Zanussi Wjs1265w Manual

21
The dangers of freezing
If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.

Turn off the water tap.

Unscrew the inlet hose.

Unhook the drain hose from the rear support and
position the end of this hose and that of the inlet
hoses in a bowl. Run the draining programme.
To do this:

Switch the machine on

Select a washing programme

Press the SKIP/RESET button three times

Press START/PAUSE button 

Disconnect the appliance.

Screw the inlet hose and reposition...

22
Something Not Working
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without
calling out an engineer. Before contacting your local Service Force Centre, please carry out the checks listed
below.
IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or
installation, a charge will be made even if the appliance is under guarantee.
During machine operation it is possible that one of the following alarm...

23
Symptom
The door will not open
Possible causes

The water level is above the bottom edge of the door.

The machine is heating the water or drying the clothes.

The drum is turning.
The door can only be opened when the relevant light has gone out.
Spinning starts late or the machine
does not spin
The electronic unbalance detection device has cut in because the
laundry is not  evenly distributed  in the drum. The laundry is
redistributed by reverse rotation of the drum. This may happen several
times...

24
Guarantee Conditions
Standard guarantee conditions
We, Zanussi undertake that if, within 12 months of the
date of the purchase, this Zanussi appliance or any part
thereof is proved to be defective by reason only of
faulty workmanship or materials, we will, at our option,
repair or replace the same FREE OF ANY CHARGE
for labour, materials or carriage on condition that:

The appliance has been correctly installed and used
only on the electricity supply stated on the rating
plate.

The appliance has been...

25
To contact your local Service Force Centre telephone 08705 929 929
CHANNEL ISLANDS
GUERNSEYGuernsey Electricity
PO Box 4
Vale, Guernsey
Channel Islands GY1 3AD
JERSEYJersey Electricity Company
Haut De L’orme
Rue De Haut De L’orme
Trinity
Jersey
Channel Islands JE3 5FG
SCOTLAND
ABERDEEN54 Claremont Street
Aberdeen AB10 6RA
AUCHTERMUCHTY33a Burnside
Auchtermuchty
Fife KY14 7AJ
BLANTYREUnit 5
Block 2
Auchenraith Ind. Estate
Rosendale Way
Blantyre G72 0NJ
DUMFRIES93 Irish Street
Dumfries
DG1 2 PQ
DUNOON7...

26
To contact your local Service Force Centre telephone 08705 929 929
MIDLANDS
BIRMINGHAM66 Birch Road East
Wyrley Trading Estate
Witton
Birmingham
B6 7DB
BOURNEPinfold Road
Bourne
PE10 9HT
BRIDGNORTH68 St. Mary’s Street
Bridgnorth
Shropshire
WV16 4DR
GLOUCESTER101 Rycroft Street
Gloucester
GL1 4NB
HEREFORDUnits 3 & 4
Bank Buildings
Cattle market
Hareford
HE4 9HX
HIGHAM FERRERS30 High Street
Higham Ferrers
Northants
NN10 8PL
ILKESTONUnit 2
Furnace Road
Ilkeston DE7 5EP
LEICESTERUnit 7
Oaks Industrial...

27
DIMENSIONS Height  85 cmWidth 60 cm
Depth 58 cm
POWER SUPPLY VOLTAGE  230-240 V/50 Hz
TOTAL POWER ABSORBED  2050 W (10A) Minimum 50 kPa
WATER PRESSURE  Maximum 800 kPaWashing
LOAD CAPACITY Cotton, linen  5 kg (max 6 kg) Synthetics 2.5 kg
Delicate fabrics  2.5 kg
Wool and Hand Wash 2 kg
Drying
Cotton, linen  2.5 kg
Synthetics 2 kg
SPIN SPEED  Maximum  1200 rpm (WJS 1265 W) 1400 rpm (WJS 1465 W)
1600 rpm (WJS 1665 W)
WJS 1265 W WJS 1465 W WJS 1665 W
CONSUMPTION DATA FOR WASHING Energy 0.95 kWh 0.95 kWh...

28
Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all the packaging for re-use in
case the machine is to be transported again.
Using a spanner unscrew and remove the rear right bolt.
Lay the machine gently on its back, making sure that the
hoses are not squashed.
Remove the polystyrene block from the bottom of the
machine and release the two plastic bags.
Carefully slide out the right polythene bag (1).
Repeat the operation for the left...

29 If you cannot make the cold water connection direct
from the rising mains, you may be able to operate the
appliance from your cold water storage system.
There should be a minimum distance of 5.02m 
(161/2 ft) between the appliance’s inlet and the bottom
of the water storage tank.
Set the hose correctly by loosening the ring nut. After
positioning the inlet hose, be sure to tighten the ring nut
again to prevent leaks.
Water drainage
This appliance is designed to be permanently plumbed
into your homes...

30
Levelling
Level the washing machine by raising or lowering the
feet. The feet may be tight to adjust as they incorporate
a self locking nut, but the machine MUST be level and
stable (check diagonally).
Any necessary adjustment can be made with a spanner.
Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Some vibration is inevitable, especially if mounted on a
wooden floor.
Sprung wooden floors are particularly susceptible to
vibration. For advice, consult a...