Zanussi Zwn7120l Manual

Start the programme by pressing button 7
To start the selected programme, press this
button; the corresponding green pilot light
stops blinking.
The pilot light 9 illuminates to indicate that the
appliance starts operating and the door is
locked.
If you have chosen a delayed start, the machine
will begin the countdown.
Important! If an incorrect option is selected,
the message Err is displayed for a few seconds
and the red pilot light of this button blinks 3
times.
Select the Delay Start by pressing...

After closing the door, it is necessary to select
the programme and options again and to press
button 7.
At the end of the programme
The machine stops automatically. Some acous-
tic signals sound and a blinking 
 appears on
the display. The pilot light of button 7 and the
pilot light 9 go off.
If you have set a programme or an option that
ends with water left in the tub, the pilot light 9
remains on. The door is locked to indicate that
the water must be emptied out. During this time
the drum continues to...

Red wine: soak in water and detergent, rinse
and treat with acetic or citric acid, then rinse.
Treat any residual marks with bleach.
Ink: depending on the type of ink, moisten the
fabric first with acetone
1), then with acetic acid;
treat any residual marks on white fabrics with
bleach and then rinse thoroughly.
Tar stains: first treat with stain remover, methy-
lated spirits or benzine, then rub with detergent
paste.
Detergents and additives
Good washing results also depend on the
choice of detergent...

Programme
Maximum and Minimum Temperature - Cycle De-
scription - Maximum Spin Speed - Maximum Fabrics
Load - Type of Laundry
OptionsDetergent Com-
partment
 SYNTHETICS
60° - 
 (Cold)
Main wash - Rinses
Maximum spin speed at 900 rpm
Max. load 3,5 kg - Reduced load 1,5 kg
Synthetic or mixed fabrics: underwear, coloured gar-
ments, non-shrink shirts, blouses.
SPIN REDUCTION
RINSE HOLD
ECO
2)
SUPER QUICK3)
PREWASH
EASY IRON
EXTRA RINSE
 4)
 Special programmes
 DELICATES
40° - 
 (Cold)
Main wash - Rinses...

Programme
Maximum and Minimum Temperature - Cycle De-
scription - Maximum Spin Speed - Maximum Fabrics
Load - Type of Laundry
OptionsDetergent Com-
partment
 SOAK
30°
Prewash - Soak for about 40 minutes - Stop with water in
the tub
Max. load 8 kg
Special programme for heavily soiled laundry. The machine
performs a soak at 30°C. At the end of this time the ma-
chine will stop automatically with water left in the tub.
Before starting a new washing phase, it is necessary to
empty out the water by:
•Draining...

Programme
Maximum and Minimum Temperature - Cycle De-
scription - Maximum Spin Speed - Maximum Fabrics
Load - Type of Laundry
OptionsDetergent Com-
partment
 = OFF
For cancelling the programme which is running or to switch the machine off .
1) Standard programmes for the Energy Label consumption values
According to regulation 1061/2010, the “COTTONS 
 ” with "ECO  ” option selected and the
“COTTONS 
 ” with "ECO  ” option selected are respectively the “standard 60 °C cotton
programme” and the...

Replace the drawer and run the rinse pro-
gramme without any clothes in the drum.
Cleaning the pump
The pump should be inspected regularly and
particularly if:
• the appliance does not empty and/or spin;
• the appliance makes an unusual noise during
draining due to objects such as safety pins,
coins etc. blocking the pump;
• a problem with water draining is detected
(see chapter “What to do if...” for more de-
tails).
Warning! Before opening the pump door,
switch the appliance off and remove the
mains...

Cleaning the water inlet filters
Important! If the appliance doesn't fill, takes
long to fill with water, the starting button blinks
yellow or the display (if available) shows the
relevant alarm (see chapter "What to do if..." for
more details), check if the water inlet filters are
blocked .
To clean the water inlet filters:
• Turn off the water
tap.
• Unscrew the hose
from the tap.
• Clean the filter in
the hose with a stiff
brush.
• Screw the hose back onto the tap. Make
sure the connection...

Important! Every time you drain the water
through the emergency emptying hose you must
pour 2 litres of water into the main washcompartment of the detergent drawer and then
run the drain programme. This will activate the
ECO Valve device avoiding that part of the
detergent remains unused at next washing.
What to do if ...
Certain problems are due to lack of simple
maintenance or oversights, which can be solved
easily without calling out an engineer. Before
contacting your local Service Centre, please...

ProblemPossible cause/Solution
The machine does not empty
and/or does not spin:
The drain hose is squashed or kinked. 
• Check the drain hose connection.
The drain filter is clogged. 
• Clean the drain filter.
An option or a programme that ends with the water still in the tub or a
that eliminates all the spinning phases has been selected.
• Select the draining or spinning programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
There is water on the floor:
Too much...