Acer Aspire 5741g Service Guide
Here you can view all the pages of manual Acer Aspire 5741g Service Guide. The Acer manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 91
Chapter 381 8.Remove four (4) screws from the LCD assembly. 9.Remove the LCD assembly from the lower cover. StepSizeQuantityScrew Type LCD assembly M2.5*8 4
Page 92
82Chapter 3 Removing the LCD Bezel 1.See “Removing the LCD Assembly” on page 79. 2.Remove the two bezel screw caps and screws. 3. Starting from the bottom edge of the bezel, pry the bezel upwards and away from the panel. Work along the right side toward the top of the bezel, prying the covers apart. Continue along the top edge and down the left side to remove the bezel. NOTE: If necessary, use a pry to lift up the outside edges of the bezel. StepSizeQuantityScrew Type LCD Bezel M2.5*6 2
Page 93
Chapter 383 Removing the Camera Module 1.See “Removing the LCD Assembly” on page 79. 2.Locate the Camera Module at the top of the LCD Module and disconnect the camera cable. 3.Remove the Camera from the module.
Page 94
84Chapter 3 Removing the LCD Panel 1.See “Removing the Camera Module” on page 83. 2.Remove the two (2) securing screws from the LCD Panel. 3.Remove the adhesive strip holding the cables in place. 4.Remove the cable from the LCD Module as shown. StepSizeQuantityScrew Type LCD Panel M2.5*6 2
Page 95
Chapter 385 5.Lift the LCD Panel clear of the module.
Page 96
86Chapter 3 Removing the LCD Brackets and FPC Cable 1.See “Removing the LCD Panel” on page 84. 2.Remove the six (6) securing screws (three on each side) from the LCD Panel brackets. 3.Remove the LCD brackets by pulling away from the LCD Panel. StepSizeQuantityScrew Type LCD Brackets M2*3 6
Page 97
Chapter 387 4.Turn the LCD panel over to expose the rear. Pull the cable up as shown. 5.Remove the adhesive tape from the cable. 6.Peel back the mylar securing the LVDS cable.
Page 98
88Chapter 3 7.Disconnect the LVDS cable from the panel.
Page 99
Chapter 389 Removing the Microphone Cable 1.See “Removing the LCD Panel” on page 84. 2.Remove the cable bundle from the hinge channel. 3.Peel back the foil tabs and remove the microphone cable from the cable channel. 4.Continue removing the cable from the cable channel.
Page 100
90Chapter 3 5.Lift the microphone set clear of the panel.