Home > Zanussi > Fridge freezer > Zanussi Zi 9454 Instruction Booklet

Zanussi Zi 9454 Instruction Booklet

Here you can view all the pages of manual Zanussi Zi 9454 Instruction Booklet. The Zanussi manuals for Fridge freezer are available online for free. You can easily download all the documents as PDF.

Page 11

26If this appliance featuring magnetic door seals is
to replace an older appliance having a spring
lock (latch) on the door or lid, be sure to make
that spring lock unusable before you discard the
old appliance. This will prevent it from becoming
a death-trap for a child.LocationThe appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
For buiding into the kitchen units follow the special
“Building-in” instructions given.Electrical connectionBefore...

Page 12

27
Height adjustmentThe height of the appliance is adjustable from 820 to
870 mm  to fine up with existing kitchen units.
Before installing the appliance between unite, adjust
the height of the feet and rear wheels.The wheels
are factory set for a height of 820 mm.To align the
appliance to a height of 870 mm, raise it by adjusting
the feet with a spanner, then remove the wheels and
refit them in the lowest position.Fitting the side panels• Fit the brackets onto the panels in the positions
shown in the...

Page 13

28Fitting the door panels•  Perforate the doors as in the drawing and insert
the two screws in the bag (do not tighten them all
the way down) for doors.
• Before installing the doors, carefully level the
appliance.
•  Open one of the two lower doors and insert the
screws that had previously been positioned inside
the slot on the hinge and on the adjustment plate.
Move the door until it is perfectly in position.
•  Repeat the operations for the other doors
•  Shut the door again and check that it is...

Page 14

29
• Check horizontal alignment of the doors and, if
necessary, correct their position by moving them
along the slots.
• Open the door.
Adjust the planarity of the doors by means of the
adjustment bushings and the lower square.
• Once the doors are perfectly and completely
aligned, fix a clamp screw inside the bushings
(upper and lower hinge) on the lower bracket.The
screws must be tighten completely inside the
slots.
40Panneau de contrôle du
réfrigérateur
 



J.Témoin ALLUMÉ/ÉTEINT
K.Touche...

Page 15

30Building the appliance in• Fit the appliance into the recess.
• Rotate the bracket of 180° in order to obtain the
right position ( 2).
The position (1) is on the delivery.
• Fix it to the wali with the appropriate bracket.
• The top of the appliance must be kept ciear to
allow better air circulation.If a wall unit is fitted
above the appliance, there must be a gap of 50
mm between this unit and the wall and it must be
at least 50 mm below the ceiling.Fitting the plinthAlignment height of 820 mm• If...

Page 16

31
• If using a 100 mm plinth, fit the complete height
compensation strip.Alignment height of 870 mm• If using a 190 to 220 mm plinth, make a shown.
• If using a plinth higher than 150 mm but less than
190 mm, cut the height compensation strip
supplied with the appliance to the required depth
and fit it between the plinth and the ventilation
grille.
• If using a 150 mm plinth, fit the complete height
compensation strip.
• If the appliance is installed at the end of a row of
units, insert foot E to hold...

Page 17

32
DECLARA
TION OF GU
ARANTEE 
TERMS
Our appliances are produced with the greatest of care.However, a defect may still occur.Our consumer
services department will repair this upon request, either during or after the guarantee period.The service life of
the appliance will not, however, be reduced as a result.
This declaration of guarantee terms is based on European Union Directive 99/44/EC and the provisions of the
CE Civil Code.The statutory rights that the consumer has under this legislation are not...

Page 18

33
These guarantee terms are only valid for appliances purchased and used in Belgium.For exported appliances,
the user must first make sure that they satisfy the technical conditions (e.g.: voltage, frequency, installation
instructions, type of gas, etc.) for the country concerned, and that they can withstand the local climatic and
environmental conditions.For appliances purchased abroad, the user must first ensure that they meet the
qualifications required in Belgium.Non-essential or requested...

Page 19

34
AVERTISSEMENTS ET CONSEILS IMPORTANTS
Il est très important que cette notice d’utilisation soit gardée avec l’appareil pour toute future
consultation. Si cet appareil devait être vendu ou transféré à une autre personne, assurez-vous que la
notice d’utilisation suive l’appareil, de façon à ce que le nouvel utilisateur puisse être informé du
fonctionnement de celui-ci et des avertissements relatifs.
Si cet appareil, muni de fermeture magnétique, doit être employé pour en remplacer un autre avec une...
Start reading Zanussi Zi 9454 Instruction Booklet

Related Manuals for Zanussi Zi 9454 Instruction Booklet

All Zanussi manuals