Zanussi Zwi 1125 User Manual
Here you can view all the pages of manual Zanussi Zwi 1125 User Manual. The Zanussi manuals for Washing Machine are available online for free. You can easily download all the documents as PDF.
Page 21
SHOWER WASHING MACHINEDISHWASHER BATHSINKTOILET BIDET RAINWATER ‘RUN-OFF’ SURFACE WATER DRAINS & SEWERS UNTREATED DISCHARGE RIVER RIVERTREATED DISCHARGEFOUL DRAIN FOUL SEWERS SEWAGE TREATMENT WORKS Electrical connection Any electrical work required to install this appliance should be carried out by a qualified electrician or compe- tent person. Warning! THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. Before switching on, make sure the...
Page 22
A 600 596 555 170 75176,5 416 100 60818 min. 820min. 560 When installing the appliance into the kitchen furniture ensure, if possible, the hoses are placed in either of the two recesses on the back of the appliance. This will help to prevent the hoses from becoming kinked or trapped. B 1 23 75 6 4 8 Caution! Do not remove the screw 8! Preparation and assembly of the door The machine is originally prearranged for the assembly of a door opening from right to left. In this case it is sufficient to screw in...
Page 23
D 4 6 8 Caution! Do not remove the screw 8! d) Counter-magnet (6) The appliance is prearranged for a magnetic closure of the door. To enable a correct operation of this device, it is neces- sary to screw the counter-magnet (6) (steel disk + rub- ber ring) into the inner side of the door. Its position must correspond to the magnet (4) on the appliance (see picture D). E 1 2 3 75 6 4 8 Caution! Do not remove the screw 8! If the door has to be opened from left to right, invert the position of the plates...
Page 24
Drill four fixing holes see Fig. G Position the base into the recess with its front edge as far forward as the adjoining plinth line will allow. The reason for placing the base in this position is to al- low a small strip of beading to be fitted in front of the appliance feet. Graphic H 600-605 4905 x 25 x 605 Hardwood strip 5 mm x 25 mm Fix the base firmly to the floor using four appropriate countersunk screws (see Fig. H). With the appliance installed adjust all four feet ensuring the machine is...