Home > Zanussi > Dishwasher > Zanussi Zdt 110 User Manual

Zanussi Zdt 110 User Manual

Here you can view all the pages of manual Zanussi Zdt 110 User Manual. The Zanussi manuals for Dishwasher are available online for free. You can easily download all the documents as PDF.

Page 11

11
Filling with dishwasher salt
Only before filling with
salt for the first time,
fill the salt container
with waterUsing the funnel
provided, pour in the
salt until the container is
filled with salt.
Remove any trace of
salt.Replace the cap tightly
turning it clockwise until
it stops with a click.
CAUTION!
Use only special salt suitable for dishwashers
IMPORTANT!
Immediately start a complete programme.
IMPORTANT!
Water will overflow from the container as salt is
added.
IMPORTANT!
The salt container will...

Page 12

Filling with rinse aid
12
Open the lid.Fill up with rinse aid.
The maximum level for
filling is indicated by
max.Clean up any rinse aid
which overflows. Close
the lid and press until it
locks.
CAUTION!
Never fill the rinse aid dispenser with any other
substances (e.g. dishwasher cleaning agent, liquid
detergent). This would damage the appliance.
Adjusting the dosage of rinse aid
Increase the dose if there are drops of water or
lime spots on the dishes after washing.Reduce the dose if there are whitish...

Page 13

13
Loading cutlery and dishes
●The following items are not suitable for use 
in the dishwasher:
- Cutlery with wooden, horn, china or 
mother-of-pearl handles
- Plastic items that are not heat resistant
- Older cutlery with glued parts that are not 
temperature resistant
- Bonded cutlery items or dishes
- Pewter or copper items
- Lead crystal glass
- Steel items prone to rusting
- Wooden platters
- Items made from synthetic fibres ●When loading the dishwasher, make sure
that you:
- Remove all left over...

Page 14

14
Load upper basket.
Light items (plastic
bowls etc.) must be
loaded in the upper
basket and arranged so
they do not move. For taller items, the cup
racks can be folded
upwards.If plates are to be loaded in the upper
basket:
load them starting from the rear positions;
tilting them slightly forwards and avoiding the
front positions near the door.
Adjusting the height of the upper basket 
If washing very large plates you can load them in the lower basket after moving the upper basket
to the higher...

Page 15

15
Filling with detergent
IMPORTANT!
Only use detergents suitable for dishwashers.
Observe the manufacturer’s dosing and storage recommendations.
Open the lid.
For programmes with
prewash add an
additional detergent
dose in compartment B.When using detergent
tablets:
place detergent tablets
in compartment A.Close the lid.
Fill in the detergent in
compartment A.Observe the dosing
levels.
Unloading the dishwasher
●Empty the lower basket first and then the
upper one; this will avoid water dripping from
the...

Page 16

16
Cleaning and Care
IMPORTANT!
NEVER use the dishwasher without filters.
Incorrect repositioning and fitting of the filters will produce poor washing results.
Cleaning the filters
IMPORTANT!
NEVER try to remove the spray arms.
If residues of soil have clogged the holes in the
upper spray arm, remove them with a
toothpick.
Clean filters A, Band C
thoroughly under
running water.Turn the handle about1/4turn anticlockwise
and remove filters B
and C.
Remove filter Afrom the
base of the washing
compartment....

Page 17

17
Environmental concerns
External cleaning
Clean the external surfaces of the machine and
control panel with a damp soft cloth. If
necessary use only neutral detergents. Never
use abrasive products, scouring pads or
solvent (acetone, trichloroethylene etc....). 
Ensure that the seals around the door, the
detergent and rinse aid dispensers are cleaned
regularly with a damp cloth.
We recommend every 3 months to run a 65°C
wash programme without dishes using
detergent.
Prolonged periods of non-operation...

Page 18

18
Fault code / malfunction Possible cause  Solution
Something not working
The dishwasher does not fill with
water.
- 1 intermittent audible signal
- 1 flash of the end of cycle
indicator light
The dishwasher will not drain.
- 2 intermittent audible signals
- 2 flashes of the end of cycle
indicator light
The water tap is blocked or furred  Clean the water tap.
with limescale.
The water tap is turned off. Turn the water tap on.
The filter (where present) in the . Clean the filter in the.
threaded hose...

Page 19

19
The wash results are not satisfactory
The dishes are not clean●The wrong washing programme has been selected.
●The dishes were arranged in such a way as to stop water reaching all parts 
of the surface. The baskets must not be overloaded.
●The spray arm do not rotate freely due to incorrect arrangement of the load.
●The filters in the base of the washing compartment are dirty or incorrectly 
positioned.
●Too little or no detergent has been used.
●Where there are limescale deposits on the dishes; the...

Page 20

Technical data
20
Consumption values
Dimensions Width 59.6 cm
Height  81.8 - 87.8 cm
Depth. 55.5 cm
Water supply pressure Minimum 0,05 MPa (0.5 bar)
Maximum 0,8 MPa (8 bar)
Electrical connection Information on the electrical connection is given on the rating plate on
Voltage - Overall power - Fuse the inner edge of the dishwasher’s door.
Capacity 12 place settings
Noise level 51 dB (A)
Max. weight37
The consumption values are intended as a
guide and depends on the pressure and the
temperature of the...
Start reading Zanussi Zdt 110 User Manual

Related Manuals for Zanussi Zdt 110 User Manual

All Zanussi manuals