

Concord  4 Series Security Systems18
Temperature settings can range from 45° to 90° Fahrenheit.
Figure 5.Energy Saver Setpoints

Concord  4 Series Security Systems19
Pager Messages
When an event is reported on a numeric pager, the following information is included:
Figure 6. Pager Messages
Although all three types of information can be reported on your pager, your pager service deter-
mines how the information will actually appear.
Event Code in Page
This number identifies what has happened. 
Sensor Number or User Number in Page
This number identifies who or what is causing the event.
CodeIndicates
009 A sensor has been restored...

Concord  4 Series Security Systems20
Account Number in Page
This number identifies where (which partition) the event is occurring.
Streamlining the Page Report
You can choose to have the four account number digits reported with every page, or to exclude 
them. Each partition has its own account number, so seeing the digits is useful if multiple parti-
tions are reporting to one pager.
Ask your dealer or installer if you would like the Streamline feature turned on.
Figure 7. Pager Message with Streamline...