Zanussi Zwn7120l Manual
Here you can view all the pages of manual Zanussi Zwn7120l Manual. The Zanussi manuals for Washing Machine are available online for free. You can easily download all the documents as PDF.
Page 21
ProblemPossible cause/Solution Spinning starts late or the machine does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by re- verse rotation of the drum. This may happen several times before the un- balance disappears and normal spinning can resume. If, after 10 minutes, the laundry is still not evenly distributed in the drum, the machine will not spin. In this case, redistribute the load manually and...
Page 22
ProgrammesLoad (kg)Energy con- sumption (kWh)Water con- sumption (li- tre)Approxi- mate pro- gramme duration (minutes)Remaining moisture (%) 1) ZWN7100L Remaining moisture (%) 1) ZWN7120L Cottons 60 °C81.4631606053 Cottons 40 °C80.6631306053 Synthetics 40 °C3,50.654803735 Delicates 40 °C30.663653735 Wool/Hand wash 30 °C20.2555603230 Standard cotton programmes Standard 60 °C cotton81.17612056053 Standard 60 °C cotton40.77491596053 Standard 40 °C cotton40.7481616053 1) At the end of spin phase. Off Mode...
Page 23
Unscrew the three bolts.Slide out the relevant plastic spacers. Open the porthole, remove the polystyr- ene block fitted on the door seal and pull out all items from the drum.Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction book- let. Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the...
Page 24
35° 45° The other end of the inlet hose which con- nects to the appliance can be turned as showed in the picture. Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. Set the hose correctly by loosening the ring nut. After posi- tioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. Caution! The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a...