3. Replace the dome cover.
q
Attach the smoke type dome cover (this prod-
uct) to the inner dome while matching the
stopper of the inner dome and the notch of the
smoke type dome cover.
wInsert it into the enclosure and make sure that
both the smoke type dome cover and the inner
dome are stuck in with the stoppers on the
enclosure.
eRotate the attached dome cover to check if it
rotates smoothly together with the inner dome.
4. Attach the enclosure to the main body of the
camera.
Refer to the operating...
                                            

                                                    FEATURES
Dome Cover
Instructions
Model Nos. WV-CS3S/WV-CS3SE
AM0205-0 3TR003468AAA Printed in Japan
This Dome cover can be attached to models WV-CS950 and WV-CS954.
Before attempting to connect or install this product,
please read these instructions carefully and 
save this manual for future use.
•Do not attach the Dome cover if the camera is mounted on the ceiling.
Doing so may result in an injury if the Dome cover falls.
•Note the following points to prevent the drip-proof packing from twisting when...
                                            

                                                    Installing the board in a Multi-Format Camera
1Remove the left and right side panels on the Multi-Format Camera (AK-HC930P).
2Remove the blank panel (right side of camera), then feed the cable (supplied with the
board) through the rectangular opening under the top panel and insert it into the
connector on the opposite side.
5
7
8DOWN
CONV
Down Converter Board
Model No. AK-HDC930P
Blank panelHeat sink Connector
Insert the cable into the connector on the opposite
(left) side of the camera(inside of the...
                                            

                                                    Installing the board in a Multi-Format Camera
1Remove the left and right side panels on the Multi-Format Camera (AK-HC931P).
2Remove the blank panel (right side of camera), then feed the cable (supplied with the
board) through the rectangular opening under the top panel and insert it into the
connector on the opposite side.
5
7
8DOWN
CONV
Down Converter Board
Model No. AK-HDC931P
Blank panelHeat sink Connector
Insert the cable into the connector on the opposite
(left) side of the camera(inside of the...
                                            

                                                    Model No. 
AW-PB303
Before attempting to connect or operate this product,
please read these instructions completely
and save this manual for future use.
High-sensitivity Card 
                                            

                                                    Hybrid Control PanelAW-RP501
Before attempting to connect or operate this product,
please read these instructions completely.
â