Zanussi Zrg 616 Cw User Manual

Het milieu
Het symbool    op het product of op de verpakking
wijst erop dat dit product niet als huishoudafval mag
worden behandeld, maar moet worden afgegeven bij
een verzamelpunt waar elektrische en elektronische
apparatuur wordt gerecycled. Als u ervoor zorgt dat dit
product op de juiste manier wordt verwijderd, voorkomtu mogelijke negatieve gevolgen voor mens en milieu
die zich zouden kunnen voordoen in geval van
verkeerde afvalverwerking. Voor gedetailleerdere
informatie over het recyclen van dit...

Contents
Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _  12
Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _  14
First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _   14
Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _  14
Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _  15Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _  15
What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _  16
Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _  18
Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _  18...

squashed or damaged power plug may overheat
and cause a fire.
3. Make sure that you can come to the mains plug
of the appliance.
4. Do not pull the mains cable.
5. If the power plug socket is loose, do not insert
the power plug. There is a risk of electric shock
or fire.
6. You must not operate the appliance without the
lamp cover
5) of interior lighting.
• This appliance is heavy. Care should be taken when
moving it.
• Do not remove nor touch items from the freezer com-
partment if your hands are...

Operation
Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a medium
setting.
Switching off
To turn off the appliance, turn the Temperature regulator
to the O position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings
to obtain the minimum coldness.
• turn the Temperature regulator toward higher set-
tings to obtain the maximum coldness.
A...

Helpful hints and tips
Normal Operating Sounds
• You may hear a faint gurgling and a bubbling sound
when the refrigerant is pumped through the coils or
tubing. This is correct.
• When the compressor is on, the refrigerant is being
pumped around and you will hear a whirring sound
and a pulsating noise from the compressor. This is
correct.
• The thermic dilatation might cause a sudden crack-
ing noise. It is natural, not dangerous physical phe-
nomenon. This is correct.
• When the compressor switches on or...

Defrosting of the refrigerator
Frost is automatically eliminated from the evaporator of
the refrigerator compartment every time the motor com-
pressor stops, during normal use. The defrost water
drains out through a trough into a special container at
the back of the appliance, over the motor compressor,
where it evaporates.
It is important to periodically clean the defrost water
drain hole in the middle of the refrigerator compartment
channel to prevent the water overflowing and dripping
onto the food...

ProblemPossible causeSolution
 The door has been opened too fre-
quently.Do not keep the door open longer than
necessary.
 The product temperature is too high.Let the product temperature decrease
to room temperature before storage.
 The room temperature is too high.Decrease the room temperature.
Water flows on the rear plate of
the refrigerator.During the automatic defrosting proc-
ess, frost defrosts on the rear plate.This is correct.
Water flows into the refrigerator.The water outlet is clogged.Clean...

Technical data
   
Dimension  
 Height850 mm
 Width550 mm
 Depth612 mm
The technical information are situated in the rating plate
on the internal left side of the appliance and in the ener-
gy label.
Installation
Caution!  Read the Safety Information carefully
for your safety and correct operation of the
appliance before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated
indoor (garage or cellar) also, but for optimum perform-
ance install this appliance at a...

Location
The appliance should be installed well away from sour-
ces of heat such as radiators, boilers, direct sunlight
etc. Ensure that air can circulate freely around the back
of the cabinet. To ensure best performance, if the appli-
ance is positioned below an overhanging wall unit, the
minimum distance between the top of the cabinet and
the wall unit must be at least 100 mm . Ideally, howev-
er, the appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured by...

1. Remove the plug from
the power socket.
2. Tilt back the appliance
carefully so that the com-
pressor cannot touch the
floor.
3. Unscrew both adjusta-
ble feet.
4. Unscrew the screws of
the door bottom hinge. Re-
move the hinge. Put over
the pin in the direction of
the arrow.
5. Unscrew and install the
screw on the opposite side.
6. Install the hinge on the
opposite side.
7. Screw both adjustable
feet.8. Unscrew both screws
on the rear side.
9. Push back the top and
lift it from the fixing ele-...